Essential oil and fatty acid composition of the fruits of Hippophae rhamnoides L. (Sea Buckthorn) and Myrtus communis L. from Turkey

2004 ◽  
Vol 32 (9) ◽  
pp. 809-816 ◽  
Author(s):  
Ahmet Cakir
PLoS ONE ◽  
2012 ◽  
Vol 7 (4) ◽  
pp. e34099 ◽  
Author(s):  
Tahira Fatima ◽  
Crystal L. Snyder ◽  
William R. Schroeder ◽  
Dustin Cram ◽  
Raju Datla ◽  
...  

2014 ◽  
Vol 12 ◽  
pp. 126-130 ◽  
Author(s):  
Ch Otgonbayar ◽  
B Matthaus ◽  
P Odonmajig

The content and composition of lipids isolated from seed and pulp of sea buckthorn were investigated. Fatty acids and sterols were analyzed by CGC while tocopherols were analyzed by HPLC. 12.67% glyceride was found in the seed. The oil of sea buckthorn seed oil showed low levels of saturated fatty acids in comparison with the buckthorn pulp oil. Palmitic (7.13%), oleic (15.85%), linoleic (36.9%) and linolenic acids (31.11%) predominated in the seed oil. Palmitic (29.17%), palmitoleic (32.86%), oleic (4.92%), vaccenic (9.35%) and linoleic (16.08%) fatty acid was dominating in the pulp oil. The primary tocopherol of sea buckthorn seed and pulp oil were α- tocopherol and γ-tocopherol (46.54mg/100g, 59.02mg/100g). Seed oil contains more (94.34mg/100g) total sterols than pulp (90.25mg/100g) oil.DOI: http://dx.doi.org/10.5564/mjc.v12i0.187 Mongolian Journal of Chemistry Vol.12 2011: 126-130 


Plants ◽  
2021 ◽  
Vol 10 (5) ◽  
pp. 847
Author(s):  
Anita Zapałowska ◽  
Natalia Matłok ◽  
Miłosz Zardzewiały ◽  
Tomasz Piechowiak ◽  
Maciej Balawejder

The aim of this research was to show the effect of the ozonation process on the quality of sea buckthorn (Hippophae rhamnoides L.). The quality of the ozonated berries of sea buckthorn was assessed. Prior to and after the ozone treatment, a number of parameters, including the mechanical properties, moisture content, microbial load, content of bioactive compounds, and composition of volatile compounds, were determined. The influence of the ozonation process on the composition of volatile compounds and mechanical properties was demonstrated. The ozonation had negligible impact on the weight and moisture of the samples immediately following the treatment. Significant differences in water content were recorded after 7 days of storage. It was shown that the highest dose of ozone (concentration and process time) amounting to 100 ppm for 30 min significantly reduced the water loss. The microbiological analyses showed the effect of ozone on the total count of aerobic bacteria, yeast, and mold. The applied process conditions resulted in the reduction of the number of aerobic bacteria colonies by 3 log cfu g−1 compared to the control (non-ozonated) sample, whereas the number of yeast and mold colonies decreased by 1 log cfu g−1 after the application of 100 ppm ozone gas for 30 min. As a consequence, ozone treatment enhanced the plant quality and extended plant’s storage life.


Sign in / Sign up

Export Citation Format

Share Document