Methods and Instrumentation in Mass Spectrometry for the Differentiation of Closely Related Microorganisms

2016 ◽  
pp. 13-50 ◽  
Author(s):  
Franco Basile ◽  
Rudolph K. Mignon
Keyword(s):  
Mass Spectrometry

How SIMS microscopy can be used in medicine

1992 ◽  
Vol 50 (2) ◽  
pp. 1602-1603
Author(s):  
Philippe Fragu
Keyword(s):  
Mass Spectrometry ◽  
Biomedical Applications ◽  
Secondary Ion Mass Spectrometry ◽  
Chemical Elements ◽  
Biological Applications ◽  
The Past ◽  
Potential Source ◽  
Secondary Ion ◽  
Chemical Integrity ◽  
Scientific Endeavour

The identification, localization and quantification of intracellular chemical elements is an area of scientific endeavour which has not ceased to develop over the past 30 years. Secondary Ion Mass Spectrometry (SIMS) microscopy is widely used for elemental localization problems in geochemistry, metallurgy and electronics. Although the first commercial instruments were available in 1968, biological applications have been gradual as investigators have systematically examined the potential source of artefacts inherent in the method and sought to develop strategies for the analysis of soft biological material with a lateral resolution equivalent to that of the light microscope. In 1992, the prospects offered by this technique are even more encouraging as prototypes of new ion probes appear capable of achieving the ultimate goal, namely the quantitative analysis of micron and submicron regions. The purpose of this review is to underline the requirements for biomedical applications of SIMS microscopy.Sample preparation methodology should preserve both the structural and the chemical integrity of the tissue.

Imaging of Al-Li-Cu alloys with a Scanning Ion Microprobe

1990 ◽  
Vol 48 (2) ◽  
pp. 314-315
Author(s):  
K.K. Soni ◽  
D.B. Williams ◽  
J.M. Chabala ◽  
R. Levi-Setti ◽  
D.E. Newbury
Keyword(s):  
Mass Spectrometry ◽  
Secondary Ion Mass Spectrometry ◽  
Equilibrium Phase ◽  
Icosahedral Symmetry ◽  
Ion Microprobe ◽  
X Ray ◽  
Cu Alloys ◽  
Two Phases ◽  
The University ◽  
Secondary Ion

In contrast to the inability of x-ray microanalysis to detect Li, secondary ion mass spectrometry (SIMS) generates a very strong Li+ signal. The latter’s potential was recently exploited by Williams et al. in the study of binary Al-Li alloys. The present study of Al-Li-Cu was done using the high resolution scanning ion microprobe (SIM) at the University of Chicago (UC). The UC SIM employs a 40 keV, ∼70 nm diameter Ga+ probe extracted from a liquid Ga source, which is scanned over areas smaller than 160×160 μm2 using a 512×512 raster. During this experiment, the sample was held at 2 × 10-8 torr.In the Al-Li-Cu system, two phases of major importance are T1 and T2, with nominal compositions of Al2LiCu and Al6Li3Cu respectively. In commercial alloys, T1 develops a plate-like structure with a thickness <∼2 nm and is therefore inaccessible to conventional microanalytical techniques. T2 is the equilibrium phase with apparent icosahedral symmetry and its presence is undesirable in industrial alloys.

Applications of Time-OF-Flight Secondary Ion Mass Spectrometry (TOF-SIMS)

1990 ◽  
Vol 48 (2) ◽  
pp. 308-309
Author(s):  
Bruno Schueler ◽  
Robert W. Odom
Keyword(s):  
Mass Spectrometry ◽  
Secondary Ion Mass Spectrometry ◽  
Structural Information ◽  
Time Of Flight ◽  
Biological Tissues ◽  
Polymer Surfaces ◽  
Tof Sims ◽  
Secondary Ions ◽  
Ion Mass Spectrometry ◽  
Secondary Ion

Time-of-flight secondary ion mass spectrometry (TOF-SIMS) provides unique capabilities for elemental and molecular compositional analysis of a wide variety of surfaces. This relatively new technique is finding increasing applications in analyses concerned with determining the chemical composition of various polymer surfaces, identifying the composition of organic and inorganic residues on surfaces and the localization of molecular or structurally significant secondary ions signals from biological tissues. TOF-SIMS analyses are typically performed under low primary ion dose (static SIMS) conditions and hence the secondary ions formed often contain significant structural information.This paper will present an overview of current TOF-SIMS instrumentation with particular emphasis on the stigmatic imaging ion microscope developed in the authors’ laboratory. This discussion will be followed by a presentation of several useful applications of the technique for the characterization of polymer surfaces and biological tissues specimens. Particular attention in these applications will focus on how the analytical problem impacts the performance requirements of the mass spectrometer and vice-versa.

Dicarbonyl derived post-translational modifications: chemistry bridging biology and aging-related disease

2020 ◽  
Vol 64 (1) ◽  
pp. 97-110
Author(s):  
Christian Sibbersen ◽  
Mogens Johannsen
Keyword(s):  
Mass Spectrometry ◽  
Future Research ◽  
Amino Acid Residues ◽  
Post Translational Modification ◽  
Dicarbonyl Compounds ◽  
Protein Targets ◽  
Post Translational Modifications ◽  
Reactive Protein ◽  
Glycation End Products ◽  
Direct Mass Spectrometry

Abstract In living systems, nucleophilic amino acid residues are prone to non-enzymatic post-translational modification by electrophiles. α-Dicarbonyl compounds are a special type of electrophiles that can react irreversibly with lysine, arginine, and cysteine residues via complex mechanisms to form post-translational modifications known as advanced glycation end-products (AGEs). Glyoxal, methylglyoxal, and 3-deoxyglucosone are the major endogenous dicarbonyls, with methylglyoxal being the most well-studied. There are several routes that lead to the formation of dicarbonyl compounds, most originating from glucose and glucose metabolism, such as the non-enzymatic decomposition of glycolytic intermediates and fructosyl amines. Although dicarbonyls are removed continuously mainly via the glyoxalase system, several conditions lead to an increase in dicarbonyl concentration and thereby AGE formation. AGEs have been implicated in diabetes and aging-related diseases, and for this reason the elucidation of their structure as well as protein targets is of great interest. Though the dicarbonyls and reactive protein side chains are of relatively simple nature, the structures of the adducts as well as their mechanism of formation are not that trivial. Furthermore, detection of sites of modification can be demanding and current best practices rely on either direct mass spectrometry or various methods of enrichment based on antibodies or click chemistry followed by mass spectrometry. Future research into the structure of these adducts and protein targets of dicarbonyl compounds may improve the understanding of how the mechanisms of diabetes and aging-related physiological damage occur.

The challenge of detecting modifications on proteins

2020 ◽  
Vol 64 (1) ◽  
pp. 135-153 ◽  
Author(s):  
Lauren Elizabeth Smith ◽  
Adelina Rogowska-Wrzesinska
Keyword(s):  
Mass Spectrometry ◽  
Protein Function ◽  
Chemical Properties ◽  
Lysine Acetylation ◽  
Mass Determination ◽  
Post Translational Modifications ◽  
Site Specific ◽  
The Common

Abstract Post-translational modifications (PTMs) are integral to the regulation of protein function, characterising their role in this process is vital to understanding how cells work in both healthy and diseased states. Mass spectrometry (MS) facilitates the mass determination and sequencing of peptides, and thereby also the detection of site-specific PTMs. However, numerous challenges in this field continue to persist. The diverse chemical properties, low abundance, labile nature and instability of many PTMs, in combination with the more practical issues of compatibility with MS and bioinformatics challenges, contribute to the arduous nature of their analysis. In this review, we present an overview of the established MS-based approaches for analysing PTMs and the common complications associated with their investigation, including examples of specific challenges focusing on phosphorylation, lysine acetylation and redox modifications.

Sign in / Sign up

Export Citation Format

Share Document