Nonlinear backstepping control for PMSG wind turbine used on the real wind profile of the Dakhla‐Morocco city

Author(s):  
Youness El Mourabit ◽  
Aziz Derouich ◽  
Abdelaziz El Ghzizal ◽  
Najib El Ouanjli ◽  
Othmane Zamzoum
Energies ◽  
2021 ◽  
Vol 14 (8) ◽  
pp. 2184
Author(s):  
Andrea Mannelli ◽  
Francesco Papi ◽  
George Pechlivanoglou ◽  
Giovanni Ferrara ◽  
Alessandro Bianchini

Energy Storage Systems (EES) are key to further increase the penetration in energy grids of intermittent renewable energy sources, such as wind, by smoothing out power fluctuations. In order this to be economically feasible; however, the ESS need to be sized correctly and managed efficiently. In the study, the use of discrete wavelet transform (Daubechies Db4) to decompose the power output of utility-scale wind turbines into high and low-frequency components, with the objective of smoothing wind turbine power output, is discussed and applied to four-year Supervisory Control And Data Acquisition (SCADA) real data from multi-MW, on-shore wind turbines provided by the industrial partner. Two main research requests were tackled: first, the effectiveness of the discrete wavelet transform for the correct sizing and management of the battery (Li-Ion type) storage was assessed in comparison to more traditional approaches such as a simple moving average and a direct use of the battery in response to excessive power fluctuations. The performance of different storage designs was compared, in terms of abatement of ramp rate violations, depending on the power smoothing technique applied. Results show that the wavelet transform leads to a more efficient battery use, characterized by lower variation of the averaged state-of-charge, and in turn to the need for a lower battery capacity, which can be translated into a cost reduction (up to −28%). The second research objective was to prove that the wavelet-based power smoothing technique has superior performance for the real-time control of a wind park. To this end, a simple procedure is proposed to generate a suitable moving window centered on the actual sample in which the wavelet transform can be applied. The power-smoothing performance of the method was tested on the same time series data, showing again that the discrete wavelet transform represents a superior solution in comparison to conventional approaches.


2002 ◽  
Vol 35 (1) ◽  
pp. 113-118 ◽  
Author(s):  
Eugenio Schuster ◽  
Miroslav Krstić ◽  
George Tynan

2018 ◽  
Vol 3 (3) ◽  
pp. 133-142
Author(s):  
Abderrahmen KIRAD ◽  
Said Grouni ◽  
Omar MECHALI

This paper presents a nonlinear backstepping control strategy used to ensure good dynamic behavior, high performance and the stability of the permanent magnet synchronous motor (PMSM). However, this control requires the precise knowledge of certain variables (speed, torque and position) that are difficult to access or sensors require additional mounting space, reduce reliability, increase the cost of the engine, and make maintenance difficult. Thus, an Extended Kalman Filter (EKF) approach is proposed for the estimation of speed and rotor position in the PMSM. The interesting simulation results obtained which are subjected to the load perturbation show very well the efficiency and the good performance of the nonlinear feedback control proposed and simulated in Matlab-Simulink.


Energies ◽  
2019 ◽  
Vol 12 (15) ◽  
pp. 2949 ◽  
Author(s):  
Lee ◽  
Kim ◽  
Kang ◽  
Kim

Although the size of the wind turbine has become larger to improve the economic feasibility of wind power generation, whether increases in rotor diameter and hub height always lead to the optimization of energy cost remains to be seen. This paper proposes an algorithm that calculates the optimized hub height to minimize the cost of energy (COE) using the regional wind profile database. The optimized hub height was determined by identifying the minimum COE after calculating the annual energy production (AEP) and cost increase, according to hub height increase, by using the wind profiles of the wind resource map in South Korea and drawing the COE curve. The optimized hub altitude was calculated as 75~80 m in the inland plain but as 60~70 m in onshore or mountain sites, where the wind profile at the lower layer from the hub height showed relatively strong wind speed than that in inland plain. The AEP loss due to the decrease in hub height was compensated for by increasing the rotor diameter, in which case COE also decreased in the entire region of South Korea. The proposed algorithm of identifying the optimized hub height is expected to serve as a good guideline when determining the hub height according to different geographic regions.


2013 ◽  
Vol 644 ◽  
pp. 312-316
Author(s):  
Chang Zheng Chen ◽  
Ping Ping Pan ◽  
Qiang Meng ◽  
Yan Ling Gu

The presence of irregularity in periodical vibration signals usually indicates the occurrence of wind turbine gearbox faults. Unfortunately, detecting the incipient faults is a difficult job because they are rather weak and often interfered by heavy noise and higher level macro-structural vibrations. Therefore, a proper signal processing method is necessary. We used the wavelet-based multifractal method to extract the impulsive features buried in noisy vibration signals. We first calculated the wavelet transform modulo maxima lines from the real vibration signals, then, obtained the singularity spectrum from the lines. The analysis results of the real signals showed that the proposed method can effectively extract weak fault features.


Sign in / Sign up

Export Citation Format

Share Document