Experimental Study on Thermal Conductivity of Concrete Using Ferronickel Slag Powder

2019 ◽  
Vol 24 (1) ◽  
pp. 219-227 ◽  
Author(s):  
Chang-Hong Lee ◽  
Sang-Chel Kim ◽  
Young-Jin Kim ◽  
Seong-Kyum Kim ◽  
Jun-Pil Hwang ◽  
...  
Keyword(s):  
Thermal Conductivity ◽  
Experimental Study ◽  
Slag Powder ◽  
Ferronickel Slag

scholarly journals An experimental study of the motion of ice past obstacles by the process of regelation

1976 ◽  
Vol 17 (75) ◽  
pp. 79-98 ◽  
Author(s):  
E. M. Morris
Keyword(s):  
Thermal Conductivity ◽  
Experimental Study ◽  
Cross Sections ◽  
Transition Point ◽  
Water Layer ◽  
Single Object ◽  
Two Systems ◽  
Basal Sliding

AbstractThe results of regelation experiments, in which a single object is pulled through ice, cannot be applied directly to the problem of basal sliding in glaciers because the two systems have different geometries. When the force applied to a single object is small, impurities trapped in the regelation water-layer around the object inhibit the regelation process. At larger forces, above the Drake-Shreve transition point, impurities are shed in a trace behind the object. However, when ice moves over a series of obstacles a trace may exist above and below the transition point. The regelation velocity below the transition point is not reduced by the effect of trapped impurities. In an experiment in which brass cylingerrs of various cross-sections rotate in ice, the ratio between the expected regelation velocity, calculated using the basal-sliding theory of Nye, and the measured regelation velocity is 8±2, both above and below the transition point. The same ratio has been obtained by other workers with wires of similar thermal conductivity above the transition point. Measurements of température differences indicate that supercooling cannot be the main source of the unexpectedly low regelation velocities above the transition point.

scholarly journals Effect of Fly Ash on Compressive Strength, Drying Shrinkage, and Carbonation Depth of Mortar with Ferronickel-Slag Powder

2021 ◽  
Vol 11 (3) ◽  
pp. 1037
Author(s):  
Se-Jin Choi ◽  
Ji-Hwan Kim ◽  
Sung-Ho Bae ◽  
Tae-Gue Oh
Keyword(s):  
Compressive Strength ◽  
Fly Ash ◽  
Construction Industry ◽  
Bituminous Coal ◽  
Raw Materials ◽  
Drying Shrinkage ◽  
The Other ◽  
Test Results ◽  
Slag Powder ◽  
Ferronickel Slag

In recent years, efforts to reduce greenhouse gas emissions have continued worldwide. In the construction industry, a large amount of CO2 is generated during the production of Portland cement, and various studies are being conducted to reduce the amount of cement and enable the use of cement substitutes. Ferronickel slag is a by-product generated by melting materials such as nickel ore and bituminous coal, which are used as raw materials to produce ferronickel at high temperatures. In this study, we investigated the fluidity, microhydration heat, compressive strength, drying shrinkage, and carbonation characteristics of a ternary cement mortar including ferronickel-slag powder and fly ash. According to the test results, the microhydration heat of the FA20FN00 sample was slightly higher than that of the FA00FN20 sample. The 28-day compressive strength of the FA20FN00 mix was approximately 39.6 MPa, which was higher than that of the other samples, whereas the compressive strength of the FA05FN15 mix including 15% of ferronickel-slag powder was approximately 11.6% lower than that of the FA20FN00 mix. The drying shrinkage of the FA20FN00 sample without ferronickel-slag powder was the highest after 56 days, whereas the FA00FN20 sample without fly ash showed the lowest shrinkage compared to the other mixes.

Sign in / Sign up

Export Citation Format

Share Document