Engineering, environmental and economic performance evaluation of high-gravity carbonation process for carbon capture and utilization

2016 ◽  
Vol 170 ◽  
pp. 269-277 ◽  
Author(s):  
Shu-Yuan Pan ◽  
Ana Maria Lorente Lafuente ◽  
Pen-Chi Chiang
Keyword(s):  
Performance Evaluation ◽  
Economic Performance ◽  
Carbon Capture ◽  
High Gravity ◽  
Carbon Capture And Utilization ◽  
Carbonation Process

Economic performance evaluation of Brangus and Nellore cattle breed naturally infested with Rhipicephalus microplus in an extensive production system in Central-West Brazil

2019 ◽  
Vol 78 (4) ◽  
pp. 565-577 ◽  
Author(s):  
Paulino Bonatte Junior ◽  
Vinicius da Silva Rodrigues ◽  
Marcos Valério Garcia ◽  
Leandro de Oliveira Souza Higa ◽  
Namor Pinheiro Zimmermann ◽  
...  
Keyword(s):  
Performance Evaluation ◽  
Economic Performance ◽  
Production System ◽  
Cattle Breed ◽  
Rhipicephalus Microplus ◽  
Nellore Cattle

Current and Future Perspectives on Catalytic-based Integrated Carbon Capture and Utilization

2021 ◽  
pp. 148081
Author(s):  
Muhammad Ashraf Sabri ◽  
Samar Al Jitan ◽  
Daniel Bahamon ◽  
Lourdes F. Vega ◽  
Giovanni Palmisano
Keyword(s):  
Carbon Capture ◽  
Future Perspectives ◽  
Carbon Capture And Utilization

scholarly journals H2-CO2 polymer electrolyte fuel cell that generates power while evolving CH4 at the Pt0.8Ru0.2/C cathode

2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Shofu Matsuda ◽  
Yuuki Niitsuma ◽  
Yuta Yoshida ◽  
Minoru Umeda
Keyword(s):  
Fuel Cell ◽  
Electric Power ◽  
Polymer Electrolyte ◽  
Carbon Capture ◽  
Polymer Electrolyte Fuel Cell ◽  
Cell Temperature ◽  
Faradaic Efficiency ◽  
Carbon Capture And Utilization ◽  
Electrode Potentials ◽  
A Cell

AbstractGenerating electric power using CO2 as a reactant is challenging because the electroreduction of CO2 usually requires a large overpotential. Herein, we report the design and development of a polymer electrolyte fuel cell driven by feeding H2 and CO2 to the anode (Pt/C) and cathode (Pt0.8Ru0.2/C), respectively, based on their theoretical electrode potentials. Pt–Ru/C is a promising electrocatalysts for CO2 reduction at a low overpotential; consequently, CH4 is continuously produced through CO2 reduction with an enhanced faradaic efficiency (18.2%) and without an overpotential (at 0.20 V vs. RHE) was achieved when dilute CO2 is fed at a cell temperature of 40 °C. Significantly, the cell generated electric power (0.14 mW cm−2) while simultaneously yielding CH4 at 86.3 μmol g−1 h−1. These results show that a H2-CO2 fuel cell is a promising technology for promoting the carbon capture and utilization (CCU) strategy.

scholarly journals Mineral carbonation process of carbon dioxide using animal bone

2021 ◽  
Vol 104 (2) ◽  
pp. 003685042110196
Author(s):  
Brendon Mpofu ◽  
Hembe E Mukaya ◽  
Diakanua B Nkazi
Keyword(s):  
Carbon Dioxide ◽  
Carbon Capture ◽  
Carbon Capture And Storage ◽  
Economic Feasibility ◽  
Mineral Carbonation ◽  
Agitation Rate ◽  
Carbonation Reaction ◽  
Carbonation Process ◽  
The Cost ◽  
Cow Bone

Carbon dioxide has been identified as one of the greenhouse gases responsible for global warming. Several carbon capture and storage technologies have been developed to mitigate the large quantities of carbon dioxide released into the atmosphere, but these are quite expensive and not easy to implement. Thus, this research analyses the technical and economic feasibility of using calcium leached from cow bone to capture and store carbon dioxide through the mineral carbonation process. The capturing process of carbon dioxide was successful using the proposed technique of leaching calcium from cow shinbone (the tibia) in the presence of HCl by reacting the calcium solution with gaseous carbon dioxide. AAS and XRF analysis were used to determine the concentration of calcium in leached solutions and the composition of calcium in cow bone respectively. The best leaching conditions were found to be 4 mole/L HCl and leaching time of 6 h. Under these conditions, a leaching efficiency of 91% and a calcium conversion of 83% in the carbonation reaction were obtained. Other factors such as carbonation time, agitation rate, and carbonation reaction temperature had little effect on the yield. A preliminary cost analysis showed that the cost to capture 1 ton of CO2 with the proposed technique is about US$ 268.32, which is in the acceptable range of the capturing process. However, the cost of material used and electricity should be reviewed to reduce the preliminary production cost.

Carbon capture and utilization technologies: a literature review and recent advances

2018 ◽  
Vol 41 (12) ◽  
pp. 1403-1433 ◽  
Author(s):  
Francisco M. Baena-Moreno ◽  
Mónica Rodríguez-Galán ◽  
Fernando Vega ◽  
Bernabé Alonso-Fariñas ◽  
Luis F. Vilches Arenas ◽  
...  
Keyword(s):  
Literature Review ◽  
Carbon Capture ◽  
Carbon Capture And Utilization ◽  
Recent Advances

scholarly journals Performance evaluation of power-operated reapers for harvesting rice at farmers’ field

2018 ◽  
Vol 16 (1) ◽  
pp. 144-150
Author(s):  
Md Ashraful Alam ◽  
Anwar Hossen ◽  
AKM Saiful Islam ◽  
Monjurul Alam
Keyword(s):  
Performance Evaluation ◽  
Economic Performance ◽  
Production Cost ◽  
Field Capacity ◽  
Production Costs ◽  
High Wage ◽  
Harvesting Time ◽  
Actual Field ◽  
Field Efficiency ◽  
User Friendly

Harvesting is one of the major labor intensive works in rice cultivation. Appropriate harvesting machinery is urgently needed to reduce labor and production costs. Production cost of rice becomes high due to labor shortage and high wage rate during harvesting time. Techno-economic performance of Korean self-propelled reaper (KR), China self-propelled reaper (CR) and BRRI reaper (BR) were evaluated in order to identify the field constrains and problems of the reapers at Mithapukur of Rangpur, Bangladesh during Aman season of 2013. The actual field capacities of the KR, CR and BR were found 0.18, 0.17 and 0.15 ha h–1with the corresponding field efficiency of 55, 68 and 56%, respectively. The variation of field capacity among the models was due to turning time losses, weight of the reaper and operator’s skill. The fuel consumption of the reapers was 4.11, 2.61 and 8.39 l ha–1 for KR, CR and BR, respectively. The shattering loss of paddy harvesting was 1.66, 1.50 and 1.45% for KR, CR and BR, respectively. The break-even area of the reapers was 9.15, 7.82 and 8.43 ha yr-1 for KR, CR and BR, respectively. It is evident that the reaper could be used successfully as labor saving and user friendly technology to eliminate post-harvest problems in Bangladesh.J. Bangladesh Agril. Univ. 16(1): 144-150, April 2018

Sign in / Sign up

Export Citation Format

Share Document