Renewable energy powered membrane technology: Experimental investigation of system performance with variable module size and fluctuating energy

2019 ◽  
Vol 221 ◽  
pp. 64-73 ◽  
Author(s):  
Junjie Shen ◽  
Azam Jeihanipour ◽  
Bryce S. Richards ◽  
Andrea I. Schäfer
2014 ◽  
Vol 468 ◽  
pp. 400-409 ◽  
Author(s):  
Bryce S. Richards ◽  
Gavin L. Park ◽  
Thomas Pietzsch ◽  
Andrea I. Schäfer

Energies ◽  
2022 ◽  
Vol 15 (2) ◽  
pp. 573
Author(s):  
Mohamed Mokhtar ◽  
Mostafa I. Marei ◽  
Mariam A. Sameh ◽  
Mahmoud A. Attia

The frequency of power systems is very sensitive to load variations. Additionally, with the increased penetration of renewable energy sources in electrical grids, stabilizing the system frequency becomes more challenging. Therefore, Load Frequency Control (LFC) is used to keep the frequency within its acceptable limits. In this paper, an adaptive controller is proposed to enhance the system performance under load variations. Moreover, the proposed controller overcomes the disturbances resulting from the natural operation of the renewable energy sources such as Wave Energy Conversion System (WECS) and Photovoltaic (PV) system. The superiority of the proposed controller compared to the classical LFC schemes is that it has auto tuned parameters. The validation of the proposed controller is carried out through four case studies. The first case study is dedicated to a two-area LFC system under load variations. The WECS is considered as a disturbance for the second case study. Moreover, to demonstrate the superiority of the proposed controller, the dynamic performance is compared with previous work based on an optimized controller in the third case study. Finally in the fourth case study, a sensitivity analysis is carried out through parameters variations in the nonlinear PV-thermal hybrid system. The novel application of the adaptive controller into the LFC leads to enhance the system performance under disturbance of different sources of renewable energy. Moreover, a robustness test is presented to validate the reliability of the proposed controller.


Author(s):  
S. F. McBean ◽  
A. M. Birk

This paper describes an experimental investigation into the effects of geometrical variations on ejector system performance when the driving nozzle includes delta mixing tabs. Mixing tabs have been shown to provide good mixing performance with comparable back-pressure penalties to other types of enhanced mixing nozzles. The performance parameters of most interest are pumping, mixing, and back-pressure. Geometric parameters studied include standoff distance, mixing-tube diameter, and tab angle. Experimental testing showed significant performance improvements in mixing and pumping with a decrease in tab angle. Maximum mixing was found to occur with tab angles positioned at 120°. Exceptional mixing was also observed with increased standoff. Back-pressure was shown to increase with increasing standoff and decreasing tab angle, but was not affected by mixing-tube diameter. In addition, a zone of recirculation was identified at the entrance to the mixing-tube. This zone is thought to have an influence on ejector performance.


2015 ◽  
Vol 103 ◽  
pp. 468-476 ◽  
Author(s):  
Matin Ghadiri ◽  
Mohammad Sardarabadi ◽  
Mohammad Pasandideh-fard ◽  
Ali Jabari Moghadam

Sign in / Sign up

Export Citation Format

Share Document