Nickel, nickel-chromium alloys, nickel-chromium-iron alloys, nickel-copper alloys

2018 ◽  
pp. 1-1
Author(s):  
C.M. Teng ◽  
T.F. Kelly ◽  
J.P. Zhang ◽  
H.M. Lin ◽  
Y.W. Kim

Spherical submicron particles of materials produced by electrohydrodynamic (EHD) atomization have been used to study a variety of materials processes including nucleation of alternative crystallization phases in iron-nickel and nickel-chromium alloys, amorphous solidification in submicron droplets of pure metals, and quasi-crystal formation in nickel-chromium alloys. Some experiments on pure nickel, nickel oxide single crystals, the nickel/nickel(II) oxide interface, and grain boundaries in nickel monoxide have been performed by STEM. For these latter studies, HREM is the most direct approach to obtain particle crystal structures at the atomic level. Grain boundaries in nickel oxide have also been investigated by HREM. In this paper, we present preliminary results of HREM observations of NiO growth on submicron spheres of pure nickel.Small particles of pure nickel were prepared by EHD atomization. For the study of pure nickel, 0.5 mm diameter pure nickel wire (99.9975%) is sprayed directly in the EHD process. The liquid droplets solidify in free-flight through a vacuum chamber operated at about 10-7 torr.


Alloy Digest ◽  
1999 ◽  
Vol 48 (3) ◽  

Abstract AMETEK 820 alloy is a powder metallurgically produced strip that is used in hardfacing weld wire. The production process, however, can produce other special strip compositions such as the nickel-chromium alloys used as resistance alloys. This datasheet provides information on composition, physical properties, hardness, and tensile properties. It also includes information on powder metal forms. Filing Code: Ni-549. Producer or source: AMETEK Specialty Metal Products.


1953 ◽  
Vol 49 (1) ◽  
pp. 115-129 ◽  
Author(s):  
A. B. Lidiard

ABSTRACTThe theory of collective electron ferromagnetism given by Stoner applies to a system of electrons in a single energy band; for iron, cobalt and nickel this is identified with the band of states derived from atomic 3d functions. To bring in the generally assumed overlapping of the 3d band by the wide 4s band in these metals, the theory has been extended to take account of the transfer of electrons from 3d to 4s states with change of temperature. A previous calculation of this transfer effect must be regarded as inadequate, for the part played by the exchange energy in determining the distribution of electrons between the two sets of states was omitted. The general equations are derived in § 2 and used as a basis for discussion of the properties of nickel-copper alloys at absolute zero in § 3. In §§4 and 5 numerical results are presented which show the effect of the overlapping 4s band on the magnetic properties of a system such as nickel both above and below its Curie point. Comparison with the measured paramagnetic susceptibility of pure nickel above the Curie point strongly suggests that for this metal the overlapping 4s band has only a minor influence, although in principle the effect could be very large (cf. Fig. 4). This result is not unambiguous, however, because values thus inferred for the two unknown parameters lead to inaccurate predictions below the Curie point. First, the predicted values for the spontaneous magnetization are too small. Secondly, the theory demands that the nickel-copper alloys should only be ferromagnetic below a copper content of about 20 %, whereas experimentally the limit is known to be about 60 %. In conclusion, it is suggested that the implicit assumption of Stoner's theory that the exchange integrals between all pairs of 3d states are equal to one another is a more serious restriction on the theory than the consideration of only a single energy band.


1953 ◽  
Vol 45 (8) ◽  
pp. 1734-1744 ◽  
Author(s):  
Earl A. Gulbransen ◽  
William R. McMillan

Sign in / Sign up

Export Citation Format

Share Document