The Penetration of the Insect Egg-shells. I.—Penetration of the Chorion of Rhodnius prolixus, Stål

1948 ◽  
Vol 39 (3) ◽  
pp. 359-383 ◽  
Author(s):  
J. W. L. Beament

The unspecialised portion of the shell and the cap of Rhodnius eggs are impermeable to almost all hydrophilic and lipophilic liquids. If water and very small ions pass through the chorion they must traverse a wax layer on the inside of the shell. Certain corrosive materials, e.g., glacial formic acid, may pass through the shell slowly.These conclusions, based on experiments with pieces of shell, have been confirmed in ovicidal experiments. A range of materials with widely differing properties enter the embryo only through the micropyles, of which there are approximately fifteen in the rim of each shell. At least one micropyle must be traversed to kill an egg but many eggs were killed when only one had been penetrated.A cement, applied by the female at oviposition, may occlude the outer orifice of a micropyle. The properties of the cement are described; it appears to be a tanned protein. Cement deposits are much more copious on the eggs laid by younger females. Such eggs are more resistant to ovicides because penetration is delayed. This increased resistance is more pronounced when oleophilic liquids are used owing to the rapidity with which they kill eggs from older females. The random distribution of cement is one cause of the variability of replicates in ovicidal tests.A detailed investigation has been made of factors governing liquids traversing the micropyles. Hydrophilic liquids invade the outer lipophilic part of the micropyle slowly; the displacement of air is the most important factor and small changes in the wetting power of the liquid make little difference to the rate of entry.Aqueous liquids aie absorbed into the protein lining of the inner portion of the micropyle. They reach the wax layer on the inside of the shell by migrating into and through the inner protein layer. The area which is invaded increases linearly with time. Mortality, therefore, increases as the square of the time of immersion, but it is proportional to the increase in concentration of a solute if the period of immersion is constant.Oleophilic liquids wet the micropyle actively. They may by-pass air and flow rapidly to the wax at the inner end of the tube. Wax solvents kill very quickly and are much more toxic than other lipophiles.Water in the micropyle and shell may affect the entrance of either type of liquid. In general it increases the toxicity of aqueous solutions and retards the entry of oils.Wax-emulsifying materials added to aqueous solutions do not produce great increases in toxicity. They are “filtered out” at the protein lining of the micropyle and do not reach the wax layer for a considerable period of time.

During the last two or three years considerable attention has been given to the growth of single crystals of bismuth and to their physical properties. The result of this work has shown that the preparation of a good single crystal is exceedingly difficult, the process being easily disturbed in many ways, and the conclusion must be drawn that it has not yet been possible to obtain anything approaching a perfect crystal. In all cases where the grown crystal has been adequately examined, it has been necessary to admit that the supposed single crystal was full of discontinuities. This was shown by Kapitza* in his work on the growth and magneto­-resistance change of single crystals of bismuth. He found it very difficult to produce a crystal rod parallel to the hexagonal axis that was flexible. Almost all the crystals grown with this orientation were apparently brittle in that a very little strain would cause a sharp fracture parallel to the principal cleavage plane. Some crystals indeed broke up into small pieces 2 or 3 mm. long when dropped from a height of a few centimetres on a table. As the separate pieces proved to be fairly flexible this brittleness is not a real property of the crystal, but appears to be due to isolated cracks or discontinuities in the crystal (the word “crack” is used with the meaning defined by Kapitza in his paper, where further arguments for their existence from X-ray and resistance measurements are given). These cracks are not characteristic only of the brittle crystals, but appear to be present in many flexible crystals as well, their flexibility being due to a random distribution of a comparatively large number of cracks small in area compared to the dimensions of the rod.


2021 ◽  
Vol 201 (3) ◽  
pp. 547-560
Author(s):  
D. N. Yuriev ◽  
G. V. Zhukovskaya

Research and commercial trawl catches of humpback shrimp Pandalus hypsinotus from the Tatar Strait (Japan Sea) in 2004–2020 were investigated, with bioanalysis of about 45 thousand specimens. Average timing of group molting, spawning, and eggs laying are determined, terms of gonads and eggs development are estimated. Prespawning and molting of the females occur between January-April, with the peaks in early February and middle February, respectively. All oviparous females have 30–40 days to lay eggs, and molt during 50–55 days; the peak of the eggs laying occurs in late June. The males molt in July-August, afterwards the largest individuals change gender and new intersexes are formed. The males have the second molting in October-December, with the peak in late November. In January, after finish of the males molting, a new annual reproduction cycle starts from the prespawning molting of females. Both vitellogenesis and embryogenesis are observed through the year, though females with developing gonads prevail from August to January (because of a long time span between winter and summer moltings while the egg carrying continued 15 months) but oviparous females — from February to July. The individual reproductive cycle of Pandalus hypsinotus in the Tatar Strait lasts 24 months, with 9 months of vitellogenesis (quick growth of gonads) and 15 months of embryogenesis. During the 2-year reproductive cycle, most of females pass through the following stages: i) gonads development (just after eggs laying) when almost all oviparous females (up to 95 % in May) have green gonads under carapace that corresponds to the stage of development «eggs laid — gonads weakly developed»; ii) summer molting from August when females lose hairs on pleopods and the gonads growth accelerates; iii) respawning in January-March (together with the firstly spawning intersexes, with slight delay of the latter); iv) initial developing of eggs during summer; v) stage of «eyed eggs» from December to March; and vi) eggs laying and molting from late March to late May; then the 2-year reproductive cycle repeats.


2010 ◽  
Vol 2 (5) ◽  
pp. 103-108 ◽  
Author(s):  
Vaida Šerevičienė ◽  
Vaida Valuntaitė ◽  
Dainius Paliulis

The method of applying passive diffusive samplers for research on air quality is simple, easy enough and requires no electricity. The operating principle of almost all passive samplers is based on chemical reactions taking place on absorbent (impregnated filter or grid). The pollutant absorption mechanism is based on passive diffusion through the gas diffusion layer to absorbent. The diffusion process can be explained by first Fick’s law described as a free movement of gases from the ambient air to a passive sampler. This movement depends on pollutant gradient. The aim of this paper is to analyse the influence of an impregnating solution on the efficiency of diffusive samplers. The object of the study covers the triethanolamine (TEA) aqueous solutions of 5%, 10%, 20%, 30% and 50%. The results obtained showed that 30% and 50% aqueous solution gave 68% and 89% relative error making the true meaning of the oxides of nitrogen analyzer testimony. Data on the passive samplers impregnated with TEA aqueous solutions having concentrations of 5%, 10% and 20% are within definite 25% uncertainty established by the European Union Directives.


10.5219/1062 ◽  
2019 ◽  
Vol 13 (1) ◽  
pp. 344-350 ◽  
Author(s):  
Pavel Diviš ◽  
Jaromír Pořízka ◽  
Jakub Kříkala

Drinking coffee has become part of our everyday culture. Coffee cultivation is devoted to over 50 countries in the world, located between latitudes 25 degrees North and 30 degrees South. Almost all of the world's coffee production is provided by two varieties, called ‘Arabica’ and ‘Robusta’ whereas the share of Arabica is 70% of the world's coffee harvest. Green (raw) coffee can not be used to prepare coffee beverages, coffee beans must first be roasted. Roasting coffee and reaching a certain degree of coffee roasting determine its flavor and aroma characteristics. In the present study the fate of sucrose, chlorogenic acid, acetic acid, formic acid, lactic acid, caffeic acid, total phenolic compounds and 5-hydroxymethylfurfural was studied in coffee (Brazil Cerrado Dulce, 100% Arabica) roasted in two ways (Medium roast and Full city roast). It has been found that almost all sucrose has been degraded (96 – 98%) in both roasting ways. During Medium roast 65% of chlorogenic acid contained in green coffee was degraded while during Full city roast it was 85%. During both Medium and Full city roasting, the formation of acetic acid but especially formic and lactic acid was recorded. The highest concentration of organic acids was recorded at Full City roasting at medium roasting times (3.3 mg.g-1 d.w. acetic acid, 1.79 mg.g-1 d.w. formic  acid, 0.65 mg.g-1d.w. lactic acid). The amount of phenolic substances also increased during roasting up to 16.7 mg.g-1 d.w. of gallic acid equivalent. Highest concentrations of 5-hydroxymethylfurfural were measured at medium roasting times at both Medium (0.357 mg.g-1 d.w.) and French city (0.597 mg.g-1 d.w.) roasting temperatures. At the end of roasting, the 5-hydroxymethylfurfural concentration in coffee were 0.237 mg.g-1 d.w. (Medium roast) and 0.095 mg.g-1 d.w. (Full city roast).


Author(s):  
Sergey Nogin ◽  
Jânio Monteiro ◽  
Sergio Gómez Melgar ◽  
José Peyroteo ◽  
António Mortal ◽  
...  

Tourists today are more likely to be concerned with the environment and greener lifestyle choices. In this context, a green flagship of some hotels can be an important selection criteria at the time of selecting one. In the near future, buildings should become nearly zero energy, consuming as low as possible and producing almost all the energy they need, using renewable energy sources. To achieve this goal, hotel buildings need to pass through a transformation process that will make them more efficient. In this process, a decision support platform would be important to help hoteliers monitor their energy consumption, identify which points are consuming more than expected, decide which investments are more cost effective and manage their equipment in an optimum way. This chapter describes the challenges involved in developing such a platform, covering several research and development fields, including Internet of Things networks, ICT, Smart Grids, Renewable Energy, Energy efficiency, as well as algorithms for machine learning and optimization.


1978 ◽  
Vol 1 (16) ◽  
pp. 30 ◽  
Author(s):  
D.H. Peregrine ◽  
I.A. Svendsen

On gently sloping beaches, almost all water waves break. After the initial breaking the water motion usually appears quite chaotic. However, for a moderate time, for example two or three times the descent time of the "plunge" in a plunging breaker, the flow can be relatively well organised despite the superficial view which is largely of spray and bubbles. If waves continue to break the breaking motion, or "white water" soon becomes fully turbulent and the mean motions become quasisteady. A reasonable definition of a quasi-steady wave is one which changes little during the time a water particle takes to pass through it. We exclude water particles which may become trapped in a surface roller and surf along with the wave. At this stage in its development a wave on a beach may be described as a spilling breaker or as a bore. In fact, there is a range of these waves from those with a little white water at the crest to examples where the whole front of the wave is fully turbulent. In investigating the properties of such waves it is desirable to start by looking at the whole range of related motions. The most obvious extension is to the hydraulic jump; since, in the simplest view, it is equivalent to a bore but in a frame of reference moving with the wave. It is also an example where the mean flow is steady rather than quasisteady.


1991 ◽  
Vol 36 (5-6) ◽  
pp. 973-978 ◽  
Author(s):  
Kiyochika Yahikozawa ◽  
Yuichi Fujii ◽  
Yoshiharu Matsuda ◽  
Katsunori Nishimura ◽  
Yoshio Takasu

Sign in / Sign up

Export Citation Format

Share Document