Experimental and Numerical Study of the Effect of Fuel/Air Mixing Modes on NOx and CO Emissions of MILD Combustion in a Boiler Burner

2020 ◽  
Author(s):  
Ziru Zhu ◽  
Yan Xiong ◽  
Xianglong Zheng ◽  
Weijie Chen ◽  
Baohe Ren ◽  
...  
Keyword(s):  
Numerical Study ◽  
Mild Combustion ◽  
Air Mixing ◽  
Boiler Burner

scholarly journals Numerical study of flame structure in the mild combustion regime

2015 ◽  
Vol 19 (1) ◽  
pp. 21-34 ◽  
Author(s):  
Amir Mardani ◽  
Sadegh Tabejamaat
Keyword(s):  
Fuel Injection ◽  
Numerical Study ◽  
Flame Structure ◽  
Combustion Regime ◽  
Low Oxygen ◽  
Mixing Rate ◽  
Jet Flame ◽  
Reduced Mechanism ◽  
Mild Combustion ◽  
O2 Concentration

In this paper, turbulent non-premixed CH4+H2 jet flame issuing into a hot and diluted co-flow air is studied numerically. This flame is under condition of the moderate or intense low-oxygen dilution (MILD) combustion regime and related to published experimental data. The modelling is carried out using the EDC model to describe turbulence-chemistry interaction. The DRM-22 reduced mechanism and the GRI2.11 full mechanism are used to represent the chemical reactions of H2/methane jet flame. The flame structure for various O2 levels and jet Reynolds numbers are investigated. The results show that the flame entrainment increases by a decrease in O2 concentration at air side or jet Reynolds number. Local extinction is seen in the upstream and close to the fuel injection nozzle at the shear layer. It leads to the higher flame entertainment in MILD regime. The turbulence kinetic energy decay at centre line of jet decreases by an increase in O2 concentration at hot Co-flow. Also, increase in jet Reynolds or O2 level increases the mixing rate and rate of reactions.

Analysis of the Mixing and Emission Characteristics in a Model Combustor

2018 ◽  
Author(s):  
Shan Li ◽  
Shanshan Zhang ◽  
Lingyun Hou ◽  
Zhuyin Ren
Keyword(s):  
Gas Turbines ◽  
Schmidt Number ◽  
Numerical Study ◽  
Flame Temperature ◽  
Scalar Dissipation ◽  
Mixing Process ◽  
Nox Formation ◽  
Turbulent Schmidt Number ◽  
Wide Range ◽  
Air Mixing

Modern gas turbines in power systems employ lean premixed combustion to lower flame temperature and thus achieve low NOx emissions. The fuel/air mixing process and its impacts on emissions are of paramount importance to combustor performance. In this study, the mixing process in a methane-fired model combustor was studied through an integrated experimental and numerical study. The experimental results show that at the dump location, the time-averaged fuel/air unmixedness is less than 10% over a wide range of testing conditions, demonstrating the good mixing performance of the specific premixer on the time-averaged level. A study of the effects of turbulent Schmidt number on the unmixedness prediction shows that for the complex flow field involved, it is challenging for Reynolds-Averaged Navier-Stokes (RANS) simulations with constant turbulent Schmidt number to accurately predict the mixing process throughout the combustor. Further analysis reveals that the production and scalar dissipation are the key physical processes controlling the fuel/air mixing. Finally, the NOx formation in this model combustor was analyzed and modelled through a flamelet-based approach, in which NOx formation is characterized through flame-front NOx and its post-flame formation rate obtained from one-dimensional laminar premixed flames. The effect of fuel/air unmixedness on NOx formation is accounted for through the presumed probability density functions (PDF) of mixture fraction. Results show that the measured NOx in the model combustor are bounded by the model predictions with the fuel/air unmixedness being 3% and 5% of the maximum unmixedness. In the context of RANS, the accuracy in NOx prediction depends on the unmixedness prediction which is sensitive to turbulent Schmidt number.

scholarly journals Numerical study of hydrogen mild combustion

2009 ◽  
Vol 13 (3) ◽  
pp. 59-67 ◽  
Author(s):  
Enrico Mollica ◽  
Eugenio Giacomazzi ◽  
Marco di
Keyword(s):  
Numerical Study ◽  
Fluid Dynamic ◽  
Thermal Gradients ◽  
Radiation Model ◽  
Dynamic Simulations ◽  
Mild Combustion ◽  
Preheating Temperature ◽  
Nitric Oxide Emissions ◽  
Gas Recirculation ◽  
Good Agreement

In this article a combustor burning hydrogen and air in mild regime is numerically studied by means of computational fluid dynamic simulations. All the numerical results show a good agreement with experimental data. It is seen that the flow configuration is characterized by strong exhaust gas recirculation with high air preheating temperature. As a consequence, the reaction zone is found to be characteristically broad and the temperature and concentrations fields are sufficiently homogeneous and uniform, leading to a strong abatement of nitric oxide emissions. It is also observed that the reduction of thermal gradients is achieved mainly through the extension of combustion in the whole volume of the combustion chamber, so that a flame front no longer exists ('flameless oxidation'). The effect of preheating, further dilution provided by inner recirculation and of radiation model for the present hydrogen/air mild burner are analyzed.

The promotion of ignition in a supersonic H2–air mixing layer by laser-induced excitation of O2 molecules: Numerical study

2009 ◽  
Vol 156 (8) ◽  
pp. 1641-1652 ◽  
Author(s):  
A.M. Starik ◽  
N.S. Titova ◽  
L.V. Bezgin ◽  
V.I. Kopchenov
Keyword(s):  
Numerical Study ◽  
Mixing Layer ◽  
Air Mixing

Numerical study on a novel burner designed to improve MILD combustion behaviors at the oxygen enriched condition

2019 ◽  
Vol 152 ◽  
pp. 686-696 ◽  
Author(s):  
Yihao Xie ◽  
Yaojie Tu ◽  
Hu Jin ◽  
Congcong Luan ◽  
Zean Wang ◽  
...  
Keyword(s):  
Numerical Study ◽  
Mild Combustion ◽  
Combustion Behaviors

Numerical study of H 2 O addition effects on pulverized coal oxy-MILD combustion

2015 ◽  
Vol 138 ◽  
pp. 252-262 ◽  
Author(s):  
Yaojie Tu ◽  
Hao Liu ◽  
Kai Su ◽  
Sheng Chen ◽  
Zhaohui Liu ◽  
...  
Keyword(s):  
Numerical Study ◽  
Pulverized Coal ◽  
Mild Combustion

Mixing Field Analysis of a Gas Turbine Burner

2002 ◽  
Author(s):  
Peter Flohr ◽  
Patrick Schmitt ◽  
Christian Oliver Paschereit
Keyword(s):  
Gas Turbine ◽  
Recirculation Zone ◽  
Numerical Study ◽  
Turbulence Models ◽  
Design Tool ◽  
Field Analysis ◽  
Mixing Process ◽  
Fuel Injector ◽  
Air Mixing ◽  
Gas Turbine Burner

An analytical and numerical study has been carried out with the view on the understanding of the physical mechanisms of the mixing process in a gas turbine burner. To this end, three methods at various levels of approximation have been used: At the simplest level an analytical model of the burner flow and the mixing process has been developed. It is demonstrated how this approach can be used to understand basic issues of the fuel-air mixing and how it can be applied as a design tool which guides the optimisation of a fuel injector device. At an intermediate level of approximation, steady-state CFD simulations, based on the k–ε- and RSM-turbulence models are used to describe the mixing process. All steady simulations fail to either predict the recirculation zone or the turbulence level correctly, and can therefore not be expected to capture the mixing correctly. At the most involved level of modelling time-accurate CFD based on unsteady RSM and LES-turbulence models are performed. The simulations show good agreement with experiments (and in the case of LES excellent agreement) for both, velocity and turbulence fields. Mixing predictions close to the fuel injectors suffer from a simplification used in the numerical setup, but the mixing field is predicted very well towards the exit of the burner. The contribution of the asymmetric coherent flow structure (which is associated with the internal recirculation zone) to the mixing process is quantified through a triple decomposition technique.

Sign in / Sign up

Export Citation Format

Share Document