The Influence of Cell Shape Anisotropy on the Tensile Behavior of Open Cell Aluminum Foam

2008 ◽  
Vol 10 (9) ◽  
pp. 877-881 ◽  
Author(s):  
E. Amsterdam ◽  
H. van Hoorn ◽  
J. Th. M. De Hosson ◽  
P. R. Onck
2010 ◽  
Vol 44-47 ◽  
pp. 3105-3108
Author(s):  
Long Zhi Zhao ◽  
Xiao Lan Zhang ◽  
Na Li ◽  
Ming Juan Zhao ◽  
Jian Zhang

Aluminum foam with unique reticular structure is used as a sound shield in the railway engineering because of its superior sound absorption. The strength of the aluminum foam plays important role on the life of the shield,so the tensile behavior of the open cell aluminum foam was investigated with the finite element method based on ANSYS software in this paper. The effects of the porosity and the aperture size of the aluminum foam on the tensile behavior are obtained. The results show that the material mechanical properties exhibit a significant decrease as the porosity increases, effects of the aperture size on the mechanical properties of aluminum foam is not obvious.


Author(s):  
Nihad Dukhan ◽  
Angel Alvarez

Wind-tunnel pressure drop measurements for airflow through two samples of forty-pore-per-inch commercially available open-cell aluminum foam were undertaken. Each sample’s cross-sectional area perpendicular to the flow direction measured 10.16 cm by 24.13 cm. The thickness in the flow direction was 10.16 cm for one sample and 5.08 cm for the other. The flow rate ranged from 0.016 to 0.101 m3/s for the thick sample and from 0.025 to 0.134 m3/s for the other. The data were all in the fully turbulent regime. The pressure drop for both samples increased with increasing flow rate and followed a quadratic behavior. The permeability and the inertia coefficient showed some scatter with average values of 4.6 × 10−8 m2 and 2.9 × 10−8 m2, and 0.086 and 0.066 for the thick and the thin samples, respectively. The friction factor decayed with the Reynolds number and was weakly dependent on the Reynolds number for Reynolds number greater than 35.


2014 ◽  
Vol 4 ◽  
pp. 359-364 ◽  
Author(s):  
Sven De Schampheleire ◽  
Peter De Jaeger ◽  
Kathleen De Kerpel ◽  
Bernd Ameel ◽  
Henk Huisseune ◽  
...  

2014 ◽  
Vol 35 (11) ◽  
pp. 1437-1446 ◽  
Author(s):  
Zi-xing Lu ◽  
Qiang Liu ◽  
Xin Chen
Keyword(s):  

Author(s):  
Paiboon Wattanapornphan ◽  
Chakkrist Phongphisutthinan ◽  
Tetsuo Suga ◽  
Masami Mizutani ◽  
Seiji Katayama

2019 ◽  
Vol 30 (19) ◽  
pp. 2458-2468 ◽  
Author(s):  
Jingchen Li ◽  
Longcan Cheng ◽  
Hongyuan Jiang

Cell division orientation plays an essential role in tissue morphogenesis and cell fate decision. Recent studies showed that either cell shape or adhesion geometry can regulate the orientation of mitotic spindles and thereby the cell division orientation. However, how they together regulate the spindle orientation remains largely unclear. In this work, we use a general computational model to investigate the competitive mechanism of determining the spindle orientation between cell shape and intercellular adhesion in epithelial cells. We find the spindle orientation is dominated by the intercellular adhesion when the cell shape anisotropy is small, but dominated by the cell shape when the shape anisotropy is large. A strong adhesion and moderate adhesive size can ensure the planar division of epithelial cells with large apico-basal elongation. We also find the spindle orientation could be perpendicular to the adhesive region when only one side of the cell is adhered to an E-cadherin–coated matrix. But after the cell is compressed, the spindle orientation is governed by the cell shape and the spindle will be parallel to the adhesive region when the cell shape anisotropy is large. Finally, we demonstrate the competition between cell shape and tricellular junctions can also effectively regulate the spindle orientation.


2005 ◽  
Vol 36 (3) ◽  
pp. 645-650 ◽  
Author(s):  
Fusheng Han ◽  
Hefa Cheng ◽  
Qiang Wang ◽  
Zhibin Li

2018 ◽  
Vol 715 ◽  
pp. 281-294 ◽  
Author(s):  
Vasanth Chakravarthy Shunmugasamy ◽  
Bilal Mansoor

Sign in / Sign up

Export Citation Format

Share Document