Deformation of concrete at variable moisture content

1986 ◽  
Vol 23 (6) ◽  
pp. 223
Keyword(s):  
Moisture Content ◽  
Variable Moisture Content

scholarly journals ELECTRICAL PROPERTIES OF MUNG BEANS (Vigna Radiata L.)

2021 ◽  
Vol 25 (3) ◽  
pp. 101-105
Author(s):  
Ján Novák
Keyword(s):  
Electrical Properties ◽  
Moisture Content ◽  
Electric Field ◽  
Loss Tangent ◽  
Vigna Radiata ◽  
Relative Permittivity ◽  
Dielectric Material ◽  
Variable Moisture Content

This paper contains the results of measuring the electrical properties of mung beans (Vigna radiata L.) set. The conductivity and relative permittivity are the main parameters of dielectric material electrical properties. The electrical properties of mung beans samples had not been sufficiently measured, and the aim of this work was to perform the measurements of these properties. Measurements were performed under variable moisture content and the frequency of electric field from 0.1 kHz till 200 kHz for conductivity and in the range from 1 MHz to 16 MHz for relative permittivity, using RLC meter and Q meter, respectively. It was concluded that relative permittivity, and conductivity increased with increase of moisture content, resistivity, impedance, loss tangent, and relative permittivity decreased as the frequency of electric field increased, respectively.

scholarly journals PERMEABILITY AND MECHANICAL BEHAVIOUR OF MICROWAVE PRE-TREATED NORWAY SPRUCE RIPEWOOD

Wood Research ◽  
2021 ◽  
Vol 66 (4) ◽  
pp. 569-581
Author(s):  
DOMINIK HESS ◽  
PETR PAŘIL ◽  
JAKUB DÖMÉNY ◽  
JAN BAAR
Keyword(s):  
Mechanical Properties ◽  
Moisture Content ◽  
Norway Spruce ◽  
Mechanical Behaviour ◽  
Vacuum Pressure ◽  
Average Depth ◽  
Depth Of Penetration ◽  
Pre Treatment ◽  
Variable Moisture Content

This is a studyofthe influence of microwave (MW) pre-treatment on the permeabilityof Norway spruceripewood(Picea abiesL. Karst)as it affects its mechanical properties. Specimens weretreated under variable moisture content,MW intensity,and impregnation processes. According to the results,thespecimens withaninitial moisture contentof 45–65% exhibited the highest permeabilityvaluescompared to referencesamples. Aninsignificant difference was found between MW pre-treatments at2 and3kW.Statistically significant results were found afterlong-time (24h) vacuum-pressureimpregnation(LP). Theaverage retention value followingLP was 132 kg.m-3, which isalmost threetimes greater thanthe MW-treatedgroupsimpregnated in ashort-time vacuum-pressure process. The average depth of penetration after LP was 2.0mm and the proportion of the impregnation area followingLP was 17.6%. MW pre-treatment had no effect on the impregnability or the mechanical propertiesof the wood; other MW regimes are open for further examination.

Volatile Emissions from Variable Moisture Content Sediments

2001 ◽  
Vol 18 (5) ◽  
pp. 279-289 ◽  
Author(s):  
Bruce Choy ◽  
Danny D. Reible ◽  
Kalliat T. Valsaraj
Keyword(s):  
Moisture Content ◽  
Volatile Emissions ◽  
Variable Moisture Content

Preparation and Standardization of a Stable AHF Plasma

1968 ◽  
Vol 19 (03/04) ◽  
pp. 423-429 ◽  
Author(s):  
G. M Thelin ◽  
Keyword(s):  
Moisture Content ◽  
Primary Standard ◽  
Healthy Male ◽  
Healthy Donors ◽  
Fresh Plasma

SummaryA stable, lyophilized AHF reference plasma has been prepared from pooled plasma from at least 50 normal healthy donors and standardized against a primary standard of fresh plasma from 20 healthy male donors aged 20 to 40. Average AHF potency of a typical lot is 98.8%, and moisture content is less than 0.5%. Under storage at -25° C, this AHF reference plasma is stable for at least 18 months. It has been used in several major coagulation laboratories, and has given consistently satisfactory and reproducible results in AHF assays.

Sign in / Sign up

Export Citation Format

Share Document