Correlation of Physiological Cross-Sectional Areas of Muscle and Tendon

1991 ◽  
Vol 16 (1) ◽  
pp. 66-67 ◽  
Author(s):  
K.-N. AN ◽  
R. L. LINSCHEID ◽  
P. W. BRAND
Keyword(s):  
Tendon Transfer ◽  
Muscle Mechanics ◽  
Fibre Length ◽  
Cross Sectional Area ◽  
Maximum Strength ◽  
Sectional Area ◽  
Cross Sectional ◽  
Sports Science ◽  
Transfer Procedures

Muscle physiological cross-sectional area, as defined and measured by dividing the volume of the muscle by its fibre length, is proportional to the maximum strength of the muscle. It is one of the important parameters when considering muscle mechanics in sports science and, clinically in tendon transfer procedures. This study reports that tendon cross-sectional area correlated well with the physiological cross-sectional area of associated muscles.

Methods of analysis and the influence of fleece characters on unit area wool production of Romney lambs

1960 ◽  
Vol 11 (5) ◽  
pp. 851 ◽  
Author(s):  
AE Henderson ◽  
BI Hayman
Keyword(s):  
Unit Area ◽  
Fibre Length ◽  
Fibre Volume ◽  
Cross Sectional Area ◽  
The Body ◽  
Skin Area ◽  
Sectional Area ◽  
Cross Sectional ◽  
Wool Production ◽  
Fibre Number

Investigation has been made of the influence of fibre number per unit area (N), cross-sectional area of fibre (A), and fibre length (L), on wool production per unit area of skin (W). The influence of the compound characters fibre volume (V) and proportion of skin area occupied by fibre (0) has also been considered. Methods are given whereby the significance of the variation associated with any one of these interacting components can be assessed. Data from four groups of lambs were analysed, each group having been subjected to a different nutritional regime. Slightly more than three-quarters of the variation induced in W by these treatments was due to variation in L, with N and A having negligible effects. No evidence was found that the relative influence of the components changed with change in level of production. Differences in W between lambs on the same nutritional level were influenced almost equally by variation in N and L, with A again having a negligible effect. Of the variation in W between positions on lambs, approximately 50 per cent. was accounted for by variation in N, 40 per cent. by variation in A, and 10 per cent. by variation in L. Variation of the compound character O accounted for nearly 90 per cent. of the variation in W over the body.

Anatomy and Properties of Japanese Hardwoods I. Variation of Fibre Dimensions and Tissue Proportions and their Relation to Basic Density

IAWA Journal ◽  
1991 ◽  
Vol 12 (4) ◽  
pp. 419-424 ◽  
Author(s):  
Shinji Fujiwara ◽  
Kazuhiko Sameshima ◽  
Kenichi Kuroda ◽  
Norio Takamura
Keyword(s):  
Wall Thickness ◽  
Fibre Length ◽  
Basic Density ◽  
Cross Sectional Area ◽  
Wall Material ◽  
Sectional Area ◽  
Cross Sectional ◽  
Wall Area ◽  
Fibre Wall ◽  
Area Percentage

Variations of tissue proportions and fibre dimensions (fibre length, fibre cross sectional area, fibre wall thickness, fibre wall area, percentage of fibre wall area) of 50 Japanese hardwoods are compared. The fibre cross sectional area showed large variations as compared to fibre length. There is no significant correlation between fibre cross sectional area and fibre wall thickness.The multiple regression analysis showed that fibre wall thickness, percentage of fibre wall material and ray volume are the parameters most closely correlated with basic density.

Wool fibre tenacity in Romney sheep genetically different in staple tenacity

1996 ◽  
Vol 47 (8) ◽  
pp. 1203 ◽  
Author(s):  
DR Scobie ◽  
RJ Walls ◽  
LJ Markham ◽  
JL Woods ◽  
AR Bray
Keyword(s):  
Cross Section ◽  
Fibre Length ◽  
Cross Sectional Area ◽  
Peak Force ◽  
Wool Fibre ◽  
Sectional Area ◽  
Cross Sectional ◽  
Wool Sample ◽  
Image Analyser ◽  
The Difference

Wool from lines of Romney sheep selected for improved or reduced staple tenacity was examined to determine if the difference in staple tenacity was explained by a difference in fibre tenacity. A random sample of ewe hogget wools (n = 32) was chosen from each of the 2 selection lines. Fibre tenacity was measured by breaking 10 fibres from each wool sample using an Instron to measure peak force, and then a fluorescence microscope attached to an image analyser to measure cross-sectional area of the fracture surface. Staple tenacity was measured on 5 staples per sample, by placing each staple in a Staplebreaker set to 40 mm between clamps, and the peak force to break the staple was recorded. Prior to clamping, each staple was adjusted so that the thinnest point measured 1.5 mm2 in cross-section and this point was positioned 20 mm from each clamp. Although the difference in staple tenacity between these 2 groups was highly significant (P = 0.002)) there was no difference in the tenacity of individual fibres (P = 0.903). Staple tenacity was not significantly correlated with fibre tenacity (r = 0.090). Similarly, there was no significant correlation between work to break the staple and either work (r = 0.118) or peak force (r = 0.195) to break the fibre. It is proposed that other components of staple tenacity, such as the profile of cross-sectional area along the fibre and the variability of crimped fibre length within the staple, may be more important determinants of staple tenacity in these selection lines.

A study of wool growth: Part II. Mean fibre thickness, density of fibre population, the area of skin covered by fibre, and the mean fibre length

1948 ◽  
Vol 38 (3) ◽  
pp. 303-313 ◽  
Author(s):  
N. Galpin
Keyword(s):  
Unit Area ◽  
Fibre Length ◽  
Expansion Ratio ◽  
Cross Sectional Area ◽  
Skin Area ◽  
Sectional Area ◽  
Cross Sectional ◽  
The Mean ◽  
Length And Area ◽  
Growing Conditions

SUMMARYBy measurement of single fibres from tattooed squares the variation in hip region mean cross-sectional area, mean fibre length and area of skin covered by fibre substance in a small flock of Romney sheep has been studied for a few years—see Part I.We find that under good growing conditions the area of skin covered by fibre is a constant percentage of the skin area for all sheep in all years. The number of fibres per unit area varies from sheep to sheep, and the mean cross-sectional area is inversely proportional to the number of fibres per unit area. The mean length/day is a constant for all sheep. When conditions are unfavourable the percentage of the skin area covered by fibre on a particular sheep falls below the good growing conditions percentage by an amount that is smaller the bigger the skin expansion ratio, but is greater the worse the season.

Pelvic Canal Narrowing Caused by Triple Pelvic Osteotomy in the Dog

1994 ◽  
Vol 07 (03) ◽  
pp. 110-113 ◽  
Author(s):  
D. L. Holmberg ◽  
M. B. Hurtig ◽  
H. R. Sukhiani
Keyword(s):  
Postoperative Complications ◽  
Pelvic Osteotomy ◽  
Cross Sectional Area ◽  
Sectional Area ◽  
Cross Sectional ◽  
Canal Width ◽  
Operative Complications ◽  
Post Operative Complications

SummaryDuring a triple pelvic osteotomy, rotation of the free acetabular segment causes the pubic remnant on the acetabulum to rotate into the pelvic canal. The resulting narrowing may cause complications by impingement on the organs within the pelvic canal. Triple pelvic osteotomies were performed on ten cadaver pelves with pubic remnants equal to 0, 25, and 50% of the hemi-pubic length and angles of acetabular rotation of 20, 30, and 40 degrees. All combinations of pubic remnant lengths and angles of acetabular rotation caused a significant reduction in pelvic canal-width and cross-sectional area, when compared to the inact pelvis. Zero, 25, and 50% pubic remnants result in 15, 35, and 50% reductions in pelvic canal width respectively. Overrotation of the acetabulum should be avoided and the pubic remnant on the acetabular segment should be minimized to reduce postoperative complications due to pelvic canal narrowing.When performing triple pelvic osteotomies, the length of the pubic remnant on the acetabular segment and the angle of acetabular rotation both significantly narrow the pelvic canal. To reduce post-operative complications, due to narrowing of the pelvic canal, overrotation of the acetabulum should be avoided and the length of the pubic remnant should be minimized.

DETERMINATION OF THE FUNCTION OF THE ROD’S CROSS-SECTIONAL AREA USING VIBRATION EIGENFREQUENCIES

2020 ◽  
Vol 0 (4) ◽  
pp. 19-24
Author(s):  
I.M. UTYASHEV ◽  
◽  
A.A. AITBAEVA ◽  
A.A. YULMUKHAMETOV ◽  
◽  
...  
Keyword(s):  
Cross Sectional Area ◽  
Variable Cross ◽  
Sectional Area ◽  
Longitudinal Vibrations ◽  
Cross Sectional ◽  
Method Error ◽  
Various Boundary Conditions ◽  
Elastic Fixation ◽  
Crosssectional Area

The paper presents solutions to the direct and inverse problems on longitudinal vibrations of a rod with a variable cross-sectional area. The law of variation of the cross-sectional area is modeled as an exponential function of a polynomial of degree n . The method for reconstructing this function is based on representing the fundamental system of solutions of the direct problem in the form of a Maclaurin series in the variables x and λ. Examples of solutions for various section functions and various boundary conditions are given. It is shown that to recover n unknown coefficients of a polynomial, n eigenvalues are required, and the solution is dual. An unambiguous solution was obtained only for the case of elastic fixation at one of the rod’s ends. The numerical estimation of the method error was made using input data noise. It is shown that the error in finding the variable crosssectional area is less than 1% with the error in the eigenvalues of longitudinal vibrations not exceeding 0.0001.

Changes in the parameters of nasal breathing and parameters of the upper respiratory tract during orthognathic operations in patients with II and III skeletal class of jaw anomalies

2020 ◽  
pp. 22-27
Author(s):  
S.Sh. Gammadaeva ◽  
M.I. Misirkhanova ◽  
A.Yu. Drobyshev
Keyword(s):  
Respiratory Tract ◽  
Nasal Cavity ◽  
Nasal Septum ◽  
Cross Sectional Area ◽  
Upper Respiratory Tract ◽  
Sectional Area ◽  
Nasal Breathing ◽  
Cross Sectional ◽  
Skeletal Class ◽  
Upper Respiratory

The study analyzed the functional parameters of nasal breathing, linear parameters of the nasal aperture, nasal cavity and nasopharynx, volumetric parameters of the upper airways in patients with II and III skeletal class of jaw anomalies before and after orthognathic surgery. The respiratory function of the nose was assessed using a rhinomanometric complex. According to rhinoresistometry data, nasal resistance and hydraulic diameter were assessed. According to the data of acoustic rhinometry, the minimum cross-sectional area along the internal valve, the minimum cross-sectional area on the head of the inferior turbinate and nasal septum and related parameters were estimated. According to the CBCT data, the state of the nasal septum, the inferior turbinates, the nasal aperture, the state of the nasal cavity, and the linear values of the upper respiratory tract (nasopharynx) were analyzed. The patients were divided into 4 groups according to the classification of the patency of the nasal passages by

Sign in / Sign up

Export Citation Format

Share Document