Characterization of CuCl quantum dots grown in NaCl single crystals via optical measurements, X-ray diffraction, and transmission electron microscopy

2018 ◽  
Vol 490 ◽  
pp. 84-88 ◽  
Author(s):  
Kensuke Miyajima ◽  
Tatsuro Akatsu ◽  
Ken Itoh
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Quantum Dots ◽  
Single Crystals ◽  
Optical Measurements ◽  
X Ray Diffraction ◽  
X Ray ◽  
Transmission Electron

Synthesis and Characterization of Graphene/Cu2SnS3 Quantum Dots Composites

2012 ◽  
Vol 624 ◽  
pp. 59-62 ◽  
Author(s):  
Cai Xia Li ◽  
Jun Guo ◽  
Danyu Jiang ◽  
Qiang Li
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Quantum Dots ◽  
Raw Materials ◽  
Synthesis And Characterization ◽  
X Ray Diffraction ◽  
X Ray ◽  
Phase Structures ◽  
Transmission Electron

In this paper, employing Cu(AC)2•H2O, SnCl2•2H2O and thiourea as raw materials, the composites of graphene/Cu2SnS3 quantum dots (QDs) were prepared simply and quickly using the hydrothermal method. Meanwhile, the separate Cu2SnS3 QDs were also synthesized in the same way. The as-obtained Cu2SnS3 QDs and composites’ phase structures were analyzed and characterized by powder X-ray diffraction (XRD), and the results indicated that the size of the Cu2SnS3 QDs in the composites were less than that of the separate Cu2SnS3 QDs. At the same time, their morphologies were also observed and cross-confirmed by Transmission Electron Microscopy (TEM), and the measurements manifested that Cu2SnS3 QDs were uniformly dispersed on the surface of the graphene, while the separate Cu2SnS3 QDs have obvious glomeration. In addition to this, elemental analysis was also made to verify the existence of Cu2SnS3 on the surface of graphene.

Detonation Synthesis of Nano-Size Materials

1995 ◽  
Vol 418 ◽  
Author(s):  
J. Forbes ◽  
J. Davis ◽  
C. Wong
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Nucleation And Growth ◽  
Detonation Synthesis ◽  
X Ray Diffraction ◽  
Crystalline Materials ◽  
X Ray ◽  
Transmission Electron ◽  
Nano Size

AbstractThe detonation of explosives typically creates 100's of kbar pressures and 1000's K temperatures. These pressures and temperatures last for only a fraction of a microsecond as the products expand. Nucleation and growth of crystalline materials can occur under these conditions. Recovery of these materials is difficult but can occur in some circumstances. This paper describes the detonation synthesis facility, recovery of nano-size diamond, and plans to synthesize other nano-size materials by modifying the chemical composition of explosive compounds. The characterization of nano-size diamonds by transmission electron microscopy and electron diffraction, X-ray diffraction and Raman spectroscopy will also be reported.

Hydrothermal Synthesis and Characterization of BiFeO3 Polyhedral Crystallites

2012 ◽  
Vol 174-177 ◽  
pp. 508-511
Author(s):  
Lin Lin Yang ◽  
Yong Gang Wang ◽  
Yu Jiang Wang ◽  
Xiao Feng Wang
Keyword(s):  
Electron Microscopy ◽  
Scanning Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Synthesis And Characterization ◽  
X Ray Diffraction ◽  
Xrd Pattern ◽  
X Ray ◽  
Transmission Electron ◽  
Scanning Electron

BiFeO3 polyhedrons had been successfully synthesized via a hydrothermal method. The as-prepared products were characterized by power X-ray diffraction (XRD) pattern, scanning electron microscopy (SEM) and transmission electron microscopy (TEM). The possible mechanisms for the formation of BiFeO3 polyhedrons were discussed. Though comparison experiments, it was found that the kind of precursor played a key role on the morphology control of BiFeO3 crystals.

Optical properties and energy transfer processes in Tb3+-doped ZnSe quantum dots

2021 ◽  
Author(s):  
Nguyen Ca ◽  
N. D Vinh ◽  
Phan Van Do ◽  
N. T. Hien ◽  
Xuan Hoa Vu ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Quantum Dots ◽  
Chemical Method ◽  
X Ray Diffraction ◽  
Wet Chemical Method ◽  
X Ray ◽  
Transfer Processes ◽  
Transmission Electron ◽  
Wet Chemical

Tb3+-doped ZnSe quantum dots (QDs) with Tb content in the range of 0.5 - 7% were successfully synthesized by a wet chemical method. X-ray diffraction (XRD) and transmission electron microscopy...

Microstructure characteristics of non-monodisperse quantum dots: on the potential of transmission electron microscopy combined with X-ray diffraction

CrystEngComm ◽  
2020 ◽  
Vol 22 (21) ◽  
pp. 3644-3655
Author(s):  
Stefan Neumann ◽  
Christina Menter ◽  
Ahmed Salaheldin Mahmoud ◽  
Doris Segets ◽  
David Rafaja
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Quantum Dots ◽  
Cdse Quantum Dots ◽  
X Ray Diffraction ◽  
X Ray ◽  
Microstructure Characteristics ◽  
Scale Bridging ◽  
Transmission Electron ◽  
Hot Injection

Capability of TEM and XRD to reveal scale-bridging information about the microstructure of non-monodisperse quantum dots is illustrated on the CdSe quantum dots synthesized using an automated hot-injection method.

Growth and Characterization of Misostructural Zinc Oxide Tubes

2005 ◽  
Vol 23 ◽  
pp. 293-296
Author(s):  
X.W. Sun ◽  
C.X. Xu ◽  
B.J. Chen ◽  
Y. Yang
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Zinc Oxide ◽  
Growth Process ◽  
Hexagonal Structure ◽  
Metallic Zinc ◽  
X Ray Diffraction ◽  
X Ray ◽  
Transmission Electron

Zinc oxide (ZnO) microtube has been fabricated by heating the mixture of ZnO and graphite powders in the atmosphere. The ZnO microtubes showed perfect hexagonal profiles with bell-mouth or normal hexagonal tops. Both X-ray diffraction (XRD) and high-resolution transmission electron microscopy (TEM) demonstrated that the product was composed of ZnO with typical hexagonal structure grown predominantly along (002) direction. The growth process was interpreted by means of vaporliquid-solid mechanism combining with the evaporation of metallic zinc.

Sign in / Sign up

Export Citation Format

Share Document