Al0.97Y0.03PO4 thermal radiation material with enhanced infrared emissivity

2020 ◽  
Vol 46 (2) ◽  
pp. 2010-2015
Author(s):  
Na Li ◽  
Xia Huang ◽  
Da Wang ◽  
Junfeng Wang ◽  
Chang He ◽  
...  
2021 ◽  
Vol 14 (0) ◽  
pp. E20-006-1-E20-006-4
Author(s):  
Maki Ito ◽  
Takashi Ando ◽  
Naoki Maruyama ◽  
Takanobu Kobayashi ◽  
Yoshitaka Takezawa

2014 ◽  
Vol 692 ◽  
pp. 337-340
Author(s):  
Xi Li Yu ◽  
Lin Ping Zhang ◽  
Yi Zhong ◽  
Hong Xu ◽  
Zhi Ping Mao

Effects of La content on the infrared stealth of ZnO: (La, Al) coated cotton fabrics were studied through XRD, SEM, ICP, IR_2 dual-band emissivity measuring instrument and the infrared camera instrument, where the content of Al remained unchanged. It was suggested the doping of Al and La was favorable for providing more free electrons, improving scattering of infrared photon, and decreasing the infrared emissivity of ZnO: (La, Al) coated fabric in the range of 8-14μm wavelengths. Thermography indicated that ZnO: (La, Al) coated fabric gave as low thermal radiation as the environment.


2013 ◽  
Vol 316-317 ◽  
pp. 968-974
Author(s):  
Nan Ding ◽  
Jian Guang Xie ◽  
Lei Lei Liang ◽  
Ye Hu ◽  
He Xiao ◽  
...  

A new kind of infrared powder has been prepared to enhance the thermal radiation properties of the lower-heat-storage asphalt concrete. Tests have determined the most suitable ratio of four kinds of transition metal oxides in CM infrared powder, adjusted the sintering process parameters to improve the infrared emissivity, investigated the grain-size effect on its emissivity, and evaluated the thermal radiation properties of the asphalt concrete. The results show that the adding of transition metal oxides can effectively improve the infrared property of CM powder in the wave band from 8μm to 14μm at 25°C. Each sintering process parameter has effect on the infrared emissivity in varying degrees. Besides, the emissivity of infrared powder increases with particle size decreases before the size approaches nanoscale. According to the best mixing proportion and the sintering process parameters adjusted, CM-β infrared powder with average particle size of 18μm is prepared, and its emissivity in the wave band from 8μm to 14μm is 0.044 higher than CM powder. The thermal radiation test shows that the surface temperature of the asphalt mortar mixed with CM-β powder is 3.96°C lower than the one with CM powder.


Author(s):  
Ahmed M Abdel-Ghanya ◽  
Ibrahim M Al-Helal

Plastic nets are extensively used for shading purposes in arid regions such as in the Arabian Peninsula. Quantifying the convection exchange with shading net and understanding the mechanisms (free, mixed and forced) of convection are essential for analyzing energy exchange with shading nets. Unlike solar and thermal radiation, the convective energy, convective heat transfer coefficient and the nature of convection have never been theoretically estimated or experimentally measured for plastic nets under arid conditions. In this study, the convected heat exchanges with different plastic nets were quantified based on an energy balance applied to the nets under outdoor natural conditions. Therefore, each net was tacked onto a wooden frame, fixed horizontally at 1.5-m height over the floor. The downward and upward solar and thermal radiation fluxes were measured below and above each net on sunny days; also the wind speed over the net, and the net and air temperatures were measured, simultaneously. Nets with different porosities, colors and texture structures were used for the study. The short and long wave’s radiative properties of the nets were pre-determined in previous studies to be used. Re and Gr numbers were determined and used to characterize the convection mechanism over each net. The results showed that forced and mixed convection are the dominant modes existing over the nets during most of the day and night times. The nature of convection over nets depends mainly on the wind speed, net-air temperature difference and texture shape of the net rather than its color and its porosity.


Sign in / Sign up

Export Citation Format

Share Document