scholarly journals Silicone composites cured under a high electric field: an electromechanical experimental study

2020 ◽  
Author(s):  
Ajeet Kumar ◽  
Karali Patra ◽  
Mokarram Hossain
Author(s):  
Yingxia Wei ◽  
Yaoxiang Liu ◽  
Tie-Jun Wang ◽  
Na Chen ◽  
Jingjing Ju ◽  
...  

We report on a systematic experimental study on the fluorescence spectra produced from a femtosecond laser filament in air under a high electric field. The electric field alone was strong enough to create corona discharge (CD). Fluorescence spectra from neutral and ionic air molecules were measured and compared with pure high-voltage CD and pure laser filamentation (FIL). Among them, high electric field assisted laser FIL produced nitrogen fluorescence more efficiently than either pure CD or pure FIL processes. The nonlinear enhancement of fluorescence from the interaction of the laser filament and corona discharging electric field resulted in a more efficient ionization along the laser filament zone, which was confirmed by the spectroscopic measurement of both ionization-induced fluorescence and plasma-scattered 800 nm laser pulses. This is believed to be the key precursor process for filament-guided discharge.


Materials ◽  
2019 ◽  
Vol 12 (17) ◽  
pp. 2657 ◽  
Author(s):  
Liwei Zhou ◽  
Xuan Wang ◽  
Yongqi Zhang ◽  
Peng Zhang ◽  
Zhi Li

In order to study the crystallinity of different density polyethylenes, this paper conducts an experimental study on the transformation of the conductance mechanism under a high electric field. In this experiment, X-ray diffraction (XRD), differentials scanning calorimetry (DSC), direct current (DC) breakdown of low-density polyethylene (LDPE), linear low-density polyethylene (LLDPE), medium-density polyethylene (MDPE) and high-density polyethylene (HDPE), as well as the conductivity characteristics under an electric field of 5–200 kV/mm are tested. In addition, the electric field–current density curves of the four kinds of polyethylene are fitted to analyze their conductance transition in non-ohmic regions under different high field strengths, through applying the mathematical formula of a variety of conductance mechanisms. The experimental results are as follows: as the density of polyethylene increases, the crystallinity increases continuously. Moreover, the continuous increase of crystallinity causes the electric conduction flow under the same field strength to decrease significantly. The field strength corresponding to the two turning points in the conductance characteristic curve increases simultaneously, and the breakdown field strength increases accordingly; through analysis, it is found that in the high field, as the electric field increases, the conductance mechanism develops from the ohmic conductance of the low field strength region to the bulk effect of the high field strength region (Poole–Frenkel effect). Then, it develops into the electrode effect to the high field strength (Schottky effect), although the threshold field strength of this conductance mechanism transition increases with the increase of crystallinity.


2020 ◽  
Vol 140 (8) ◽  
pp. 650-655
Author(s):  
Shoki Tsuji ◽  
Yoji Fujita ◽  
Hiroaki Urushibata ◽  
Akihiko Kono ◽  
Ryoichi Hanaoka ◽  
...  

2018 ◽  
Vol 7 (3.36) ◽  
pp. 127 ◽  
Author(s):  
Nishanthi Sunthrasakaran ◽  
Nor Akmal Mohd Jamail ◽  
Qamarul Ezani Kamarudin ◽  
Sujeetha Gunabalan

The most important aspect influencing the circumstance and characteristics of electrical discharges is the distribution of electric field in the gap of electrodes. The study of discharge performance requires details on the variation of maximum electric field around the electrode. In electrical power system, the insulation of high voltage power system usually subjected with high electric field. The high electric field causes the degradation performance of insulation and electrical breakdown start to occur. Generally, the standard sphere gaps widely used for protective device in electrical power equipment. This project is study about the electric field distribution and current density for different electrode configuration with XLPE barrier. Hence, the different electrode configuration influences the electric field distribution. This project mainly involves the simulation in order to evaluate the maximum electric field for different electrode configuration. Finite Element Method (FEM) software has been used in this project to perform the simulation. This project also discusses the breakdown characteristics of the XLPE. The accurate evaluation of electric field distribution and maximum electric field is an essential for the determination of discharge behavior of high voltage apparatus and components. The degree of uniformity is very low for pointed rod-plane when compared to other two electrode configurations. The non- uniform electric distribution creates electrical stress within the surface of dielectric barrier. As a conclusion, when the gap distance between the electrodes increase the electric field decrease.  


1979 ◽  
Vol 30 (2) ◽  
pp. 219-223 ◽  
Author(s):  
S.G. Dinev ◽  
Ch.I. Radev ◽  
K.V. Stamenov ◽  
K.A. Stankov

1997 ◽  
Vol 72-74 ◽  
pp. 112-113 ◽  
Author(s):  
Zhidong Lou ◽  
Zheng Xu ◽  
Feng Teng ◽  
Xurong Xu

1998 ◽  
Vol 15 (1) ◽  
pp. 318 ◽  
Author(s):  
Robert Blum ◽  
Martin Sprave ◽  
Jurgen Sablotny ◽  
Manfred Eich

Sign in / Sign up

Export Citation Format

Share Document