A Contribution to Flotation Technique as a Reliable Wettability Alteration Measurement method for Carbonate Minerals in Separation Processes Involving Hydrocarbons, Low Salinity Water and Nanofluids

Author(s):  
Mehdi Sadeghi ◽  
Rohallah Hashemi ◽  
Hamidreza Shahverdi
RSC Advances ◽  
2020 ◽  
Vol 10 (69) ◽  
pp. 42570-42583
Author(s):  
Rohit Kumar Saw ◽  
Ajay Mandal

The combined effects of dilution and ion tuning of seawater for enhanced oil recovery from carbonate reservoirs. Dominating mechanisms are calcite dissolution and the interplay of potential determining ions that lead to wettability alteration of rock surface.


Fuel ◽  
2020 ◽  
Vol 271 ◽  
pp. 117675 ◽  
Author(s):  
Yongqiang Chen ◽  
Nilesh Kumar Jha ◽  
Duraid Al-Bayati ◽  
Maxim Lebedev ◽  
Mohammad Sarmadivaleh ◽  
...  

2018 ◽  
Vol 58 (1) ◽  
pp. 51 ◽  
Author(s):  
Tammy Amirian ◽  
Manouchehr Haghighi

Low salinity water (LSW) injection as an enhanced oil recovery method has attracted much attention in the past two decades. Previously, it was found that the presence of clay such as kaolinite and water composition like the nature of cations affect the enhancement of oil recovery under LSW injection. In this study, a pore-scale visualisation approach was developed using a 2D glass micromodel to investigate the impact of clay type and water composition on LSW injection. The glass micromodels were coated by kaolinite and illite. A meniscus moving mechanism was observed and the oil–water interface moved through narrow throats to large bodies, displacing the wetting phase (oil phase). In the presence of kaolinite, the effect of LSW injection was reflected in the change to the wettability with a transition towards water-wetness in the large sections of the pore walls. The advance of the stable water front left behind an oil film on the oil-wet portions of pore walls; however, in water-wet surfaces, the interface moved towards the surface and replaced the oil film. As a result of wettability alteration towards a water-wet state, the capillary forces were not dominant throughout the system and the water–oil menisci displaced oil in large portions of very narrow channels. This LSW effect was not observed in the presence of illite. With regard to the water composition effect, systems containing divalent cations like Ca2+ showed the same extent of recovery as those containing only monovalent ions. The observation indicates a significant role of cation exchange in wettability alteration. Fines migration was insignificant in the observations.


2016 ◽  
Vol 34 (15) ◽  
pp. 1345-1351 ◽  
Author(s):  
Erfan Sadatshojaei ◽  
Mohammad Jamialahmadi ◽  
Feridun Esmaeilzadeh ◽  
Mohammad Hossein Ghazanfari

2011 ◽  
Author(s):  
Ramez A. Nasralla ◽  
Mohammed Abdullah Bataweel ◽  
Hisham A. Nasr-El-Din

2020 ◽  
Vol 10 (5) ◽  
pp. 6328-6342 ◽  

Low salinity water in the oil reservoirs changes the wettability and increases the oil recovery factor. In sandstone reservoirs, the sand production occurs or intensifies with wettability alteration due to low salinity water injection. In any case, sand production should be stopped and there are many ways to prevent sand production. By modifying the composition of low salinity water, it can be adapted to be more compatible with the reservoir rock and formation water, which has the least formation damage. By eliminating magnesium and calcium ions, smart soft water (SSW) is created which is economically suitable for injection into the reservoirs. By stabilizing the nanoparticles in SSW, nanofluids can be prepared which with injection into the sandstones reservoir increase the oil recovery, change the wettability and increase the rock strength. In this present, SSW composition was determined by compatibility testing, and the SiO2 nanoparticle with 1000 ppm concentration was stabilized in SSW. Eight thin sections were oil wetted by using normal heptane solution and different molars of stearic acid and two thin sections were considered as base thin sections to compare the effect of wettability alteration on sand production. Thin sections were immersed in SSW and Nanofluid, the amount of contact angle and sand production were measured in both cases. The amount of sand produced and the contact angle in SSW was higher than the Nanofluid. The silica nanoparticles reduced the contact angle (more water wetting) and by sitting between the sand particles, more than 40%, it reduced sand production.


Author(s):  
Dhrubajyoti Neog

AbstractLow salinity water flooding (LSWF) is a promising strategy for improving oil recovery in sandstone reservoirs, and recent studies have shown that the recovery with low salinity water injection is a function of not only the salinity and ionic composition but also of the pH of injected brine, temperature, and the combined effect of both on the wetting properties of the clay mineral surfaces. Following brine flooding, the initial wettability of sandstone rock surfaces existed when crude oil, formation water (FW), and rock surface interaction were in chemical equilibrium at reservoir condition changes based on brine pH, salinity, temperature, and clay mineralogy. This study proposes pH, core flood temperature, and irreducible water saturation as key parameters in inducing wettability changes in the sandstone porous media. In the present work, the sandstone cores were subjected to flooding at temperatures of 70 °C, 85 °C, and 105 °C and measured the pH of the discharge effluents and initial or irreducible water saturation with respect to varying temperatures. This paper investigates the rise of the pH gradient and irreducible water saturation, Swir with respect to LS flooding, at increasing temperatures using a Barail sandstone core. The key results include the following: The pH of the flood effluents increases with increasing core flood temperature, which indicates a shifting of the existing wetting state of the rock. The combined effects of increasing pH and initial or irreducible water saturation pertaining to low salinity flooding at progressively increasing temperatures result in increasing water wettability of the sandstone rock. Increasing flooding temperatures cause an increase in Swir, which follows a linear relationship. The findings of the paper highlight the link of increasing pH and irreducible water saturation with the water wetting properties of the sandstone reservoir rock and hence the fluid flow or the oil–water relative permeability behaviour. This paper proposes that increased irreducible water saturation and pH of water flood effluents are connected to increasing water wetness in a sandstone rock as a function of elevated temperatures. As adequate work and consensus on the potential effects of temperature on wettability alteration under low salinity water flooding is still lacking, the current work in relation to the Barail sandstone of the upper Assam basin could be a novel reference for understanding of the importance of temperature dependent wettability alteration behaviour in sandstone cores. The findings of this study can assist in the formation of a novel approach towards considering the increasing irreducible water saturation and pH of the brine effluent as an effect of alternatively injection of low salinity water at elevated temperatures on sandstone porous rock.


Sign in / Sign up

Export Citation Format

Share Document