Quantifying the aggregation-dispersion boundary condition in terms of saturated hydraulic conductivity reduction and the threshold electrolyte concentration

2018 ◽  
Vol 203 ◽  
pp. 172-178 ◽  
Author(s):  
A. Dang ◽  
J. McL. Bennett ◽  
A. Marchuk ◽  
A. Biggs ◽  
S.R. Raine
Soil Research ◽  
1992 ◽  
Vol 30 (5) ◽  
pp. 565 ◽  
Author(s):  
NS Jayawardane

Equivalent salt solutions series have been previously defined as solutions with combinations of sodium absorption ratio (SAR) and electrolyte concentration (E,) producing the same extent of clay swelling in a given soil. These equivalent salt solutions series values have yielded satisfactory predictions of changes in saturated hydraulic conductivity, with changes in salt solution composition and concentrations. In the present study, previously published data on changes in saturated and unsaturated hydraulic conductivities of Gilat soil in salt solutions of cationic ratio 0-50 (mmol dm-3)1/2 and electrolyte concentration 2-50 (m.e. dm-3) were used to compare the equivalent salt solution series values for hydraulic conductivities at different water contents. The equivalent salt solution series causing a given change in saturated hydraulic conductivity of a loamy Gilat soil were derived. These equivalent salt solution values were used to predict the unsaturated hydraulic conductivities of this soil at low water contents. Predictions of unsaturated conductivity at relative water contents (�) ranging from 0.80 to 0.20 agreed closely with the measured values. Coefficients log a1 and b1 for Gilat soil, in the equation log Ec = log a1+b1 log SAR, relating the Ec and SAR values of each equivalent salt solutions series were determined at � values between 1.00 and 0.20. The relationship between log a1 and bl was similar at all water contents, in agreement with the equivalent salt solutions concept. Therefore, equivalent salt solution parameters derived from saturated hydraulic conductivity measurements could be used to predict changes in unsaturated conductivities and hence flow rates of saline water under specified boundary conditions.


1990 ◽  
Vol 21 (2) ◽  
pp. 119-132 ◽  
Author(s):  
Johnny Fredericia

The background for the present knowledge about hydraulic conductivity of clayey till in Denmark is summarized. The data show a difference of 1-2 orders of magnitude in the vertical hydraulic conductivity between values from laboratory measurements and field measurements. This difference is discussed and based on new data, field observations and comparison with North American studies, it is concluded to be primarily due to fractures in the till.


2019 ◽  
Vol 34 (2) ◽  
pp. 237-243
Author(s):  
Jari Hyväluoma ◽  
Mari Räty ◽  
Janne Kaseva ◽  
Riikka Keskinen

2021 ◽  
Vol 13 (13) ◽  
pp. 7301
Author(s):  
Marcin K. Widomski ◽  
Anna Musz-Pomorska ◽  
Wojciech Franus

This paper presents research considering hydraulic as well as swelling and shrinkage characteristics of potential recycled fine particle materials for compacted clay liner for sustainable landfills. Five locally available clay soils mixed with 10% (by mass) of NaP1 recycled zeolite were tested. The performed analysis was based on determined plasticity, cation exchange capacity, coefficient of saturated hydraulic conductivity after compaction, several shrinkage and swelling characteristics as well as, finally, saturated hydraulic conductivity after three cycles of drying and rewetting of tested specimens and the reference samples. The obtained results showed that addition of zeolite to clay soils allowed reduction in their saturated hydraulic conductivity to meet the required threshold (≤1 × 10−9 m/s) of sealing capabilities for compacted clay liner. On the other hand, an increase in plasticity, swelling, and in several cases in shrinkage, of the clay–zeolite mixture was observed. Finally, none of the tested mixtures was able to sustain its sealing capabilities after three cycles of drying and rewetting. Thus, the studied clayey soils mixed with sustainable recycled zeolite were assessed as promising materials for compacted liner construction. However, the liner should be operated carefully to avoid extensive dissication and cracking.


Environments ◽  
2021 ◽  
Vol 8 (4) ◽  
pp. 26
Author(s):  
Muhammad Rashid Iqbal ◽  
Hiniduma Liyanage Damith Nandika ◽  
Yugo Isobe ◽  
Ken Kawamoto

Gas transport parameters such as gas diffusivity (Dp/D0), air permeability (ka), and their dependency on void space (air-filled porosity, ε) in a waste body govern convective air and gas diffusion at solid waste dumpsites and surface emission of various gases generated by microbial processes under aerobic and anaerobic decompositions. In this study, Dp/D0(ε) and ka(ε) were measured on dumping solid waste in Japan such as incinerated bottom ash and unburnable mixed waste as well as a buried waste sample (dumped for 20 years). Sieved samples with variable adjusted moistures were compacted by a standard proctor method and used for a series of laboratory tests for measuring compressibility, saturated hydraulic conductivity, and gas transport parameters. Results showed that incinerated bottom ash and unburnable mixed waste did not give the maximum dry density and optimum moisture content. Measured compressibility and saturated hydraulic conductivity of tested samples varied widely depending on the types of materials. Based on the previously proposed Dp/D0(ε) models, the diffusion-based tortuosity (T) was analyzed and unique power functional relations were found in T(ε) and could contribute to evaluating the gas diffusion process in the waste body compacted at different moisture conditions.


Sign in / Sign up

Export Citation Format

Share Document