scholarly journals Comprehensive investigation of low salinity waterflooding in carbonate reservoirs

Author(s):  
M. Fouad Snosy ◽  
Mahmoud Abu El Ela ◽  
Ahmed El-Banbi ◽  
Helmy Sayyouh

AbstractWaterflooding has been practiced as a secondary recovery mechanism for many years with no regard to the composition of the injected brine. However, in the last decade, there has been an interest to understand the impact of the injected water composition and the low salinity waterflooding (LSWF) in oil recovery. LSWF has been investigated through various laboratory tests as a promising method for improving oil recovery in carbonate reservoirs. These experiments showed diverse mechanisms and results. In this study, a comprehensive review and analysis for results of more than 300 carbonate core flood experiments from published work were performed to investigate the effects of several parameters (injected water, oil, and rock properties along with the temperature) on oil recovery from carbonate rock. The analysis of the results showed that the water composition is the key parameter for successful waterflooding (WF) projects in the carbonate rocks. However, the salinity value of the injected water seems to have a negligible effect on oil recovery in both secondary and tertiary recovery stages. The study indicated that waterflooding with optimum water composition can improve oil recovery up to 30% of the original oil in place. In addition, the investigation showed that changing water salinity from LSWF to high salinity waterflooding can lead to an incremental oil recovery of up to 18% in the tertiary recovery stage. It was evident that applying the optimum composition in the secondary recovery stage is more effective than applying it in the tertiary recovery stage. Furthermore, the key parameters of the injected water and rock properties in secondary and tertiary recovery stages were studied using Fractional Factorial Design. The results revealed that the concentrations of Mg2+, Na+, K+, and Cl− in the injected water are the greatest influence parameters in the secondary recovery stage. However, the most dominant parameters in the tertiary recovery stage are the rock minerals and the concentration of K+, HCO3−, and SO42− in the injected water. In addition, it appears that the anhydrite percentage in the carbonate reservoirs may be an effective parameter in the tertiary WF. Also, there are no clear relations between the incremental oil recovery and the oil properties (total acid number or total base number) in both secondary and tertiary recovery stages. In addition, the results of the analysis showed an incremental oil recovery in all ranges of the studied flooding temperatures. The findings of this study can help to establish guidelines for screening and designing optimum salinity and composition for WF projects in carbonate reservoirs.

SPE Journal ◽  
2021 ◽  
pp. 1-17
Author(s):  
Yue Shi ◽  
Chammi Miller ◽  
Kishore Mohanty

Summary Carbonate reservoirs tend to be oil-wet/mixed-wet and heterogeneous because of mineralogy and diagenesis. The objective of this study is to improve oil recovery in low-temperature dolomite reservoirs using low-salinity and surfactant-aided spontaneous imbibition. The low-salinity brine composition was optimized using ζ-potential measurements, contact-angle (CA) experiments, and a novel wettability-alteration measure. Significant wettability alteration was observed on dolomite rocks at a salinity of 2,500 ppm. We evaluated 37 surfactants by performing CA, interfacial-tension (IFT), and spontaneous-imbibition experiments. Three (quaternary ammonium) cationic and one (sulfonate) anionic surfactants showed significant wettability alteration and produced 43–63% of original oil in place (OOIP) by spontaneous imbibition. At a low temperature (35°C), oil recovery by low-salinity effect is small compared with that by wettability-altering surfactants. Coreflood tests were performed with a selected low-salinity cationic surfactant solution. A novel coreflood was proposed that modeled heterogeneity and dynamic imbibition into low-permeability regions. The results of the “heterogeneous” coreflood were consistent with that of spontaneous-imbibition tests. These experiments demonstrated that a combination of low-salinity brine and surfactants can make originally oil-wet dolomite rocks more water-wet and improve oil recovery from regions bypassed by waterflood at a low temperature of 35°C.


SPE Journal ◽  
2016 ◽  
Vol 21 (05) ◽  
pp. 1643-1654 ◽  
Author(s):  
Ramez A. Nasralla ◽  
Ekaterina Sergienko ◽  
Shehadeh K. Masalmeh ◽  
Hilbert A. van der Linde ◽  
Niels J. Brussee ◽  
...  

Summary Low-salinity waterflood (LSF) is a promising improved-oil-recovery (IOR) technology. Although, it was demonstrated that LSF is an efficient IOR method for many sandstone reservoirs, the potential of LSF in carbonate reservoirs is still not well-established because only a limited number of successful coreflood experiments are available in the literature. Therefore, the aim of this study was to examine the oil-recovery improvement by LSF in carbonate reservoirs by performing coreflood experiments. This paper proposes an experimental approach to qualitatively evaluate the potential of LSF to improve oil recovery and alter the rock wettability during coreflood experiments. The corefloods were conducted on core plugs from two Middle Eastern carbonate reservoirs with a wide variation of rock properties and reservoir conditions. Seawater (SW) and several dilutions of formation brine and SW were flooded in the tertiary mode to evaluate their impacts on oil recovery compared with formation-brine injection. In addition, a geochemical study was performed with PHREEQC software (Parkhurst and Appelo 1999) to assess the potential of calcite dissolution by LSF. The experimental results confirmed that lowering the water salinity can alter the rock wettability toward more water-wet, causing improvement of oil recovery in tertiary waterflood in plugs from the two reservoirs. Furthermore, SW is more-favorable for improved oil recovery than formation brine because injection of SW after formation brine resulted in extra oil production. This demonstrates that the brine composition plays an important role during waterflooding in carbonate reservoirs, and not only the brine salinity. It was also observed that oil recovery can be improved by injection of brines that cannot dissolve calcite on the basis of the geochemical modeling study. This implies that calcite dissolution is not the dominant mechanism of IOR by LSF. To conclude, this paper demonstrates that LSF has a good potential as an IOR technology in carbonate reservoirs. In addition, the proposed experimental approach ensures the verification of LSF effect, either it is positive or negative. However, further research is required to explore the optimum salinity and composition and the most-influential parameters affecting LSF response.


2014 ◽  
Vol 17 (03) ◽  
pp. 304-313 ◽  
Author(s):  
A.M.. M. Shehata ◽  
M.B.. B. Alotaibi ◽  
H.A.. A. Nasr-El-Din

Summary Waterflooding has been used for decades as a secondary oil-recovery mode to support oil-reservoir pressure and to drive oil into producing wells. Recently, the tuning of the salinity of the injected water in sandstone reservoirs was used to enhance oil recovery at different injection modes. Several possible low-salinity-waterflooding mechanisms in sandstone formations were studied. Also, modified seawater was tested in chalk reservoirs as a tertiary recovery mode and consequently reduced the residual oil saturation (ROS). In carbonate formations, the effect of the ionic strength of the injected brine on oil recovery has remained questionable. In this paper, coreflood studies were conducted on Indiana limestone rock samples at 195°F. The main objective of this study was to investigate the impact of the salinity of the injected brine on the oil recovery during secondary and tertiary recovery modes. Various brines were tested including deionized water, shallow-aquifer water, seawater, and as diluted seawater. Also, ions (Na+, Ca2+, Mg2+, and SO42−) were particularly excluded from seawater to determine their individual impact on fluid/rock interactions and hence on oil recovery. Oil recovery, pressure drop across the core, and core-effluent samples were analyzed for each coreflood experiment. The oil recovery using seawater, as in the secondary recovery mode, was, on the average, 50% of original oil in place (OOIP). A sudden change in the salinity of the injected brine from seawater in the secondary recovery mode to deionized water in the tertiary mode or vice versa had a significant effect on the oil-production performance. A solution of 20% diluted seawater did not reduce the ROS in the tertiary recovery mode after the injection of seawater as a secondary recovery mode for the Indiana limestone reservoir. On the other hand, 50% diluted seawater showed a slight change in the oil production after the injection of seawater and deionized water slugs. The Ca2+, Mg2+, and SO42− ions play a key role in oil mobilization in limestone rocks. Changing the ion composition of the injected brine between the different slugs of secondary and tertiary recovery modes showed a measurable increase in the oil production.


AAPG Bulletin ◽  
2017 ◽  
Vol 101 (01) ◽  
pp. 1-18 ◽  
Author(s):  
Mark Person ◽  
John L. Wilson ◽  
Norman Morrow ◽  
Vincent E.A. Post

SPE Journal ◽  
2017 ◽  
Vol 23 (01) ◽  
pp. 84-101 ◽  
Author(s):  
Maxim P. Yutkin ◽  
Himanshu Mishra ◽  
Tadeusz W. Patzek ◽  
John Lee ◽  
Clayton J. Radke

Summary Low-salinity waterflooding (LSW) is ineffective when reservoir rock is strongly water-wet or when crude oil is not asphaltenic. Success of LSW relies heavily on the ability of injected brine to alter surface chemistry of reservoir crude-oil brine/rock (COBR) interfaces. Implementation of LSW in carbonate reservoirs is especially challenging because of high reservoir-brine salinity and, more importantly, because of high reactivity of the rock minerals. Both features complicate understanding of the COBR surface chemistries pertinent to successful LSW. Here, we tackle the complex physicochemical processes in chemically active carbonates flooded with diluted brine that is saturated with atmospheric carbon dioxide (CO2) and possibly supplemented with additional ionic species, such as sulfates or phosphates. When waterflooding carbonate reservoirs, rock equilibrates with the injected brine over short distances. Injected-brine ion speciation is shifted substantially in the presence of reactive carbonate rock. Our new calculations demonstrate that rock-equilibrated aqueous pH is slightly alkaline quite independent of injected-brine pH. We establish, for the first time, that CO2 content of a carbonate reservoir, originating from CO2-rich crude oil and gas, plays a dominant role in setting aqueous pH and rock-surface speciation. A simple ion-complexing model predicts the calcite-surface charge as a function of composition of reservoir brine. The surface charge of calcite may be positive or negative, depending on speciation of reservoir brine in contact with the calcite. There is no single point of zero charge; all dissolved aqueous species are charge determining. Rock-equilibrated aqueous composition controls the calcite-surface ion-exchange behavior, not the injected-brine composition. At high ionic strength, the electrical double layer collapses and is no longer diffuse. All surface charges are located directly in the inner and outer Helmholtz planes. Our evaluation of calcite bulk and surface equilibria draws several important inferences about the proposed LSW oil-recovery mechanisms. Diffuse double-layer expansion (DLE) is impossible for brine ionic strength greater than 0.1 molar. Because of rapid rock/brine equilibration, the dissolution mechanism for releasing adhered oil is eliminated. Also, fines mobilization and concomitant oil release cannot occur because there are few loose fines and clays in a majority of carbonates. LSW cannot be a low-interfacial-tension alkaline flood because carbonate dissolution exhausts all injected base near the wellbore and lowers pH to that set by the rock and by formation CO2. In spite of diffuse double-layer collapse in carbonate reservoirs, surface ion-exchange oil release remains feasible, but unproved.


Sign in / Sign up

Export Citation Format

Share Document