A comparison of in situ and extractive measurement techniques for monitoring SO2 emissions from a stationary source

1975 ◽  
Vol 3 (4) ◽  
pp. 349-362
Author(s):  
James B. Homolya
2021 ◽  
Vol 13 (7) ◽  
pp. 1238
Author(s):  
Jere Kaivosoja ◽  
Juho Hautsalo ◽  
Jaakko Heikkinen ◽  
Lea Hiltunen ◽  
Pentti Ruuttunen ◽  
...  

The development of UAV (unmanned aerial vehicle) imaging technologies for precision farming applications is rapid, and new studies are published frequently. In cases where measurements are based on aerial imaging, there is the need to have ground truth or reference data in order to develop reliable applications. However, in several precision farming use cases such as pests, weeds, and diseases detection, the reference data can be subjective or relatively difficult to capture. Furthermore, the collection of reference data is usually laborious and time consuming. It also appears that it is difficult to develop generalisable solutions for these areas. This review studies previous research related to pests, weeds, and diseases detection and mapping using UAV imaging in the precision farming context, underpinning the applied reference measurement techniques. The majority of the reviewed studies utilised subjective visual observations of UAV images, and only a few applied in situ measurements. The conclusion of the review is that there is a lack of quantitative and repeatable reference data measurement solutions in the areas of mapping pests, weeds, and diseases. In addition, the results that the studies present should be reflected in the applied references. An option in the future approach could be the use of synthetic data as reference.


2017 ◽  
Author(s):  
Vitali Fioletov ◽  
Chris A. McLinden ◽  
Shailesh K. Kharol ◽  
Nickolay A. Krotkov ◽  
Can Li ◽  
...  

Abstract. Reported sulfur dioxide (SO2) emissions from U.S. and Canadian sources have declined dramatically since the 1990s as a result of emissions control measures. Observations from the Ozone Monitoring Instrument (OMI) on NASA's Aura satellite and ground-based in-situ measurements are examined to verify whether the observed changes from SO2 abundance measurements are quantitatively consistent with the reported changes in emissions. To make this connection, a new method to link SO2 emissions and satellite SO2 measurements was developed. The method is based on fitting satellite SO2 vertical column densities (VCDs) to a set of functions of OMI pixel coordinates and wind speeds, where each function represents a statistical model of a plume from a single point source. The concept is first demonstrated using sources in North America, and then applied to Europe. The correlation coefficient between OMI-measured VCDs (with a local bias removed) and SO2 VCDs derived here using reported emissions for 1° by 1° gridded data is 0.91 and the best-fit line has a slope near unity, confirming a very good agreement between observed SO2 VCDs and reported emissions. Having demonstrated their consistency, seasonal and annual mean SO2 VCD distributions are calculated, based on reported point-source emissions for the period 1980–2015, as would have been seen by OMI. This consistency is further substantiated as the emissions-derived VCDs also show a high correlation with annual mean SO2 surface concentrations at 50 regional monitoring stations.


2014 ◽  
pp. 75-80
Author(s):  
Károly Bakos ◽  
Attila Dobos ◽  
János Nagy

In this article we are presenting the methodology applied to analyse and interpret the topsoil surface reflectance parameters of multiple samples collected in the Mugello valley area in northern Italy in October 2012. The main aim of the whole project was to discover geomorphological behaviour and situation of the area ino order to improve potential for correct dating of certain archaeological artefacts found in the nearby areas. One of the crucial problem researchers are facing in the area is the lack of understanding of the underlying geological and geomorphological processes that were describing and characterizing the area and that played important role not only in the current geography and landscape formation but also in the transportation of various sediments and artefacts. In this particular research the main aim is to examine the possibility of developing a quick way to assess low level properties of the soil using hand held spectrometer and rapid analysis of cross-section using in situ measurement techniques. In this work we collected over 2000 individual samples of topsoil surface reflectance properties that we organized into a spectral library. This library is then to be used to describe physical and chemical processes in the soil. To support the analysis results were compared to analysis results from different kind of assessments in the same area. Our results show a great potential of application of hand held imaging spectrometer in soil property analysis based on the top soil surface reflectance parameters.


Author(s):  
V. Conde ◽  
D. Nilsson ◽  
B. Galle ◽  
R. Cartagena ◽  
A. Muñoz

Abstract. Volcanic gas emissions play a crucial role in describing geophysical processes; hence measurements of magmatic gases such as SO2 can be used as tracers prior and during volcanic crises. Different measurement techniques based on optical spectroscopy have provided valuable information when assessing volcanic crises. This paper describes the design and implementation of a network of spectroscopic instruments based on Differential Optical Absorption Spectroscopy (DOAS) for remote sensing of volcanic SO2 emissions, which is robust, portable and can be deployed in relative short time. The setup allows the processing of raw data in situ even in remote areas with limited accessibility, and delivers pre-processed data to end-users in near real time even during periods of volcanic crisis, via a satellite link. In addition, the hardware can be used to conduct short term studies of volcanic plumes in remotes areas. The network was tested at Telica, an active volcano located in western Nicaragua, producing what is so far the largest data set of continuous SO2 flux measurements at this volcano.


2015 ◽  
Vol 22 (4) ◽  
pp. 879-885 ◽  
Author(s):  
Paw Kristiansen ◽  
Jan Horbach ◽  
Ralph Döhrmann ◽  
Joachim Heuer

The requirement for vibrational stability of beamline optics continues to evolve rapidly to comply with the demands created by the improved brilliance of the third-generation low-emittance storage rings around the world. The challenge is to quantify the performance of the instrument before it is installed at the beamline. In this article, measurement techniques are presented that directly and accurately measure (i) the relative vibration between the two crystals of a double-crystal monochromator (DCM) and (ii) the absolute vibration of the second-crystal cage of a DCM. Excluding a synchrotron beam, the measurements are conducted underin situconditions, connected to a liquid-nitrogen cryocooler. The investigated DCM utilizes a direct-drive (no gearing) goniometer for the Bragg rotation. The main causes of the DCM vibration are found to be the servoing of the direct-drive goniometer and the flexibility in the crystal cage motion stages. It is found that the investigated DCM can offer relative pitch vibration down to 48 nrad RMS (capacitive sensors, 0–5 kHz bandwidth) and absolute pitch vibration down to 82 nrad RMS (laser interferometer, 0–50 kHz bandwidth), with the Bragg axis brake engaged.


2019 ◽  
Vol 19 (14) ◽  
pp. 9181-9208 ◽  
Author(s):  
Kristina Pistone ◽  
Jens Redemann ◽  
Sarah Doherty ◽  
Paquita Zuidema ◽  
Sharon Burton ◽  
...  

Abstract. The total effect of aerosols, both directly and on cloud properties, remains the biggest source of uncertainty in anthropogenic radiative forcing on the climate. Correct characterization of intensive aerosol optical properties, particularly in conditions where absorbing aerosol is present, is a crucial factor in quantifying these effects. The southeast Atlantic Ocean (SEA), with seasonal biomass burning smoke plumes overlying and mixing with a persistent stratocumulus cloud deck, offers an excellent natural laboratory to make the observations necessary to understand the complexities of aerosol–cloud–radiation interactions. The first field deployment of the NASA ORACLES (ObseRvations of Aerosols above CLouds and their intEractionS) campaign was conducted in September of 2016 out of Walvis Bay, Namibia. Data collected during ORACLES-2016 are used to derive aerosol properties from an unprecedented number of simultaneous measurement techniques over this region. Here, we present results from six of the eight independent instruments or instrument combinations, all applied to measure or retrieve aerosol absorption and single-scattering albedo. Most but not all of the biomass burning aerosol was located in the free troposphere, in relative humidities typically ranging up to 60 %. We present the single-scattering albedo (SSA), absorbing and total aerosol optical depth (AAOD and AOD), and absorption, scattering, and extinction Ångström exponents (AAE, SAE, and EAE, respectively) for specific case studies looking at near-coincident and near-colocated measurements from multiple instruments, and SSAs for the broader campaign average over the month-long deployment. For the case studies, we find that SSA agrees within the measurement uncertainties between multiple instruments, though, over all cases, there is no strong correlation between values reported by one instrument and another. We also find that agreement between the instruments is more robust at higher aerosol loading (AOD400>0.4). The campaign-wide average and range shows differences in the values measured by each instrument. We find the ORACLES-2016 campaign-average SSA at 500 nm (SSA500) to be between 0.85 and 0.88, depending on the instrument considered (4STAR, AirMSPI, or in situ measurements), with the interquartile ranges for all instruments between 0.83 and 0.89. This is consistent with previous September values reported over the region (between 0.84 and 0.90 for SSA at 550nm). The results suggest that the differences observed in the campaign-average values may be dominated by instrument-specific spatial sampling differences and the natural physical variability in aerosol conditions over the SEA, rather than fundamental methodological differences.


2005 ◽  
Vol 22 (9) ◽  
pp. 1373-1380 ◽  
Author(s):  
Darek J. Bogucki ◽  
Burton H. Jones ◽  
Mary-Elena Carr

Abstract The rate of horizontal diffusivity or lateral dispersion is key to understanding the dispersion of tracers and contaminants in the ocean, and it is an elusive, yet crucial, parameter in numerical models of circulation. However, the difficulty of parameterizing horizontal mixing is exacerbated in the shallow coastal ocean, which points to the need for more direct measurements. Here, a novel and inexpensive approach to remotely measure the rate of horizontal diffusivity is proposed. Current shipboard measurement techniques require repeated surveys and are thus time consuming and labor intensive. Furthermore, intensive in situ sampling is generally impractical for routine coastal management or for rapid assessment in the case of emergencies. A remote approach is particularly useful in shallow coastal regions or those with complex bathymetry. A time series of images from a dye-release experiment was obtained with a standard three-megapixel digital camera from a helicopter that hovered over the study area. The red–green–blue (RGB) images were then 1) analyzed to distinguish the dye from the ambient color of the water and adjacent land features, 2) orthorectified, and 3) analyzed to obtain advection and diffusion rates of the thin subsurface dye layer. A horizontal current of the order of 6 cm s−1 was found. The estimated horizontal eddy diffusivity rate for scales of O(10 m) in the harbor was 0.1 m2 s−1. The dye diffusivity and advection rate that are calculated from the images are consistent with independent calculations based on in situ measurements of current speed fluctuations.


Sign in / Sign up

Export Citation Format

Share Document