Fluorescent polyacrylamide nanospheres for concentration detection and fluorescent visual oil displacement experiments

2021 ◽  
pp. 51898
Author(s):  
Yipeng Chen ◽  
Zhongli Tang ◽  
Shuo Wang ◽  
Yuxing Liu ◽  
Jin Qu ◽  
...  
Energies ◽  
2019 ◽  
Vol 12 (4) ◽  
pp. 664 ◽  
Author(s):  
Jorge Avendaño ◽  
Nicolle Lima ◽  
Antonio Quevedo ◽  
Marcio Carvalho

Wettability has a dramatic impact on fluid displacement in porous media. The pore level physics of one liquid being displaced by another is a strong function of the wetting characteristics of the channel walls. However, the quantification of the effect is still not clear. Conflicting data have shown that in some oil displacement experiments in rocks, the volume of trapped oil falls as the porous media becomes less water-wet, while in some microfluidic experiments the volume of residual oil is higher in oil-wet media. The reasons for this discrepancy are not fully understood. In this study, we analyzed oil displacement by water injection in two microfluidic porous media with different wettability characteristics that had capillaries with constrictions. The resulting oil ganglia size distribution at the end of water injection was quantified by image processing. The results show that in the oil-wet porous media, the displacement front was more uniform and the final volume of remaining oil was smaller, with a much smaller number of large oil ganglia and a larger number of small oil ganglia, when compared to the water-wet media.


2013 ◽  
Vol 734-737 ◽  
pp. 1290-1293 ◽  
Author(s):  
Ji Hong Zhang ◽  
Yu Wang ◽  
Xi Ling Chen ◽  
Zi Wei Qu ◽  
Dong Ke Qin

Aiming at the development of remaining oil after polymer flooding, the author develops an oil displacement technology, alternately injecting the slug of the gel and polymer/surfactant compound system, which can advanced improve the remained oil after polymer flooding. By using the artificial large flat-panel model, the oil displacement experiments are carried on to study the injection characteristics and the displacement efficiency of the alternately injecting the slug of gel and polymer/surfactant compound system, and whether the following water should be injected after polymer flooding has been discussed. The experimental results show that, the recovery of alternately injecting the gel and polymer/surfactant slug after polymer flooding could enhance recovery more than 10% on the basis of polymer flooding, the following water after polymer flooding has a little impact on the final recovery but increasing time and the difficulty of development. Therefore, these results provide the technology that alternately injecting the slug of the gel and polymer/surfactant could advance develop the residual oil and enhance the recovery after polymer flooding.


2013 ◽  
Vol 318 ◽  
pp. 491-495
Author(s):  
Yue Luo ◽  
Ding Wang ◽  
Lei Bai ◽  
Ke Jian Zha

A polymer gel-surfactant composition profile control technology has been developed, basing on the high salinity, especially high levels of Ca2+, Mg2+ in the injection water of the Hongshanzui oilfield. The construction parameters of deep profile control & oil displacement have been studied by performing core displacement experiments. The results show that the ratio of polymer gel slug and active agents slug is 1:0.3, the best ratio of strong polymer gel, medium polymer gel and weak polymer gel slug is 4:3:3. The way of combination is stronger gel slug + surfactant slug + in strong gel slug + weak gel slug + surfactant slug + strong gel sealing slug. The application effect of this technology in Hongshanzui oilfield is remarkable, the 12 tune flooding group daily oil production rose from 85t to 130t and the liquid water content decreased from 75% to 67%.


SPE Journal ◽  
2016 ◽  
Vol 21 (04) ◽  
pp. 1126-1139 ◽  
Author(s):  
Robin Singh ◽  
Kishore K. Mohanty

Summary The goal of this work is to systematically study the effect of wettability alteration and foaming, either acting individually or synergistically, on tertiary oil recovery in oil-wet carbonate cores. Three types of anionic-surfactant formulations were used: alkyl propoxy sulfate (APS), which exhibited low interfacial tension (IFT), wettability alteration, and weak foaming; alpha-olefin sulfonate (AOS), which showed no wettability alteration but good foaming; and a blend of APS, AOS, and a zwitterionic-foam booster, which showed low IFT, wettability alteration, and good foaming. First, contact-angle experiments were conducted on oil-wet calcite plates to evaluate their wettability-altering capabilities. Second, spontaneous imbibitions in a microchannel were performed to study the role of IFT reduction and wettability alteration by these formulations. Third, static foam tests were conducted to evaluate their foaming performance in bulk. Fourth, foam-flow experiments were conducted in cores to evaluate potential synergism between the anionic-surfactant AOS and the zwitterionic surfactants in stabilizing foam in the absence of crude oil. Finally, oil-displacement experiments were performed by use of a vuggy, oil-wet, dolomite core saturated with a crude oil. After secondary waterfloods, surfactant solutions were coinjected with methane gas at a fixed foam quality (gas-volume fraction). Contact-angle and spontaneous-imbibition experiments showed that AOS can act as a wettability-altering surfactant in the presence of sodium carbonate, but not alone. No synergy was observed in foam stabilization by means of the blend of zwitterionic surfactant and AOS solution (1:1) in a water-wet carbonate core. Oil-displacement experiments in oil-wet carbonate core revealed that coinjection of wettability-altering surfactant and gas can recover a significant amount of oil [33% original oil in place (OOIP)] over waterflood. During foam flooding, with AOS as the foaming agent, only a weak foam was propagated in a carbonate core, irrespective of the core wettability. A blend of wettability-altering surfactant, AOS, and zwitterionic surfactant not only altered the wettability of carbonate core from oil-wet to water-wet, but also significantly increased the foam-pressure gradient in the presence of crude oil.


2020 ◽  
Vol 10 (3) ◽  
pp. 927
Author(s):  
Shaohua You ◽  
Xiaofei Sun ◽  
Xiaoyu Li

Colloidal gas aphrons (CGAs) offer some advantages in improving oil recovery, but resin and asphaltene deposition problems still occur in CGA flooding. Based on this phenomenon, a new modified colloidal foam system is developed by incorporating a modifier in CGA preparation. The results indicate that the modified CGAs prepared by adding foaming agent sodium dodecyl sulfate (SDS) (concentration: 5 g/L) and GXJ-C (a CGAs modifier from a light fraction of petroleum; concentration: 0.1 g/L) attained the best performance. Oil displacement experiments show that modified CGA flooding had a better effect than water or CGA flooding. There are two important mechanisms via which modified CGAs enhance oil recovery, including decreasing the interfacial tension and enhancing the heavy components in the recovered oil. The developed modified CGA system attained a good oil displacement effect, which is of guiding significance to further improve the oil displacement efficiency and application of foam flooding.


SPE Journal ◽  
2018 ◽  
Vol 23 (06) ◽  
pp. 2218-2231 ◽  
Author(s):  
Pinaki Ghosh ◽  
Kishore K. Mohanty

Summary Carbonate rocks are typically heterogeneous at many scales, leading to low waterflood recoveries. Polymers and gels cannot be injected into nonfractured low-permeability carbonates (k < 10 md) because pore throats are smaller than the polymers. Foams have the potential to improve both oil-displacement efficiency and sweep efficiency in such carbonate rocks. However, foams have to overcome two adverse conditions in carbonates: oil-wettability and low permeability. This study evaluates several cationic-foam formulations that combine wettability alteration and foaming in low-permeability oil-wet carbonate cores. Contact-angle experiments were performed on initially oil-wet media to evaluate the wettability-altering capabilities of the surfactant formulations. Static foam-stability tests were conducted to evaluate their foaming performance in bulk; foam-flow experiments (without crude oil) were performed in porous media to estimate the foam strength. Finally, oil-displacement experiments were performed with a crude oil after a secondary gasflood. Two different injection strategies were studied in this work: surfactant slug followed by gas injection and coinjection of surfactant with gas at a constant foam quality. Systematic study of oil-displacement experiments in porous media showed the importance of wettability alteration in increasing tertiary oil recovery for oil-wet media. Several blends of cationic, nonionic, and zwitterionic surfactants were used in the experiments. In-house-developed Gemini cationic surfactant GC 580 was able to alter the wettability from oil-wet to water-wet and also formed strong bulk foam. Static foam tests showed an increase in bulk foam stability with the addition of zwitterionic surfactants to GC 580. Oil-displacement experiments in oil-wet carbonate cores revealed that tertiary oil recovery with injection of a wettability-altering surfactant and foam can recover a significant amount of oil [approximately 25 to 52% original oil in place (OOIP)] over the secondary gasflood. The foam rheology in the presence of oil suggested propagation of only weak foam in oil-wet low-permeability carbonate cores.


2013 ◽  
Vol 868 ◽  
pp. 522-528
Author(s):  
Tao Ping Chen ◽  
Biao Qiu ◽  
Qi Hao Hu

As concerning the limitations of the classic capillary number theory in the applications to the oil displacement with the ultra low interfacial intension system in low permeability reservoirs, considering the flow velocity of water/oil displacement through pores in low permeability reservoirs and the mechanism of displacement of the remaining oil in the parallel pores, and considering the influences of ultra low interfacial intension on oil/water relative permeability and the influences of non-homogeneity on the recovery, the expression of modification of the capillary number was given. The relation curves of recovery and capillary number were plotted through the displacement experiments with the ultra low interfacial intension system in low permeability cores. Some points on the application of capillary number to the oil displacement with the ultra low interfacial tension system were given, and the reasonable ways of enhancing the recovery of water flooding low permeability reservoirs with ultra low interfacial intension system were shown.


Sign in / Sign up

Export Citation Format

Share Document