Relationship between Covalence and Displacive Phase Transition Temperature in RAO4 and LiAO3 (R = Rare-Earth Element and A = Nb and Ta)

1995 ◽  
Vol 116 (1) ◽  
pp. 28-32 ◽  
Author(s):  
S. Tsunekawa ◽  
T. Kamiyama ◽  
H. Asano ◽  
T. Fukuda
2020 ◽  
Vol 32 (3) ◽  
pp. 305-310
Author(s):  
Wendi Liu ◽  
Yan Yang ◽  
Qunke Xia

Abstract. It has long been known that hydrogen impurities can be incorporated in the structure of nominally anhydrous minerals (NAMs) and substantially influence their physical properties. One of the geologically most prominent NAMs is feldspar. The hydrogen concentration in NAMs is usually expressed in parts per million of water by weight (ppm H2O wt.) In this paper, we use the term “hydrogen” for uniformity, except when we use “water” for describing its amount expressed as parts per million of H2O by weight. In our article (Liu et al., 2018), we carried out in situ high-temperature X-ray powder diffraction and Raman spectroscopic studies on three natural anorthoclase samples with similar Or (K-feldspar) contents (Ab67Or31An2, Ab66Or31An2, and Ab65Or33An3) and Al–Si disordering but contrasting water contents. The spectroscopic results suggested that the displacive phase transition temperature is higher for the nearly anhydrous anorthoclase sample than the anorthoclase samples with about 200 ppm water, and we thus concluded that hydrogen is another factor impacting the displacive phase transition temperature. We thank Kroll and Schmid-Beurmann for pointing out the weakness in our interpretation that hydrogen is a possible important factor (Kroll and Schmid-Beurmann, 2020). To clarify this issue, we conducted transmission electron microscopy (TEM) experiments on the three samples to check texture effects. The TEM studies indicated that the nearly anhydrous anorthoclase sample consists of two feldspar phases, a K-poor and a K-rich one, and that the K-poor area may be responsible for the higher displacive phase transition temperature. According to the observation that the temperature of redistribution of hydrogen is accordant with the displacive phase transition temperature, the effect of hydrogen could not be ruled out. Based on these results, it can be concluded that hydrogen may not be the sole possible factor, and it was a proposition more than a definitive proof for the moment. Natural feldspars are complex, and factors affecting displacive phase transitions are multiple (e.g., Salje et al., 1991; Harrison and Salje, 1994; Hayward and Salje, 1996; Dobrovolsky et al., 2017). Therefore, to further investigate hydrogen effects on displacive phase transition in feldspar, synthetic samples with pure chemical compositions and hydrogen species are necessary. In the following, we address each issue in the same order as in the comment by Kroll and Schmidt-Beurmann (2020).


2018 ◽  
Vol 30 (6) ◽  
pp. 1071-1081 ◽  
Author(s):  
Wendi Liu ◽  
Yan Yang ◽  
Qunke Xia ◽  
Yu Ye ◽  
Zhongping Wang ◽  
...  

RSC Advances ◽  
2016 ◽  
Vol 6 (98) ◽  
pp. 96275-96280 ◽  
Author(s):  
Weigang Cao ◽  
Qiang Li ◽  
Kun Lin ◽  
Zhanning Liu ◽  
Jinxia Deng ◽  
...  

Orthorhombic Dy2W3O12 shows NTE (−2.6 × 10−5 °C−1) in the temperature range of 150–500 °C. So far, this value is the largest coefficient of negative thermal expansion in the A2W3O12 family (A = rare earth element).


Author(s):  
Uwe Lücken ◽  
Joachim Jäger

TEM imaging of frozen-hydrated lipid vesicles has been done by several groups Thermotrophic and lyotrophic polymorphism has been reported. By using image processing, computer simulation and tilt experiments, we tried to learn about the influence of freezing-stress and defocus artifacts on the lipid polymorphism and fine structure of the bilayer profile. We show integrated membrane proteins do modulate the bilayer structure and the morphology of the vesicles.Phase transitions of DMPC vesicles were visualized after freezing under equilibrium conditions at different temperatures in a controlled-environment vitrification system. Below the main phase transition temperature of 24°C (Fig. 1), vesicles show a facetted appearance due to the quasicrystalline areas. A gradual increase in temperature leads to melting processes with different morphology in the bilayer profile. Far above the phase transition temperature the bilayer profile is still present. In the band-pass-filtered images (Fig. 2) no significant change in the width of the bilayer profile is visible.


Sign in / Sign up

Export Citation Format

Share Document