Silicone Elastomer Composites Fabricated with MgO and MgO-Multi-Wall Carbon Nanotubes with Improved Thermal Conductivity

The effect of multiwall carbon nanotubes (MWCNTs) and magnesium oxide (MgO) on the thermal conductivity of MWCNTs and MgO-reinforced silicone rubber was studied. The increment of thermal conductivity was found to be linear with respect to increased loading of MgO. In order to improve the thermal transportation of phonons 0.3 wt % and 0.5 wt % of MWCNTs were added as filler to MgO-reinforced silicone rubber. The MWCNTs were functionalized by hydrogen peroxide (H2O2) to activate organic groups onto the surface of MWCNTs. These functional groups improved the compatibility and adhesion and act as bridging agents between MWCNTs and silicone elastomer, resulting in the formation of active conductive pathways between MgO and MWCNTs in the silicone elastomer. The surface functionalization was confirmed with XRD and FTIR spectroscopy. Raman spectroscopy confirms the pristine structure of MWCNTs after oxidation with H2O2. The thermal conductivity is improved to 1 W/m·K with the addition of 20 vol % with 0.5 wt % of MWCNTs, which is an ~8-fold increment in comparison to neat elastomer. Improved thermal conductive properties of MgO-MWCNTs elastomer composite will be a potential replacement for conventional thermal interface materials.

Highly Sensitive Flexible Pressure Sensors Enabled by Mixing of Silicone Elastomer With Ionic Liquid-Grafted Silicone Oil

Developing highly sensitive flexible pressure sensors has become crucially urgent due to the increased societal demand for wearable electronic devices capable of monitoring various human motions. The sensitivity of such sensors has been shown to be significantly enhanced by increasing the relative dielectric permittivity of the dielectric layers used in device construction via compositing with immiscible ionic conductors. Unfortunately, however, the elastomers employed for this purpose possess inhomogeneous morphologies, and thus suffer from poor long-term durability and unstable electrical response. In this study, we developed a novel, flexible, and highly sensitive pressure sensor using an elastomeric dielectric layer with particularly high permittivity and homogeneity due to the addition of synthesized ionic liquid-grafted silicone oil (denoted LMS-EIL). LMS-EIL possesses both a very high relative dielectric permittivity (9.6 × 105 at 10−1 Hz) and excellent compatibility with silicone elastomers due to the covalently connected structure of conductive ionic liquid (IL) and chloropropyl silicone oil. A silicone elastomer with a relative permittivity of 22 at 10−1 Hz, Young’s modulus of 0.78 MPa, and excellent homogeneity was prepared by incorporating 10 phr (parts per hundreds rubber) of LMS-EIL into an elastomer matrix. The sensitivity of the pressure sensor produced using this optimized silicone elastomer was 0.51 kPa−1, which is 100 times higher than that of the pristine elastomer. In addition, a high durability illustrated by 100 loading–unloading cycles and a rapid response and recovery time of approximately 60 ms were achieved. The excellent performance of this novel pressure sensor suggests significant potential for use in human interfaces, soft robotics, and electronic skin applications.