scholarly journals Overcurrent protection against multi-phase faults in MV networks based on negative and zero sequence criteria

Author(s):  
Jerzy Andruszkiewicz ◽  
Józef Lorenc ◽  
Bogdan Staszak ◽  
Agnieszka Weychan ◽  
Beata Zięba
2020 ◽  
Vol 35 (3) ◽  
pp. 1476-1487
Author(s):  
Neng Jin ◽  
Jiawei Xing ◽  
Xiangning Lin ◽  
Peifu Zhang ◽  
Zirui Rong ◽  
...  

2022 ◽  
Vol 8 ◽  
pp. 1257-1263
Author(s):  
Yuanlin Pan ◽  
Zhichang Liu ◽  
Xin Yin ◽  
Wei Xi ◽  
Xianggen Yin ◽  
...  

Vestnik IGEU ◽  
2019 ◽  
pp. 31-39 ◽  
Author(s):  
O.A. Dobryagina ◽  
V.V. Tyutikov ◽  
T.Yu. Shadrikova ◽  
V.A. Shuin

Simple and reliable zero sequence overcurrent protection in distribution 6–10 kV cable networks with an insulated neutral is most widely used for protection against single phase earth faults. However, protection of this type in many cases does not provide the required sensitivity to internal (inside the protected zone) faults as it must be tuned to the response current from surge transients during external faults through an intermittent arc. It is possible to increase the sensitivity if adaptive current protection is applied. However, the known methods for its implementation are only effective for stable faults through transient resistance but do not provide high dynamic stability of operation in transient conditions in case of arc intermittent earth faults that are the most dangerous for the network. Therefore, an urgent problem to be solved now is improving the principles of adaptive current protection against earth faults. To compare the efficiency of the known and proposed principles of adaptive current protection implementation taking into account the complexity of transients during earth faults through an intermittent arc in 6–10 kV cable networks, we used Matlab simulation with the SimPowerSystem and Simulink extension packages. The research into the operation algorithms of adaptive current protection against earth faults was carried out on simulation models of 6–10 kV cable networks with an insulated neutral and with neutral grounding through a high-value resistor. The studies on the simulation models have shown that the known methods of implementation of adaptive current protection against earth faults based on the use of full zero sequence currents and voltage are ineffective during intermittent arc earth faults. The authors propose a method of adaptive current protection against earth faults in 6–10 kV cable networks with an insulated neutral and with neutral grounding through a high-value resistor that provides a significant increase in dynamic stability of transient operation with arc ground faults and allows using only zero sequence current and voltage components of the operating frequency of 50 Hz as the actuating quantities. The proposed method of implementing adaptive current protection against earth faults in 6–10 kV cable networks with an insulated neutral and with neutral grounding through a high-value resistor does not only increase the sensitivity of this protection type to earth faults through transient resistence and dynamic stability of operation in transient condiitons in case of arc intermittent earth faults but also broadens the range of its possible applications


Energies ◽  
2019 ◽  
Vol 12 (15) ◽  
pp. 2911 ◽  
Author(s):  
Wenbin Cao ◽  
Xianggen Yin ◽  
Yongxin Chen ◽  
Yuanlin Pan ◽  
Xiangyuan Yin ◽  
...  

In recent years, the zero-mode inrush current of high-impedance transformer with built-in high-voltage winding (T-Hin), which has large amplitude and decays slowly, causes the misoperation of zero-sequence overcurrent protection. Compared with magnetizing inrush current, the waveform of zero-mode inrush current is inconsistent and irregular, and few researches have proposed the mathematical analysis as well as the improved protection using waveform characteristics. In this paper, the mathematical expression of transformer zero-mode inrush current is derived. Further considering the parameter differences, the zero-mode inrush current of T-Hin is larger, which tends to cause the misoperation. The mathematical waveforms fit well with the recorded waveforms. Both recorded waveforms and mathematical waveforms in various conditions prove that the second harmonic ratio (the ratio between the second harmonic and first harmonic) of zero-mode inrush current is significant. Based on the above analysis, a criterion based on the second harmonic ratio restraint of zero-mode inrush current is proposed. If the second harmonic ratio exceeds the setting value, it is considered that the inrush current is generated and sends a signal to restrain the protection. The theoretical setting value of the proposed criterion and the practical engineering method for determining the setting value are obtained.


Energies ◽  
2019 ◽  
Vol 12 (14) ◽  
pp. 2733 ◽  
Author(s):  
Carlos Candelo-Zuluaga ◽  
Jordi-Roger Riba ◽  
Carlos López-Torres ◽  
Antoni Garcia

Inter-turn winding faults in five-phase ferrite-permanent magnet-assisted synchronous reluctance motors (fPMa-SynRMs) can lead to catastrophic consequences if not detected in a timely manner, since they can quickly progress into more severe short-circuit faults, such as coil-to-coil, phase-to-ground or phase-to-phase faults. This paper analyzes the feasibility of detecting such harmful faults in their early stage, with only one short-circuited turn, since there is a lack of works related to this topic in multi-phase fPMa-SynRMs. Two methods are tested for this purpose, the analysis of the spectral content of the zero-sequence voltage component (ZSVC) and the analysis of the stator current spectra, also known as motor current signature analysis (MCSA), which is a well-known fault diagnosis method. This paper compares the performance and sensitivity of both methods under different operating conditions. It is proven that inter-turn faults can be detected in the early stage, with the ZSVC providing more sensitivity than the MCSA method. It is also proven that the working conditions have little effect on the sensitivity of both methods. To conclude, this paper proposes two inter-turn fault indicators and the threshold values to detect such faults in the early stage, which are calculated from the spectral information of the ZSVC and the line currents.


Author(s):  
J. S. Lally ◽  
L. E. Thomas ◽  
R. M. Fisher

A variety of materials containing many different microstructures have been examined with the USS MVEM. Three topics have been selected to illustrate some of the more recent studies of diffraction phenomena and defect, grain and multi-phase structures of metals and minerals.(1) Critical Voltage Effects in Metals and Alloys - This many-beam dynamical diffraction phenomenon, in which some Bragg resonances vanish at certain accelerating voltages, Vc, depends sensitively on the spacing of diffracting planes, Debye temperature θD and structure factors. Vc values can be measured to ± 0.5% in the HVEM ana used to obtain improved extinction distances and θD values appropriate to electron diffraction, as well as to probe local bonding effects and composition variations in alloys.


Sign in / Sign up

Export Citation Format

Share Document