Temperature dependent transport characterization of iron on n-type (111) Si0.65Ge0.35 Schottky diodes

2018 ◽  
Vol 763 ◽  
pp. 173-179 ◽  
Author(s):  
D. Hamri ◽  
A. Teffahi ◽  
A. Djeghlouf ◽  
A. Saidane ◽  
A. Mesli
2011 ◽  
Vol 1300 ◽  
Author(s):  
A. F. Isakovic ◽  
S. D. Sulejmanovic ◽  
T. P. Mihac ◽  
K. Evans-Lutterodt

ABSTRACTThree families of NixZry (x = 28, 36, 38, x + y = 100%) metallic glasses were prepared and examined using X-ray, temperature dependent transport and magnetic field. X-ray characterization shows characteristic diffuse spectrum, except for narrow regions of control samples, where partial crystallization was induced in finite small volumes. Magnetic properties confirm spin-fluctuating paramagnetic-like behavior, which we asses from preliminary Hall coefficient measurements, which is quantitatively different in three sample families. Temperature dependent AC and DC transport measurements were conducted in a broad temperature range from 70 K to 700 K, finding both quantitative and semi-qualitative differences between samples with different Ni/Zr ratio.


2019 ◽  
Vol 49 (3) ◽  
pp. 1993-2002
Author(s):  
Manuel A. Hernández-Ochoa ◽  
Humberto Arizpe-Chávez ◽  
Rafael Ramírez-Bon ◽  
Alain Pérez-Rodríguez ◽  
Manuel Cortez-Valadez ◽  
...  

Genetics ◽  
2003 ◽  
Vol 164 (2) ◽  
pp. 487-499 ◽  
Author(s):  
Sophie Zuber ◽  
Michael J Hynes ◽  
Alex Andrianopoulos

AbstractThe opportunistic human pathogen Penicillium marneffei exhibits a temperature-dependent dimorphic switch. At 25°, multinucleate, septate hyphae that can undergo differentiation to produce asexual spores (conidia) are produced. At 37° hyphae undergo arthroconidiation to produce uninucleate yeast cells that divide by fission. This work describes the cloning of the P. marneffei gasC gene encoding a G-protein α-subunit that shows high homology to members of the class III fungal Gα-subunits. Characterization of a ΔgasC mutant and strains carrying a dominant-activating gasCG45R or a dominant-interfering gasCG207R allele show that GasC is a crucial regulator of germination. A ΔgasC mutant is severely delayed in germination, whereas strains carrying a dominant-activating gasCG45R allele show a significantly accelerated germination rate. Additionally, GasC signaling positively affects the production of the red pigment by P. marneffei at 25° and negatively affects the onset of conidiation and the conidial yield, showing that GasC function overlaps with functions of the previously described Gα-subunit GasA. In contrast to the S. cerevisiae ortholog Gpa2, our data indicate that GasC is not involved in carbon or nitrogen source sensing and plays no major role in either hyphal or yeast growth or in the switch between these two forms.


1985 ◽  
Vol 5 (7) ◽  
pp. 609-614 ◽  
Author(s):  
A. Lodola

The uptake and intracellular distribution of haem by isolated rat hepatocyte suspensions was studied. An increase in cell haem content occurred after a challenge with 5, 10 or 20 μM haem, supplied as methaemalbumin. The rate of haem uptake was temperature dependent; no non-specific binding occurred. Intracellular haem distribution data are consistent with a rapid association of haem with the endoplasmic reticulum fraction prior to its accumulation in the cytosol and at the mitochondrion.


Author(s):  
C. Ballesteros ◽  
J. A. Garci´a ◽  
M. I. Orti´z ◽  
R. Rodri´guez ◽  
M. Varela

A detailed tribological characterization of low-energy, nitrogen implanted V5 at. %Ti alloy is presented. Samples were nitrogen-implanted at an accelerating voltage of 1.2 kV and 1 mA/cm2, up to a dose of 1E19 ions/cm2. The tribological properties of the alloys: microhardness, friction coefficient and wear resistance, have improved after ion implantation and this improvement increases as the implantation temperature increases. The microstructure of the alloys were analysed by transmission electron microscopy. A direct correlation between structural modifications of the nitrogen implanted layer and the improvement in their tribological properties is obtained. For samples implanted at 848 K a nanocomposite layer where the reinforcement particles are TiN precipitates forms. TiN precipitation appears as the responsible of the improvement in the tribological properties.


Sign in / Sign up

Export Citation Format

Share Document