Domestic hot water consumption pattern: Relation with total water consumption and air temperature

2022 ◽  
Vol 157 ◽  
pp. 112035
Author(s):  
I. Meireles ◽  
V. Sousa ◽  
B. Bleys ◽  
B. Poncelet
2019 ◽  
Vol 39 (1) ◽  
Author(s):  
梅旭荣 MEI Xurong ◽  
黄桂荣 HUANG Guirong ◽  
严昌荣 YAN Changrong ◽  
刘晓英 LIU Xiaoying ◽  
张欣莹 ZHANG Xinying ◽  
...  

2020 ◽  
Vol 0 (6) ◽  
pp. 13-19
Author(s):  
Guzel Gumerova ◽  
Georgiy Gulyuk ◽  
Dmitry Kucher ◽  
Anatoly Shuravilin ◽  
Elena Piven

Data of long-term researches (2015–2018) in southern forest-steppe zone of the Republic of Bashkortostan, is justified theoretically and experimentally the mode of irrigation of potatoes on leached chernozems of unsatisfactory, satisfactory and good ameliorative condition of irrigated lands. For the growing periods of potatoes with different heat and moisture supply, the number of watering, the timing of their implementation, irrigation and irrigation norms are established. On lands with unsatisfactory meliorative state the number of irrigation depending on weather conditions of potato vegetation period varied from 0 to 3 (1.5 on average) with average irrigation norm – 990 m3/ha. With satisfactory meliorative state of lands the number of irrigation on average increased from 0 to 4 (2.3 on average) with irrigation norm – 1305 m3/ha. On lands with good meliorative state the number of irrigation was the highest – from 1 to 5 (3 on average) with average irrigation irrigation norm is 1653 m3/ha. It was noted that in the dry periods of potato vegetation the greatest number of watering was carried out (3–5 watering), and in the wet periods (2017) watering was not carried out except for the area with a good reclamation state, where only one irrigation was carried out by the norm of 550 m3/ha. Water consumption of potato was studied in dynamics as a whole during the growing season and the months of the growing season depending on weather conditions of vegetation period and land reclamation condition of irrigated lands, as well as in the control (without irrigation). The lowest total water consumption was in the area without irrigation and averaged 226.8 mm. In irrigated areas, its values increased to 319-353.4 mm. The average daily water consumption varied from 2.12 to 3.3 mm. The highest rates of potato water consumption were observed in June and July, and the lowest – in May and August. In the total water consumption of potatoes on the site without irrigation, the largest share was occupied by atmospheric precipitation and in addition to them the arrival of moisture from the soil. Irrigation water was used in irrigated areas along with precipitation, the share of which was 30.2–46.1 %.


2020 ◽  
Vol 20 (2) ◽  
Author(s):  
Trey Dronyk-Trosper ◽  
Brandli Stitzel

AbstractAs water rights and water usage become an ever more important part of municipalities’ and states’ way of life, it becomes important to understand what policies can be effective for encouraging conservation of water. One method that has been employed at various times and throughout numerous communities is to limit outdoor watering days. We use a dataset with over 3 million property-month observations during the 2007–2015 period in Norman, Oklahoma, to identify whether the periodic implementation of mandatory water restrictions reduces water usage. Our data allow us to exploit variance in the timing of these water restriction programs. Our findings indicate that this policy reduces water consumption by 0.7 % of total water consumption. Additionally, we use home assessment prices to identify heterogeneity in this response, finding that high priced homes are more responsive to water use restrictions.


2021 ◽  
pp. 1-32
Author(s):  
Jean-Pierre Chouraqui ◽  
Simon N. Thornton ◽  
Louise Seconda ◽  
Stavros A. Kavouras

Abstract Hydration is a particular concern for infants and young children due to their greater risk of dehydration. However, studies on their water intakes are scarce. The current survey aimed to analyze total water intake (TWI) in non-breastfed children aged 0.5-35 months compared to the adequate intake (AI) for the same age group set by the EFSA and to examine the different contributors to TWI as well as beverage consumption patterns. Nationally representative data from the Nutri-Bébé cross-sectional survey were used to assess food, beverage, and plain water consumption by age group over three non-consecutive days. With age, median TWI in 1,035 children increased from 732 to 1010 mL/d, without differences between sex, but with a great inter-individual variation, and the percentage of children who did not meet the AI increased from 10% to 88%. Median weight-related TWI decreased from 136.6 to 69.0 mL/kg/d. Among infants, 90% had a ratio of water/energy below the AI, similarly for about 75% of toddlers. Milk and milk products were the main contributors to TWI, while the part of plain water increased gradually to be 25% in the older toddlers, half of which was tap water. The beverage consumption pattern varied in types and timing, with little consumption of juices and sweetened beverages. Vegetables and fruits accounted for 20% of TWI after the age of 6 months. These initial results, showing strong discrepancies between actual and recommended water intakes in young children, should help identify ways to increase children’s water consumption.


2012 ◽  
Vol 97 ◽  
pp. 897-906 ◽  
Author(s):  
M.C. Rodríguez-Hidalgo ◽  
P.A. Rodríguez-Aumente ◽  
A. Lecuona ◽  
M. Legrand ◽  
R. Ventas

2019 ◽  
Author(s):  
MJ Booysen

Electric water heaters are responsible for a large portion of electricity consumption and water usage in the domestic sector. Smart water heaters alleviate the strain on the electricity supply grid and reduce water consumption through behavioural change, but the installation of in-line flow meters is inconvenient and expensive. A non-invasive water flow meter is proposed as an alternative. Non-invasive flow measurement is more common for high flow rates in the industrial sector than for domestic applications. Various non-invasive water measurement methods are investigated in the context of domestic hot water, and a combination of thermal- and vibration-sensing is proposed. The proposed solution uses inexpensive, easily installable, non-invasive sensors and a novel algorithm to provide the same flow measurement accuracy as existing in-line meters. The algorithm detects the beginning and end of water consumption events with an accuracy of 95.6%. Quantitative flow rate estimation was possible for flow rates greater than 5 L min⁻¹ with an accuracy of 89%, while volumetric usage estimation had an accuracy of more than 93%. The algorithm limitations were applied to field data, revealing that water consumption could be detected with an error of less than 12% within the limitations of the proposed algorithm. The paper presents a successful proof of concept for a non-invasive alternative to domestic hot water flow rate measurement.


Sign in / Sign up

Export Citation Format

Share Document