Weight loss method of corrosion assessment

2022 ◽  
pp. 85-92
Author(s):  
Chandrabhan Verma
Keyword(s):  
Weight Loss ◽  
Weight Loss Method ◽  
Corrosion Assessment ◽  
Loss Method

A Note on Groove Depth Changes Without Wear

1980 ◽  
Vol 8 (1) ◽  
pp. 10-12
Author(s):  
F. C. Brenner
Keyword(s):  
Weight Loss ◽  
Wear Test ◽  
Groove Depth ◽  
High Rate ◽  
Weight Changes ◽  
Wear Rates ◽  
Weight Loss Method ◽  
Loss Method ◽  
And Storage ◽  
Low Rate

Abstract Tread wear rates during first wear measured by groove depth and weight changes do not always agree. Sometimes, the groove depth method shows a high rate and the weight loss method a low rate. Reported here are experiments designed to determine if grooves show depth changes without wear. Four tires were measured before mounting on a wheel, after mounting and inflation, and after inflation and storage. The mounted and inflated tires showed shallower shoulder grooves and deeper center grooves than the unmounted tires. In a second experiment, tires were measured immediately after a tread wear test and then stored mounted for two weeks before remeasuring. Each groove became deeper, and there was no change in the crown radius of any tire.

scholarly journals Synergistic and Antagonistic Effects of Sodium Molybdate-Zn2+System

2012 ◽  
Vol 9 (4) ◽  
pp. 1746-1752 ◽  
Author(s):  
J. Wilson Sahayaraj ◽  
A. John Amalraj ◽  
Susai Rajendran ◽  
N. Vijaya
Keyword(s):  
Aqueous Solution ◽  
Weight Loss ◽  
Inhibition Efficiency ◽  
Sodium Molybdate ◽  
Antagonistic Effect ◽  
Protective Film ◽  
Antagonistic Effects ◽  
Polarization Study ◽  
Weight Loss Method ◽  
Loss Method

The inhibition efficiency (IE) of sodium molybdate (SM) in controlling corrosion of carbon steel in an aqueous solution containing 120 ppm of Cl-, in the absence and presence of Zn2+has been evaluated by weight-loss method. A synergistic effect exists between SM and Zn2+when the concentration of Zn2+is 25 ppm and above. Inhibition efficiencies obtained are greater than 85%. Antagonistic effect exists between SM and Zn2+when the concentration of Zn2+is 10 ppm and below. The SM-Zn2+system shows excellent IE up to third day. Above third day IE decreases. Acceleration of corrosion takes place. Excellent IE is shown at pH 5,7 and 12. At pH 9, IE decreases since Zn2+is precipitated as Zn(OH)2in the bulk of the solution. Polarization study reveals that SM-Zn2+system functions as a mixed inhibitor. FTIR spectra reveal that the protective film consists of Fe2+-SM complex and Zn(OH)2.

Experimental Research on Erosion of P110 Tubing during Perforating

2014 ◽  
Vol 1073-1076 ◽  
pp. 2244-2247
Author(s):  
Hu Sun ◽  
Zhi Jun Ning ◽  
Zu Wen Wang ◽  
Zhen Li ◽  
Zhi Guo Wang
Keyword(s):  
Weight Loss ◽  
Erosion Rate ◽  
Large Scale ◽  
Guar Gum ◽  
Electrochemical Corrosion ◽  
Low Velocity ◽  
Gas Field ◽  
Weight Loss Method ◽  
Loss Method ◽  
Gas Fields

Erosion is a main failure of tubings and downhole tools in Changqing gas field. It is necessary to evaluate the erosion rate for the safety of tubing and strings. In this paper, the erosion of P110 steel, in the 0.2%wt guar gum fracturing fluid which contains sands, is investigated by weight loss method in the self-made jet experiment device. It is indicated that the erosion rate increases with the increment of slurry velocity exponentially. When the slurry velocity is in low velocity area, the electrochemical corrosion of dissolved oxygen dominates in erosion mechanism; when slurry velocity increases into middle velocity area, the weight loss is controlled by the synergism of corrosion-erosion; and when the slurry velocity increases into high velocity area, the weight loss rate is dominantly depended on erosion of particles. The results can provide guidelines for large-scale fracturing work of Changqing gas fields.

The Effect of Regional Selectivity on the Corrosion Inhibition Properties of Synthetic Ionic Liquid with the Synergistic Action of Cation and Anion

2021 ◽  
Author(s):  
Jian Sun ◽  
Xinyue Wang ◽  
huajing Gao ◽  
Feng Chen ◽  
Xing-Bao Wang ◽  
...  
Keyword(s):  
Weight Loss ◽  
Ionic Liquid ◽  
Ionic Liquids ◽  
Hybrid Systems ◽  
Corrosion Inhibition ◽  
Synergistic Action ◽  
Weight Loss Method ◽  
Loss Method ◽  
Regional Selectivity

By adding different proportions of N-buthylimidazole and carboxyethylthiosuccinic acid (CETSA), three hybrid systems of ionic liquids were synthesized and named ILHS1, ILHS2 and ILHS3. By using weight loss method, electrochemical...

Corrosion Behaviour of Aluminium Alloy in Palm Oil Methyl Ester (B100)

2012 ◽  
Vol 58 (2) ◽  
Author(s):  
W. B. Wan Nik ◽  
S. Syahrullail ◽  
R. Rosliza ◽  
M. M. Rahman ◽  
M. F. R. Zulkifli
Keyword(s):  
Weight Loss ◽  
Methyl Ester ◽  
Corrosion Rate ◽  
Aluminium Alloy ◽  
Palm Oil ◽  
Corrosion Behaviour ◽  
Corrosion Current ◽  
Electrochemical Test ◽  
Weight Loss Method ◽  
Loss Method

The aim of this study is to determine the corrosion effect of palm oil methyl ester (POME) on aluminium alloy 5083 (AA5083). The static immersion test was carried out at 60°C for 68 days according to ASTM G–31–72. The corrosion analysis was done by using weight loss method and electrochemical test. The result from weight loss method shows the decreasing in weight loss of AA5083 which signifies the ability of POME to reduce corrosion rate. The electrochemical test shows the decreasing in polarization resistance,Rp, while the corrosion current densities, Icorr, increase. The corrosion rate reduces from 2.250mpy to 0.1946mpy. The low concentration of fatty acid C18:2 and high anti oxidant element contributes to the reduction of corrosion rate of AA5083 in POME.

EVALUATION OF A SIMPLE WEIGHT-LOSS METHOD FOR DETERMINING THE PERMEATION OF ORGANIC LIQUIDS THROUGH RUBBER FILMS

AIHAJ ◽  
1991 ◽  
Vol 52 (10) ◽  
pp. 445-447 ◽  
Author(s):  
R.L. Mickelsen ◽  
R.C. Hall ◽  
R.T. Chern ◽  
J.R. Myers
Keyword(s):  
Weight Loss ◽  
Organic Liquids ◽  
Weight Loss Method ◽  
Loss Method

scholarly journals The inhibition of mild steel corrosion in 0.5 M H2SO4 solution by radish leaf extract

RSC Advances ◽  
2019 ◽  
Vol 9 (70) ◽  
pp. 40997-41009 ◽  
Author(s):  
Dongyi Li ◽  
Panpan Zhang ◽  
Xinyu Guo ◽  
Xiaowei Zhao ◽  
Ying Xu
Keyword(s):  
Weight Loss ◽  
Mild Steel ◽  
Electrochemical Method ◽  
Leaf Extract ◽  
Steel Corrosion ◽  
Inhibitory Effect ◽  
H2so4 Solution ◽  
Mild Steel Corrosion ◽  
Weight Loss Method ◽  
Loss Method

The inhibitory effect of radish leaf extract (RLE) on mild steel corrosion in 0.5 M H2SO4 was studied by the weight loss method and the electrochemical method.

Study on Corrosion Resistance of Brass in Circulating Cooling Water with Different Concentration Ratio

2012 ◽  
Vol 511 ◽  
pp. 70-73
Author(s):  
Yu Chun Li ◽  
Xiao Wei Liu ◽  
Rui Feng Zhang ◽  
Kang Juan ◽  
Fan Gao
Keyword(s):  
Weight Loss ◽  
Corrosion Resistance ◽  
Concentration Ratio ◽  
Water System ◽  
Cooling Water ◽  
Cooling Water System ◽  
Circulating Cooling Water ◽  
Weight Loss Method ◽  
Ratio Condition ◽  
Loss Method

Abstract: The corrosion resistance of brass H70-1A cooling water was studied through weight-loss method and electrochemistry measurement in different concentration ratio condition. The results obtained from this study showed that brass inhibitor was necessary to add to circulating cooling water system when concentration ratio was in the range of 3~7.

Inhibition of Aloe in Corrosion Experimental Research

2011 ◽  
Vol 233-235 ◽  
pp. 648-651
Author(s):  
Ai Jun Wei ◽  
Bei Feng ◽  
Xin Zhang ◽  
Fu Yong Huo
Keyword(s):  
Weight Loss ◽  
Corrosion Rate ◽  
Work Environment ◽  
Corrosion Inhibition ◽  
Corrosion Test ◽  
Inhibition Effect ◽  
Corrosion Medium ◽  
Different Temperatures ◽  
Weight Loss Method ◽  
Loss Method

In this corrosion test, simulated brine is used as corrosion medium, added different concentrations of aloe juice. Static weight-loss method is employed, meanwhile, we calculated corrosion rate of Q235 steel and researched on the corrosion inhibition effect of aloe in different temperatures. Results show that aloe is a good inhibitor, rate of corrosion inhibition can reach 80% or more and suitable for the temperature of work environment is less than 60 °C.

scholarly journals Microbial Corrosion of API 5L X-70 Carbon Steel by ATCC 7757 and Consortium of Sulfate-Reducing Bacteria

2014 ◽  
Vol 2014 ◽  
pp. 1-7 ◽  
Author(s):  
Arman Abdullah ◽  
Nordin Yahaya ◽  
Norhazilan Md Noor ◽  
Rosilawati Mohd Rasol
Keyword(s):  
Weight Loss ◽  
Carbon Steel ◽  
Corrosion Rate ◽  
Sulfate Reducing Bacteria ◽  
Desulfovibrio Vulgaris ◽  
Corrosion Morphology ◽  
Sulfate Reducing ◽  
Weight Loss Method ◽  
Loss Method ◽  
Reducing Bacteria

Various cases of accidents involving microbiology influenced corrosion (MIC) were reported by the oil and gas industry. Sulfate reducing bacteria (SRB) have always been linked to MIC mechanisms as one of the major causes of localized corrosion problems. In this study, SRB colonies were isolated from the soil in suspected areas near the natural gas transmission pipeline in Malaysia. The effects of ATCC 7757 and consortium of isolated SRB upon corrosion on API 5L X-70 carbon steel coupon were investigated using a weight loss method, an open circuit potential method (OCP), and a potentiodynamic polarization curves method in anaerobic conditions. Scanning electron microscopy (SEM) and energy dispersive X-ray spectroscopy (EDS) were then used to determine the corrosion morphology in verifying the SRB activity and corrosion products formation. Results from the study show that the corrosion rate (CR) of weight loss method for the isolated SRB is recorded as 0.2017 mm/yr compared to 0.2530 mm/yr for ATCC 7757. The Tafel plot recorded the corrosion rate of 0.3290 mm/yr for Sg. Ular SRB and 0.2500 mm/yr forDesulfovibrio vulgaris. The results showed that the consortia of isolated SRB were of comparable effects and features with the single ATCC 7757 strain.

Sign in / Sign up

Export Citation Format

Share Document