Characterization of Pectin Extracted from Guava Peels Using Deep Eutectic Solvent and Citric Acid

2020 ◽  
pp. 421-433
Author(s):  
Rizana Yusof ◽  
Siti Zawani Ahmad Zaini ◽  
Mohd Azhar Azman
Keyword(s):  
Citric Acid ◽  
Deep Eutectic Solvent

scholarly journals Characterization of Phosphate Coatings: Influence of the Acid Pickling Conditions

Materials ◽  
2021 ◽  
Vol 14 (4) ◽  
pp. 1048
Author(s):  
Belén Díaz ◽  
X. Ramón Nóvoa ◽  
Carmen Pérez ◽  
Sheila Silva-Fernández
Keyword(s):  
Citric Acid ◽  
High Strength ◽  
Acid Pickling ◽  
Acid Cleaning ◽  
Inorganic Acids ◽  
Phosphate Coatings ◽  
Acid Bath ◽  
Coating Morphology ◽  
Coating Weight

This research emphasizes the importance of the acid cleaning prior to the phosphate development on high-strength steel rods. It compares the phosphate properties achieved after different acid-pickling conditions. The most common inorganic acids were considered in this study. Additionally, taking into account the environmental and safety concerns of these acids, the assessment of a less harmful organic acid is presented. This study revealed significant differences in the coating morphology and chemical composition whereas no great changes were found in terms of the coating weight or porosity. Thus, hydrochloric and sulfuric acid promote the growth of a Fe-enriched phosphate layer with a less conductive character that is not developed after the pickling with phosphoric acid. The phosphate developed after the citric acid pickling is comparable to that developed after the inorganic acids although with a porosity slightly higher. The temperature of the citric acid bath is an important parameter that affects to the phosphate appearance, composition, and porosity.

scholarly journals Structural Characterization of a Polysaccharide from Gastrodia elata and Its Bioactivity on Gut Microbiota

Molecules ◽  
2021 ◽  
Vol 26 (15) ◽  
pp. 4443
Author(s):  
Jiangyan Huo ◽  
Min Lei ◽  
Feifei Li ◽  
Jinjun Hou ◽  
Zijia Zhang ◽  
...  
Keyword(s):  
Molecular Weight ◽  
Citric Acid ◽  
Gut Microbiota ◽  
Structural Characterization ◽  
Hot Water ◽  
Nmr Analysis ◽  
Gastrodia Elata ◽  
Hot Water Extraction ◽  
Hydroxybenzyl Alcohol

A novel homogeneous polysaccharide named GEP-1 was isolated and purified from Gastrodia elata (G. elata) by hot-water extraction, ethanol precipitation, and membrane separator. GEP-1, which has a molecular weight of 20.1 kDa, contains a polysaccharide framework comprised of only glucose. Methylation and NMR analysis showed that GEP-1 contained 1,3,6-linked-α-Glcp, 1,4-linked-α-Glcp, 1,4-linked-β-Glcp and 1,4,6-linked-α-Glcp. Interestingly, GEP-1 contained citric acid and repeating p-hydroxybenzyl alcohol as one branch. Furthermore, a bioactivity test showed that GEP-1 could significantly promote the growth of Akkermansia muciniphila (A. muciniphila) and Lacticaseibacillus paracasei (L.paracasei) strains. These results implied that GEP-1 might be useful for human by modulating gut microbiota.

Synthesis and characterization of starch/fiber-based bioplastic composites modified by citric acid-epoxidized palm oil oligomer with reactive blending

2021 ◽  
Vol 170 ◽  
pp. 113797
Author(s):  
Jianlei Yang ◽  
Yern Chee Ching ◽  
Cheng Hock Chuah ◽  
Dai Hai Nguyen ◽  
Nai-Shang Liou
Keyword(s):  
Citric Acid ◽  
Palm Oil ◽  
Synthesis And Characterization ◽  
Reactive Blending ◽  
Epoxidized Palm Oil

Preparation and Characterization of the Nano Powder for Al2O3-SiO2-CaF2 Glass by Homo-Precipitation Method

2007 ◽  
Vol 280-283 ◽  
pp. 1643-1646
Author(s):  
G.C. Yuan ◽  
Q.G. Wu ◽  
G.X. Zeng ◽  
X.H. Zhang
Keyword(s):  
Citric Acid ◽  
Amorphous Structure ◽  
Precipitation Method ◽  
Inorganic Salts ◽  
Mixture Ratio ◽  
Nano Powder ◽  
Desiccation Process ◽  
Amorphous Compounds ◽  
Crystal Phases

The nano-powder of Al2O3-SiO2-CaF2 bio-glass was prepared by the homo-precipitation method with some inorganic salts containing Al3+, Ca2+, Na+, F-, SiO3 2+, Cl- as starting-reagents. The composition and characteristics of the powders were studied with XRD, EDAX, TEM and DTA. The results indicate that the prepared powder belongs to amorphous compounds containing Al, Ca, Si, O and F atoms and the size of particle is in the range of 30 ~ 70 nm. Adding citric acid and the well-controlled desiccation process can slightly improve the dispersing effect of the powders; the mixture ratio of the reagents rarely affects the characteristic of powder. The crystal phase CaF2 was precipitated firstly from the amorphous structure when the temperature is above 600°C, with the temperature rising, Al2SiO5 and Al4.4Si1.2O9.5 etc. crystal phases were precipitated sequentially.

scholarly journals Desulfurization Performance of Choline Chloride-Based Deep Eutectic Solvents in the Presence of Graphene Oxide

Environments ◽  
2020 ◽  
Vol 7 (11) ◽  
pp. 97
Author(s):  
Chiau Yuan Lim ◽  
Mohd Faridzuan Majid ◽  
Sarrthesvaarni Rajasuriyan ◽  
Hayyiratul Fatimah Mohd Zaid ◽  
Khairulazhar Jumbri ◽  
...  
Keyword(s):  
Graphene Oxide ◽  
Choline Chloride ◽  
Deep Eutectic Solvent ◽  
Oxidative Desulfurization ◽  
Deep Eutectic Solvents ◽  
Tetraethylene Glycol ◽  
Catalytic Oxidative Desulfurization ◽  
The One ◽  
Model Oil

Extractive catalytic oxidative desulfurization (ECODS) is the one of the recent methods used in fuel desulfurization which involved the use of catalyst in the oxidative desulfurization of diesel fuel. This study is aimed to test the effectiveness of synthesized choline chloride (ChCl) based deep eutectic solvent (DES) in fuel desulfurization via ECODS method, with the presence of graphene oxide (GO) as catalyst and hydrogen peroxide (H2O2) as oxidant. In this study, 16 DESs based on choline chloride were synthesized using glycerol (GLY), ethylene glycol (EG), tetraethylene glycol (TEG) and polyethylene glycol (PEG). The characterization of the synthesized DES was carried out via Fourier transform infrared spectroscopy (FTIR) analysis, density, and viscosity determination. According to the screening result, ChCl-PEG (1:4) was found to be the most effective DES for desulfurization using ECODS method, with a removal of up to 47.4% of sulfur containing compounds in model oil in just 10 min per cycle after the optimization of the reaction parameters, and up to 95% desulfurization efficiency could be achieved by six cycles of desulfurization. It is found that the addition of GO as catalyst does not increase the desulfurization performance drastically; hence, future studies for the desulfurization performance of DESs made up from ChCl and PEG and its derivatives can be done simply by using extraction desulfurization (EDS) method instead of ECODS method, for cost reduction purpose and easier regulation of DES waste into environment.

Sign in / Sign up

Export Citation Format

Share Document