Optimization of Ferulic Acid Production from Oil Palm Frond Bagasse

Author(s):  
Zulsyazwan Ahmad Khushairi ◽  
Hafizuddin Wan Yussof ◽  
Norazwina Zainol
2020 ◽  
Vol 2 (2) ◽  
Author(s):  
Zulsyazwan Ahmad Khushairi ◽  
Kamaliah Abdul Samad ◽  
Nurul Aliaa Abdul Rahman ◽  
Hafizuddin Wan Yussof ◽  
Norazwina Zainol

2016 ◽  
Vol 78 (10) ◽  
Author(s):  
Zulsyazwan Ahmad Khushairi ◽  
Hafizuddin Wan Yussof ◽  
Nurul Atikah Rodzri ◽  
Rozaimi Abu Samah ◽  
Norazwina Zainol

Enzymatic hydrolysis of fibre-pressed oil palm frond (FPOPF) was done using mix culture for the production of ferulic acid. Mix culture was prepared by acclimatizing the soil obtained from palm oil plantation with FPOPF substrate for 30 days. The substrate had a ratio of FPOPF to water of 1:10. Design Expert 7.1 was used to aid the experimental design. A half fractional two-level factorial analysis with five factors was selected for the experimental design resulting in a total of 16 runs. The factors controlled were temperature (A; 26°C and 40°C), pH value (B; 5 and 9), agitation speed (C; 0 and 150 rpm), inoculum percentage (D; 2% and 10%), and response time (E; 1 and 3 days). The result obtained showed that the experimental design model was significant with a coefficient of determination value of 0.8978. Two factors that contributed the most to the process were temperature and pH value. This model was proved to be repeatable with a validation test percentage error at 4.15% to 6.83%.


2016 ◽  
Vol 51 (10) ◽  
pp. 1527-1537 ◽  
Author(s):  
Abdullah Amru Indera Luthfi ◽  
Jamaliah Md. Jahim ◽  
Shuhaida Harun ◽  
Jian Ping Tan ◽  
Abdul Wahab Mohammad

Author(s):  
F S Hashim ◽  
H W Yussof ◽  
M A K M Zahari ◽  
R A Rahman ◽  
R M Illias

2014 ◽  
Vol 893 ◽  
pp. 488-491 ◽  
Author(s):  
Elfarizanis Baharudin ◽  
Alyani Ismail ◽  
Adam Reda Hasan Alhawari ◽  
Edi Syams Zainudin ◽  
Dayang L.A. Majid ◽  
...  

This paper presents the results on dielectric properties of pulverized material based on agricultural waste namely oil palm frond and pineapple leaf fiber for microwave absorber application in the X-band frequency range. The investigation is started by identifying the pulverized materials permittivities and loss tangents using coaxial probe technique, followed by density measurement comprising the determination of bulk and solid densities. Then, by using dielectric mixture model, the solid particle dielectric properties were determined. It is observed that the air properties give quite an effect on the permittivity and loss tangent of the pulverized materials. It is also found that the lower the material density the higher material dielectric constant will be. Furthermore, the results show that, both oil palm frond and pineapple leaf fiber are potential to be X-band absorber with average dielectric constant of 4.40 and 3.38 respectively. The loss tangents for both materials were observed to be more than 0.1 which mark them as lossy materials.


Author(s):  
Siti Nur Ridhwah Muhamed Ramli ◽  
Tengku Elida Tengku Zainal Mulok ◽  
Sabiha Hanim Mohd Salleh ◽  
Khalilah Abdul Khalil ◽  
Othman Ahmad ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document