Electrocatalytic properties of ultrafine platinum particles for oxidation of methanol and formic acid in aqueous solutions

1991 ◽  
Vol 36 (5-6) ◽  
pp. 973-978 ◽  
Author(s):  
Kiyochika Yahikozawa ◽  
Yuichi Fujii ◽  
Yoshiharu Matsuda ◽  
Katsunori Nishimura ◽  
Yoshio Takasu
1999 ◽  
Vol 44 (12) ◽  
pp. 2131-2137 ◽  
Author(s):  
Pawel J Kulesza ◽  
Monika Matczak ◽  
Anna Wolkiewicz ◽  
Bozena Grzybowska ◽  
Mariusz Galkowski ◽  
...  

Catalysts ◽  
2019 ◽  
Vol 9 (10) ◽  
pp. 856 ◽  
Author(s):  
Lubna Yaqoob ◽  
Tayyaba Noor ◽  
Naseem Iqbal ◽  
Habib Nasir ◽  
Neelam Zaman

In this study, electrochemical oxidation of methanol to formic acid using the economical and highly active catalytic Nickel Benzene tricarboxylic acid metal organic framework (Ni-BTC-MOF) and reduced graphene oxide (rGO) nanocomposites modified glassy carbon electrode GCE in alkaline media, which was examined via cyclic voltammetry technique. Nickel based MOF and rGO nanocomposites were prepared by solvothermal approach, followed by morphological and structural characterization of prepared samples through X-ray diffraction (XRD), scanning electron microscopy (SEM), Fourier Transform Infrared Spectroscopy (FTIR), and energy dispersive X-ray (EDX) analysis. The electrochemical testing of synthesized materials represents the effect of the sequential increase in rGO concentration on electrocatalytic activity. The Ni-BTC/4 wt % rGO composite with a pronounced current density of 200.22 mA/cm2 at 0.69 V versus Hg/HgO electrode at 50 mV/s was found to be a potential candidate for methanol oxidation in Direct Methanol Fuel Cell (DMFC) applications. Product analysis was carried out through Gas Chromatography (GC) and Nuclear Magnetic Resonance (NMR) spectroscopy, which confirmed the formation of formic acid during the oxidation process, with approximately 62% yield.


2018 ◽  
Vol 47 (42) ◽  
pp. 15131-15140 ◽  
Author(s):  
Liu Lin ◽  
Mengwei Yuan ◽  
Zemin Sun ◽  
Huifeng Li ◽  
Caiyun Nan ◽  
...  

One-pot strategy to in-suit anchor NiPt nanocrystals on the graphene substrates which show outstanding bifunctional electrocatalytic properties in DMFC and DFAFC.


1948 ◽  
Vol 39 (3) ◽  
pp. 359-383 ◽  
Author(s):  
J. W. L. Beament

The unspecialised portion of the shell and the cap of Rhodnius eggs are impermeable to almost all hydrophilic and lipophilic liquids. If water and very small ions pass through the chorion they must traverse a wax layer on the inside of the shell. Certain corrosive materials, e.g., glacial formic acid, may pass through the shell slowly.These conclusions, based on experiments with pieces of shell, have been confirmed in ovicidal experiments. A range of materials with widely differing properties enter the embryo only through the micropyles, of which there are approximately fifteen in the rim of each shell. At least one micropyle must be traversed to kill an egg but many eggs were killed when only one had been penetrated.A cement, applied by the female at oviposition, may occlude the outer orifice of a micropyle. The properties of the cement are described; it appears to be a tanned protein. Cement deposits are much more copious on the eggs laid by younger females. Such eggs are more resistant to ovicides because penetration is delayed. This increased resistance is more pronounced when oleophilic liquids are used owing to the rapidity with which they kill eggs from older females. The random distribution of cement is one cause of the variability of replicates in ovicidal tests.A detailed investigation has been made of factors governing liquids traversing the micropyles. Hydrophilic liquids invade the outer lipophilic part of the micropyle slowly; the displacement of air is the most important factor and small changes in the wetting power of the liquid make little difference to the rate of entry.Aqueous liquids aie absorbed into the protein lining of the inner portion of the micropyle. They reach the wax layer on the inside of the shell by migrating into and through the inner protein layer. The area which is invaded increases linearly with time. Mortality, therefore, increases as the square of the time of immersion, but it is proportional to the increase in concentration of a solute if the period of immersion is constant.Oleophilic liquids wet the micropyle actively. They may by-pass air and flow rapidly to the wax at the inner end of the tube. Wax solvents kill very quickly and are much more toxic than other lipophiles.Water in the micropyle and shell may affect the entrance of either type of liquid. In general it increases the toxicity of aqueous solutions and retards the entry of oils.Wax-emulsifying materials added to aqueous solutions do not produce great increases in toxicity. They are “filtered out” at the protein lining of the micropyle and do not reach the wax layer for a considerable period of time.


RSC Advances ◽  
2015 ◽  
Vol 5 (1) ◽  
pp. 650-653 ◽  
Author(s):  
Ruigang Xie ◽  
Muzi Chen ◽  
Jiaqing Wang ◽  
Sujuan Mei ◽  
Yue Pan ◽  
...  

Au–Pt bimetallic nanocomplexes were synthesized and the composition and morphology of the nanocomplexes could be easily controlled by a facile synthesis method.


2013 ◽  
Vol 225 ◽  
pp. 323-329 ◽  
Author(s):  
Erwan Bertin ◽  
Sébastien Garbarino ◽  
Daniel Guay ◽  
José Solla-Gullón ◽  
Francisco J. Vidal-Iglesias ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document