Effect of upflow velocity on the performance of a fluidized bed reactor to remove phosphate from simulated swine wastewater

2019 ◽  
Vol 140 ◽  
pp. 78-83 ◽  
Author(s):  
Kangning Xu ◽  
Lin Ge ◽  
Chengwen Wang
2005 ◽  
Vol 486-487 ◽  
pp. 387-390 ◽  
Author(s):  
Chan Won Lee ◽  
H.B Kwon ◽  
Young Jin Kim ◽  
Hong Pyo Jeon

Nutrient removal and recovery from wastewater is being challenged to avoid eutrophication problems, and the discharge standards have also been tightened by water regulations. Therefore, this study was undertaken to recover the nutrients from both synthetic wastewater and swine wastewater in a fluidized bed reactor (FBR). The operational parameters were changed to find out the optimum conditions for struvite formation. The most suitable pH was identified around pH 9. When the molar ratio of magnesium as Mg: P was 2:1 in the FBR, the removal efficiency of NH4-N and PO4-P was 79 and 90 %, respectively. The seed material was effective to form struvite in the condition of 30 g dosage. Struvite crystallization in reaction was completed in 20 minutes. The growth of struvite crystals was confirmed by the analysis of XRD, FT-IR and TG-DTA. In addition, the struvite was successfully recovered when the optimum conditions were applied to the swine wastewater.


2004 ◽  
Vol 4 (5-6) ◽  
pp. 21-28
Author(s):  
S.-C. Kim ◽  
D.-K. Lee

TiO2-coated granular activated carbon was employed for the removal of toxic microcystin-LR from water. High surface area of the activated carbon provided sites for the adsorption of microcystin-LR, and the adsorbed microcystin-LR migrated continuously onto the surface of TiO2 particles which located mainly at the exterior surface in the vicinity of the entrances of the macropores of the activated carbon. The migrated microcystin-LR was finally degraded into nontoxic products and CO2 very quickly. These combined roles of the activated carbon and TiO2 showed a synergistic effect on the efficient degradation of toxic microcystin-LR. A continuous flow fluidized bed reactor with the TiO2-coated activated carbon could successfully be employed for the efficient photocatalytic of microcystin-LR.


1989 ◽  
Vol 21 (4-5) ◽  
pp. 157-165 ◽  
Author(s):  
F. Ehlinger ◽  
J. M. Audic ◽  
G. M. Faup

The characterization of the biofilm of an anaerobic fluidized-bed reactor was completed under standard conditions. The distribution of the fixed protein concentration depended on the level in the reactor. The protein concentration reached 1520 µg.g−1 of support at the top of the reactor and only 1200 µg.g−1 at the bottom after 504 hours of operation but the specific activity of the biofilm was 33×10−4 µM acetate.h−1.mg−1 proteins at the bottom and only 26×10−4 µM.h−1.mg−1 at the top. The efficiency of a fluidized bed reactor and the composition of the biofilm changed with an increase of the pH from 7 to 8.5 during the seeding of the support material. Future development of the biofilm and the specific activity of the support were affected.


1993 ◽  
Vol 28 (2) ◽  
pp. 135-144 ◽  
Author(s):  
S. Matsui ◽  
R. Ikemoto Yamamoto ◽  
Y. Tsuchiya ◽  
B. Inanc

Using a fluidized bed reactor, experiments on glucose decomposition with and without sulfate reduction were conducted. Glucose in the reactor was mainly decomposed into lactate and ethanol. Lactate was mainly decomposed into propionate and acetate, while ethanol was decomposed into propionate, acetate, and hydrogen. Sulfate reduction was not involved in the decomposition of glucose, lactate, and ethanol, but was related to propionate and acetate decomposition. The stepwise reactions were modeled using either a Monod expression or first order reaction kinetics in respect to the reactions. The coefficients of the kinetic equations were determined experimentally. The modified Monod and first order reaction equations were effective at predicting concentrations of glucose, lactate, ethanol, propionate, acetate, and sulfate along the beight of the reactor. With sulfate reduction, propionate was decomposed into acetate, while without sulfate reduction, accumulation of propionate was observed in the reactor. Sulfate reduction accelerated propionate conversion into acetate by decreasing the hydrogen concentration.


2004 ◽  
Vol 49 (11-12) ◽  
pp. 215-222 ◽  
Author(s):  
M. Herzberg ◽  
C.G. Dosoretz ◽  
S. Tarre ◽  
M. Beliavski ◽  
M. Green

To show that an adsorbing biofilm carrier (GAC) can be advantageous for atrazine bioremediation over a non-adsorbing carrier, fluidized bed (FB) reactors were operated under atrazine limiting concentrations using Pseudomonas sp. strain ADP as the atrazine degrading bacteria. The following interrelated subjects were investigated: 1) atrazine adsorption to GAC under conditions of atrazine partial penetration in the biofilm, 2) differences in atrazine degradation rates and 3) stability of atrazine biodegradation under non-sterile anoxic conditions in the GAC reactor versus a reactor with a non-adsorbing biofilm carrier. Results from batch adsorption tests together with modeling best described the biofilm as patchy in nature with covered and non-biofilm covered areas. Under conditions of atrazine partial penetration in the biofilm, atrazine adsorption occurs in the non-covered areas and is consequently desorbed at the base of the biofilm substantially increasing the active biofilm surface area. The double flux of atrazine to the biofilm in the GAC reactor results in lower effluent atrazine concentrations as compared to a FB reactor with a non-adsorbing carrier. Moreover, under non-sterile denitrification conditions, atrazine degradation stability was found to be much higher (several months) using GAC as a biofilm carrier while non-adsorbing carrier reactors showed sharp deterioration within 30 days due to contamination of non-atrazine degrading bacteria.


Vacuum ◽  
2004 ◽  
Vol 73 (3-4) ◽  
pp. 505-510 ◽  
Author(s):  
Metin Usta ◽  
Izzet Oney ◽  
Muzaffer Yildiz ◽  
Yilmaz Akalin ◽  
Ahmet Hikmet Ucisik

Sign in / Sign up

Export Citation Format

Share Document