In recent years, ultrafine-grained steel has been gaining increasing attention as a high-performance material. Accordingly, it is necessary to develop an efficient production method for ultrafine-grained steel. Severe plastic deformation is a critical factor that causes grain subdivision into ultrafine grains less than 1 µm in diameter. In this study, the effects of plastic deformation on the microstructure and static recrystallization of pure iron were studied by comparing orthogonal cutting and rolling. Orthogonal cutting yielded ultrafine grains with a diameter of 0.2 µm. It was found that a high strain rate in the thin shear plane generated during the cutting process caused a uniform subdivision of grains, and this uniform plastic deformation resulted in the uniform recrystallization of grains. In addition, a theoretical model was developed, and it was revealed that the number of recrystallized grains depended on the fraction of a large-misorientation area constructed with geometrically necessary boundaries (GNBs). It was suggested that the cutting process was more advantageous than rolling in producing ultrafine recrystallized grains because cutting could apply severe plastic strain uniformly on a work material, effectively generating GNBs.
Microstructural changes and formability of Al–Mg ultrafine-grained aluminum plates processed by multi-turn ECAP and upsetting
