scholarly journals Impact of radiatively interactive dust aerosols in the NASA GEOS‐5 climate model: Sensitivity to dust particle shape and refractive index

2014 ◽  
Vol 119 (2) ◽  
pp. 753-786 ◽  
Author(s):  
Peter R. Colarco ◽  
Edward P. Nowottnick ◽  
Cynthia A. Randles ◽  
Bingqi Yi ◽  
Ping Yang ◽  
...  
2017 ◽  
Author(s):  
Hui Sun ◽  
Xiaodong Liu ◽  
Zaitao Pan

Abstract. While dust aerosols emitted from major Asian sources such as Taklimakan and Gobi Deserts have been shown to have strong effect on Asian monsoon and climate, the role of dust emitted from Tibetan Plateau (TP) itself, where aerosols can directly interact with the TP heat pump because of their physical proximity both in location and elevation, has not been examined. This study uses the dust coupled RegCM4.1 regional climate model to simulate the spatiotemporal distribution of dust aerosols originating in the TP and their radiative effects on the East Asian summer monsoon (EASM) during both heavy and light dust years. Two 20-year simulations with and without the dust emission from TP showed that direct radiative cooling in the mid-troposphere induced by the TP locally produced dust aerosols resulted in an overall anticyclonic circulation anomaly in the low-troposphere centered over the TP region. The northeasterly anomaly in the EASM region reduces its strength considerably. The simulations found a significant negative correlation between the TP column dust load produced by local emissions and the corresponding anomaly in the EASM index (R=−0.41). The locally generated TP dust can cause surface cooling far downstream in eastern Mongolia and northeastern China through stationery Rossby wave propagation. Although contribution to the total Asian dust source from within TP (mainly Qaidam Basin) is relatively small, its impacts on Asian monsoon and climate seems disproportionately large, likely owning to its higher elevation within TP itself.


2010 ◽  
Vol 23 (15) ◽  
pp. 4121-4132 ◽  
Author(s):  
Dorian S. Abbot ◽  
Itay Halevy

Abstract Most previous global climate model simulations could only produce the termination of Snowball Earth episodes at CO2 partial pressures of several tenths of a bar, which is roughly an order of magnitude higher than recent estimates of CO2 levels during and shortly after Snowball events. These simulations have neglected the impact of dust aerosols on radiative transfer, which is an assumption of potentially grave importance. In this paper it is argued, using the Dust Entrainment and Deposition (DEAD) box model driven by GCM results, that atmospheric dust aerosol concentrations may have been one to two orders of magnitude higher during a Snowball Earth event than today. It is furthermore asserted on the basis of calculations using NCAR’s Single Column Atmospheric Model (SCAM)—a radiative–convective model with sophisticated aerosol, cloud, and radiative parameterizations—that when the surface albedo is high, such increases in dust aerosol loading can produce several times more surface warming than an increase in the partial pressure of CO2 from 10−4 to 10−1 bar. Therefore the conclusion is reached that including dust aerosols in simulations may reconcile the CO2 levels required for Snowball termination in climate models with observations.


2018 ◽  
Vol 18 (13) ◽  
pp. 9681-9703 ◽  
Author(s):  
Jamie R. Banks ◽  
Kerstin Schepanski ◽  
Bernd Heinold ◽  
Anja Hünerbein ◽  
Helen E. Brindley

Abstract. Satellite imagery of atmospheric mineral dust is sensitive to the optical properties of the dust, governed by the mineral refractive indices, particle size, and particle shape. In infrared channels the imagery is also sensitive to the dust layer height and to the surface and atmospheric environment. Simulations of mineral dust in infrared Desert Dust imagery from the Spinning Enhanced Visible and InfraRed Imager (SEVIRI) have been performed, using the COSMO-MUSCAT (COSMO: COnsortium for Small-scale MOdelling; MUSCAT: MUltiScale Chemistry Aerosol Transport Model) dust transport model and the Radiative Transfer for TOVS (RTTOV) program, in order to investigate the sensitivity of the imagery to assumed dust properties. This paper introduces the technique and performs initial validation and comparisons with SEVIRI measurements over North Africa for daytime hours during 6 months covering June and July of 2011–2013. Using T-matrix scattering theory and assuming the dust particles to be spherical or spheroidal, wavelength- and size-dependent dust extinction values are calculated for a number of different dust refractive index databases, along with several values of the particle aspect ratio, denoting the particle shape. The consequences for the infrared extinction values of both the particle shape and the particle orientation are explored: this analysis shows that as the particle asphericity increases, the extinctions increase if the particles are aligned horizontally, and decrease if they are aligned vertically. Randomly oriented spheroidal particles have very similar infrared extinction properties as spherical particles, whereas the horizontally and vertically aligned particles can be considered to be the upper and lower bounds on the extinction values. Inputting these values into COSMO-MUSCAT-RTTOV, it is found that spherical particles do not appear to be sufficient to describe fully the resultant colour of the dust in the infrared imagery. Comparisons of SEVIRI and simulation colours indicate that of the dust types tested, the dust refractive index dataset produced by Volz (1973) shows the most similarity in the colour response to dust in the SEVIRI imagery, although the simulations have a smaller range of colour than do the observations. It is also found that the thermal imagery is most sensitive to intermediately sized particles (radii between 0.9 and 2.6 µm): larger particles are present in too small a concentration in the simulations, as well as with insufficient contrast in extinction between wavelength channels, to have much ability to perturb the resultant colour in the SEVIRI dust imagery.


2011 ◽  
Vol 42 (10) ◽  
pp. 631-644 ◽  
Author(s):  
Bingqi Yi ◽  
Christine N. Hsu ◽  
Ping Yang ◽  
Si-Chee Tsay

2008 ◽  
Vol 8 (2) ◽  
pp. 4625-4667 ◽  
Author(s):  
D. F. Zhang ◽  
A. S. Zakey ◽  
X. J. Gao ◽  
F. Giorgi

Abstract. The ICTP regional climate model (RegCM3) coupled with a desert dust model is used to simulate the radiative forcing and related climate effects of dust aerosols over East Asia. Two sets of experiments encompassing the main dust producing months, February to May, for 10 years (1997–2006) are conducted and inter-compared, one without (Exp. 1) and one with (Exp. 2) the radiative effects of dust aerosols. The simulation results are evaluated against ground station and satellite data. The model captures the basic observed climatology over the area of interest. The spatial and temporal variations of near surface concentration, mass load, and emission of dust aerosols from the main source regions are reproduced by model, with the main model deficiency being an overestimate of dust amount over the source regions and underestimate downwind of these source areas. Both the top-of-the-atmosphere (TOA) and surface radiative fluxes are decreased by dust and this causes a surface cooling locally up to −1°C. The inclusion of dust radiative forcing leads to a reduction of dust emission in the East Asia source regions, which is mainly caused by an increase in local stability and a corresponding decrease in dust lifting. Our results indicate that dust effects should be included in the assessment of climate change over East Asia.


Sign in / Sign up

Export Citation Format

Share Document