Fly ash and granulated blast-furnace slag as ‘stabilisers’ of portland cements with added periclase

1978 ◽  
Vol 28 (11) ◽  
pp. 687-698
Author(s):  
Marianne E. Gaze ◽  
Michael A. Smith
2020 ◽  
Vol 322 ◽  
pp. 01017
Author(s):  
Michał Wieczorek

In the formulations of adhesive mortars for tiles almost exclusively CEM I Portland cements are used. Practically no CEM II - CEM V cements with additives are used, although they are often produced with strength classes 32.5 R and some even 42.5R. Relationship between strengths of tile adhesives in which cement was partially replaced with fly ash and granulated blast furnace slag was studied. A fly ash was used in three different replacement levels from 5% to 25% by weight of either cement. The tensile adhesion were determined at 28 and 90 days after various conditioning conditions of the samples. The influence on the flexibility of mortars was also assessed. In small substitution levels, fly ash replacement increased the tensile adhesion strength. The results indicate that the optimal amount of fly ash and granulated blast furnace slag additive replacing a given amount of cement allows to obtain adhesive mortars for tiles with high functional parameters.


Materials ◽  
2021 ◽  
Vol 14 (12) ◽  
pp. 3239
Author(s):  
Rosa Abnelia Rivera ◽  
Miguel Ángel Sanjuán ◽  
Domingo Alfonso Martín ◽  
Jorge Luis Costafreda

Ternary Portland cements are new cementitious materials that contain different amounts of cement replacements. Ternary Portland cements composed of granulated blast-furnace slag (GBFS), coal fly ash (CFA), and clinker (K) can afford some environmental advantages by lowering the Portland cement clinker use. Accordingly, this is an opportunity to reduce carbon dioxide emissions and achieve net-zero carbon emissions by 2050. Furthermore, GBFS and CFA possess pozzolanic properties and enhance the mechanical strength and durability at later ages. Compressive strength and natural carbonation tests were performed in mortar and concrete. Cement-based materials made with GBFS and/or CFA presented a delay in the compressive strength development. In addition, they exhibited lower carbonation resistance than that of mortar and concrete made with plain Portland cements. Concrete reinforcement remains passive in common conditions; however, it could be corroded if the concrete pore solution pH drops due to the carbonation process. Service life estimation was performed for the ternary cements regarding the carbonation process. This information can be useful to material and civil engineers in designing concretes made with these ternary cements.


2020 ◽  
Vol 12 (14) ◽  
pp. 5783 ◽  
Author(s):  
Rosa Abnelia Rivera ◽  
Miguel Ángel Sanjuán ◽  
Domingo Alfonso Martín

Granulated blast-furnace slag (GBFS) and coal fly ash (CFA) are two well-known constituents in Portland cements. Ternary Portland cements (GBFS-CFA-K) provide environmental advantages by reducing Portland cement clinker (K) production and, therefore, promote lower CO2 emissions. Nevertheless, both of them cause a delay in the compressive strength gain. Given that, the early compressive strength for both constituents is low, but they improve the compressive strength at medium and later ages as consequence of the pozzolanic reaction. In this paper, a full factorial design with two levels was developed for the mortar compressive strength estimation at 2, 7 and 28 days. Mortar prisms made with 25% and 40% of granulated blast-furnace slag (GBFS) and/or coal fly ash (CFA) were tested. The effects of the interaction between GBFS and CFA on the compressive strength development of ternary Portland cement mortars were reported. Results show that the contribution of both cement constituents to the ternary mortar mix reduces the compressive strength for all the tested ages. Nevertheless, the finer the GBFS, the better ternary cement performance was achieved, showing that the synergistic effect is more effective when the finer GBFS is used, probably due to a more adequate particle size distribution. Finally, a relationship between compressive strength, fineness, GBFS content and CFA content was found for each age.


Crystals ◽  
2021 ◽  
Vol 11 (6) ◽  
pp. 596
Author(s):  
Yasuhiro Dosho

To improve the application of low-quality aggregates in structural concrete, this study investigated the effect of multi-purpose mineral admixtures, such as fly ash and ground granulated blast-furnace slag, on the performance of concrete. Accordingly, the primary performance of low-quality recycled aggregate concrete could be improved by varying the replacement ratio of the recycled aggregate and using appropriate mineral admixtures such as fly ash and ground granulated blast-furnace slag. The results show the potential for the use of low-quality aggregate in structural concrete.


2011 ◽  
Vol 99-100 ◽  
pp. 420-425 ◽  
Author(s):  
Qian Rong Yang ◽  
Xiao Qian Wang ◽  
Hui Ji

The strength, expansion and amount of scaling of concrete with compound mineral admixture (CMA) from steel slag, granulated blast furnace slag and fly ash were studied. The result shows that damage by crystallization press from sulfate attack when concrete was exposed to sulfate environments under wetting–drying alternation is much larger than that from sulfate chemical attack. Adding CMA to concrete could reduce the damage from expansion of concrete caused by sulfate chemical attack, but the resistance of concrete to damage by crystallization press from sulfate attack was remarkably reduced.


Sign in / Sign up

Export Citation Format

Share Document