Advances in Nano-finishing of Optical Glasses and Glass Ceramics

2020 ◽  
pp. 569-599
Author(s):  
Mahender Kumar Gupta ◽  
I. Abdul Rasheed ◽  
M. Buchi Suresh
Keyword(s):  
Glass Ceramics ◽  
Optical Glasses

Advances in Nano-finishing of Optical Glasses and Glass Ceramics

2020 ◽  
pp. 1-31
Author(s):  
M. Buchi Suresh ◽  
I. A. Rasheed ◽  
Mahender Kumar Gupta
Keyword(s):  
Glass Ceramics ◽  
Optical Glasses

Optical glasses and glass ceramics for large optical systems

2003 ◽  
Author(s):  
Thorsten Doehring ◽  
Peter Hartmann ◽  
Hans F. Morian ◽  
Ralf Jedamzik
Keyword(s):  
Glass Ceramics ◽  
Optical Systems ◽  
Optical Glasses

Samarium Ions Doped Yttrium Aluminium Garnet Glass Ceramics

2012 ◽  
Vol 531-532 ◽  
pp. 216-219
Author(s):  
Jie Yang ◽  
Xiao Liu ◽  
Bin Zhai ◽  
Zhi Qiang Wang ◽  
Xin Zhao ◽  
...  
Keyword(s):  
Single Phase ◽  
Glass Ceramics ◽  
Heat Treating ◽  
Rare Earth Ions ◽  
Yttrium Aluminium Garnet ◽  
Stark Splitting ◽  
Optical Glasses ◽  
Yttrium Aluminium ◽  
Internal Network ◽  
The Matrix

Sm3+doped YAG glass ceramics containing single phase of YAG micro-crystals have been obtained by heat-treating the aluminosilicate precursor glasses. The YAG crystals grow with several preferred orientations and a dominant one (444) in the matrix, and present microcrystal sizes in the range of 3~15µm. The pilotaxitic texture existed in internal network of the YAG glass ceramics can increase yield strength and tensile strength of the sample effectively. Typical visible transition emissions of Sm3+have been observed in the YAG glass ceramics under the excitation of short-wavelength visible light, and the spectral intensity ratio between the electric dipole4G5/2→6H9/2and the magnetic dipole4G5/2→6H5/2transitions is lower than the values reported in the optical glasses specifying the enhanced symmetric nature in the Sm3+doped YAG glass ceramics. The obvious Stark splitting exhibited in emission spectrum manifests that rare-earth ions have been incorporated into YAG lattices.

Optical glasses and glass ceramics for large lenses and prisms

2002 ◽  
Author(s):  
Peter Hartmann ◽  
Hans F. Morian ◽  
Ralf Jedamzik
Keyword(s):  
Glass Ceramics ◽  
Optical Glasses

The Microstructure of Steatite (Protoenstatite)

1985 ◽  
Vol 43 ◽  
pp. 236-237
Author(s):  
W. E. Lee ◽  
A. H. Heuer
Keyword(s):  
High Frequency ◽  
Glass Ceramics ◽  
Magnesium Silicate ◽  
Beam Current ◽  
Glassy Matrix ◽  
Angle Of Incidence ◽  
X Ray ◽  
Mechanical And Electrical Properties ◽  
Argon Ions ◽  
High Temperature Polymorph

IntroductionTraditional steatite ceramics, made by firing (vitrifying) hydrous magnesium silicate, have long been used as insulators for high frequency applications due to their excellent mechanical and electrical properties. Early x-ray and optical analysis of steatites showed that they were composed largely of protoenstatite (MgSiO3) in a glassy matrix. Recent studies of enstatite-containing glass ceramics have revived interest in the polymorphism of enstatite. Three polymorphs exist, two with orthorhombic and one with monoclinic symmetry (ortho, proto and clino enstatite, respectively). Steatite ceramics are of particular interest a they contain the normally unstable high-temperature polymorph, protoenstatite.Experimental3mm diameter discs cut from steatite rods (∼10” long and 0.5” dia.) were ground, polished, dimpled, and ion-thinned to electron transparency using 6KV Argon ions at a beam current of 1 x 10-3 A and a 12° angle of incidence. The discs were coated with carbon prior to TEM examination to minimize charging effects.

Energy saving technology for sintering of black bricks from high-siliceous clay

MRS Advances ◽  
2020 ◽  
Vol 5 (61) ◽  
pp. 3123-3131
Author(s):  
Mario Flores Nicolas ◽  
Marina Vlasova ◽  
Pedro Antonio Márquez Aguilar ◽  
Mykola Kakazey ◽  
Marcos Mauricio Chávez Cano ◽  
...  
Keyword(s):  
Low Temperature ◽  
Oxygen Deficiency ◽  
Glass Ceramics ◽  
Total Content ◽  
Ceramic Materials ◽  
Ternary Mixtures ◽  
High Porosity ◽  
Reducing Conditions ◽  
Binary And Ternary Mixtures ◽  
Dark Color

AbstractThe low-temperature synthesis of bricks prepared from high-siliceous clays by the method of plastic molding of blanks was used. For the preparation of brick blanks, binary and ternary mixtures of high-siliceous clays, black sand, and bottle glass cullet were used. Gray-black low-porosity and high-porosity ceramics was obtained by sintering under conditions of oxygen deficiency. It has been established that to initiate plastic in mixtures containing high-siliceous clay, it is necessary to add montmorillonite/bentonite additives, carry out low-temperature sintering, and introduce low-melting glass additives with a melting point ranging from 750 to 800 °C. The performed investigations have shown that the sintering of mixtures with a total content of iron oxide of about 5 wt% under reducing conditions at Tsint. = 800°C for 8 h leads to the formation of glass ceramics consisting of quartz, feldspars, and a phase. The main sources of the appearance of a dark color is the formation of [Fe3+O4]4- and [Fe3+O6]9- anions in the composition of the glass phase and feldspars. By changing the contents of clay, sand, and glass in sintering, it is possible to obtain two types of ceramic materials: (a) in the form of building bricks and (b) in the form of porous fillers.

Magnetic Properties of xCeO2•(50 − x) PbO•50B2O3 Glasses and Glass Ceramics

2017 ◽  
Vol 13 (1) ◽  
pp. 4486-4494 ◽  
Author(s):  
G.El Damrawi ◽  
F. Gharghar
Keyword(s):  
Magnetic Properties ◽  
Large Scale ◽  
Glass Ceramics ◽  
Magnetic Behavior ◽  
Crystal Formation ◽  
Dual Roles ◽  
Effective Agent ◽  
Ordered Structures ◽  
Essential Change

Cerium oxide in borate glasses of composition xCeO2·(50 − x)PbO·50B2O3 plays an important role in changing both microstructure and magnetic behaviors of the system. The structural role of CeO2 as an effective agent for cluster and crystal formation in borate network is clearly evidenced by XRD technique. Both structure and size of well-formed cerium separated clusters have an effective influence on the structural properties. The cluster aggregations are documented to be found in different range ordered structures, intermediate and long range orders are the most structures in which cerium phases are involved. The nano-sized crystallized cerium species in lead borate phase are evidenced to have magnetic behavior.  The criteria of building new specific borate phase enriched with cerium as ferrimagnetism has been found to keep the magnetization in large scale even at extremely high temperature. Treating the glass thermally or exposing it to an effective dose of ionized radiation is evidenced to have an essential change in magnetic properties. Thermal heat treatment for some of investigated materials is observed to play dual roles in the glass matrix. It can not only enhance alignment processes of the magnetic moment but also increases the capacity of the crystallite species in the magnetic phases. On the other hand, reverse processes are remarked under the effect of irradiation. The magnetization was found to be lowered, since several types of the trap centers which are regarded as defective states can be produced by effect of ionized radiation. 

Sign in / Sign up

Export Citation Format

Share Document