Evapotranspiration Estimation Using Surface Energy Balance-Based Evaporative Fraction for Water Management in Canal Irrigation Command

2021 ◽  
Author(s):  
H. V. Parmar ◽  
N. K. Gontia
Keyword(s):  
Water Management ◽  
Energy Balance ◽  
Surface Energy ◽  
Surface Energy Balance ◽  
Evaporative Fraction ◽  
Canal Irrigation ◽  
Evapotranspiration Estimation

scholarly journals The Surface Energy Balance System (SEBS) for estimation of turbulent heat fluxes

2002 ◽  
Vol 6 (1) ◽  
pp. 85-100 ◽  
Author(s):  
Z. Su
Keyword(s):  
Energy Balance ◽  
Surface Energy ◽  
Surface Energy Balance ◽  
Heat Fluxes ◽  
Physical Parameters ◽  
Turbulent Heat ◽  
Evaporative Fraction ◽  
Balance System ◽  
Turbulent Heat Fluxes

Abstract. A Surface Energy Balance System (SEBS) is proposed for the estimation of atmospheric turbulent fluxes and evaporative fraction using satellite earth observation data, in combination with meteorological information at proper scales. SEBS consists of: a set of tools for the determination of the land surface physical parameters, such as albedo, emissivity, temperature, vegetation coverage etc., from spectral reflectance and radiance measurements; a model for the determination of the roughness length for heat transfer; and a new formulation for the determination of the evaporative fraction on the basis of energy balance at limiting cases. Four experimental data sets are used to assess the reliabilities of SEBS. Based on these case studies, SEBS has proven to be capable to estimate turbulent heat fluxes and evaporative fraction at various scales with acceptable accuracy. The uncertainties in the estimated heat fluxes are comparable to in-situ measurement uncertainties. Keywords: Surface energy balance, turbulent heat flux, evaporation, remote sensing

Evaluation of the evaporative fraction for parameterization of the surface energy balance

1993 ◽  
Vol 29 (11) ◽  
pp. 3681-3690 ◽  
Author(s):  
William E. Nichols ◽  
Richard H. Cuenca
Keyword(s):  
Energy Balance ◽  
Surface Energy ◽  
Surface Energy Balance ◽  
Evaporative Fraction

scholarly journals Daily Actual Evapotranspiration Estimation in a Mediterranean Ecosystem from Landsat Observations Using SEBAL Approach

Forests ◽  
2021 ◽  
Vol 12 (2) ◽  
pp. 189
Author(s):  
Hassan Awada ◽  
Simone Di Prima ◽  
Costantino Sirca ◽  
Filippo Giadrossich ◽  
Serena Marras ◽  
...  
Keyword(s):  
Energy Balance ◽  
Surface Energy ◽  
Surface Energy Balance ◽  
Actual Evapotranspiration ◽  
Shortwave Radiation ◽  
Balance Model ◽  
Mediterranean Ecosystem ◽  
Acquisition Time ◽  
Natural Ecosystem ◽  
Evaporative Fraction

Quantifying actual evapotranspiration (ETa) over natural vegetation is crucial in evaluating the water status of ecosystems and the water-use patterns in local or regional hydrological basins. Remote sensing-based surface energy balance models have been used extensively for estimating ETa in agro-environments; however, the application of these models to natural ecosystems is still limited. The surface energy balance algorithm for land (SEBAL) physical-based surface energy balance model was applied to estimate the actual evapotranspiration over a heterogeneous coverage of Mediterranean maquis in a natural reserve in Sardinia, Italy. The model was applied on 19 Landsat 5 and 8 images from 2009 to 2014, and the results were compared to the data of a micrometeorological station with eddy covariance flux measurements. Comparing the SEBAL-based evaporative fraction (ΛS) to the corresponding tower-derived evaporative fractions (ΛT) showed good flux estimations in the Landsat overpass time (Coefficient of determination R2 = 0.77, root mean square error RMSE = 0.05 and mean absolute error MAE = 0.076). Three methods were evaluated for upscaling instantaneous latent heat flux (λE) to daily actual evapotranspiration (ETa,D). The upscaling methods use the evaporative fraction (Λ), the reference evapotranspiration fraction (EFr) and the ratio of daily to instantaneous incoming shortwave radiation (Rs24/Rsi) as upscaling factors under the hypothesis of diurnal self-preservation. A preliminary analysis performed using only in-situ measured data demonstrated that the three factors were relatively self-preserved during the daytime, and can yield good ETa,D estimations, particularly when obtained at near the Landsat scene acquisition time (≈10:00 UTC). The upscaling factors obtained from SEBAL retrieved instantaneous fluxes, and some ancillary measured meteorological data were used to upscale SEBAL-estimated instantaneous actual λ to daily ET. The Λ EFr and Rs24/Rsi methods on average overestimated the measured ETa,D by nearly 20, 61 and 18%, respectively. The performance of the Λ and Rs24/Rsi methods was considered satisfactory, bearing in mind the high variable ground cover and the inherent variability of the biome composition, which cannot be properly represented in the Landsat moderate spatial resolution. In this study, we tested the potential of the SEBAL model application in a complex natural ecosystem. This modeling approach will be used to represent the spatial dynamics of ET, which will be integrated into further environmental and hydrological applications.

scholarly journals Using climate reanalysis data in conjunction with multi-temporal satellite thermal imagery to derive supraglacial debris thickness changes from energy-balance modelling

2021 ◽  
pp. 1-19
Author(s):  
Rebecca L. Stewart ◽  
Matthew Westoby ◽  
Francesca Pellicciotti ◽  
Ann Rowan ◽  
Darrel Swift ◽  
...  
Keyword(s):  
Energy Balance ◽  
Surface Energy ◽  
Surface Energy Balance ◽  
Current Knowledge ◽  
Meteorological Data ◽  
Reanalysis Data ◽  
Balance Model ◽  
Thermal Imagery ◽  
Thickness Estimation ◽  
Miage Glacier

Abstract Surface energy-balance models are commonly used in conjunction with satellite thermal imagery to estimate supraglacial debris thickness. Removing the need for local meteorological data in the debris thickness estimation workflow could improve the versatility and spatiotemporal application of debris thickness estimation. We evaluate the use of regional reanalysis data to derive debris thickness for two mountain glaciers using a surface energy-balance model. Results forced using ERA-5 agree with AWS-derived estimates to within 0.01 ± 0.05 m for Miage Glacier, Italy, and 0.01 ± 0.02 m for Khumbu Glacier, Nepal. ERA-5 data were then used to estimate spatiotemporal changes in debris thickness over a ~20-year period for Miage Glacier, Khumbu Glacier and Haut Glacier d'Arolla, Switzerland. We observe significant increases in debris thickness at the terminus for Haut Glacier d'Arolla and at the margins of the expanding debris cover at all glaciers. While simulated debris thickness was underestimated compared to point measurements in areas of thick debris, our approach can reconstruct glacier-scale debris thickness distribution and its temporal evolution over multiple decades. We find significant changes in debris thickness over areas of thin debris, areas susceptible to high ablation rates, where current knowledge of debris evolution is limited.

Sign in / Sign up

Export Citation Format

Share Document