Hydrothermal preparation of Na0.5Bi0.5TiO3 nanospheres towards high humidity sensing response

2021 ◽  
pp. 130584
Author(s):  
Li Li ◽  
Xiaoqi Xuan ◽  
Gaifang Chen ◽  
Yanran Ma ◽  
Cheng Chen ◽  
...  
Keyword(s):  
High Humidity ◽  
Hydrothermal Preparation ◽  
Humidity Sensing

Polyaniline-intercalated layered double hydroxides: synthesis and properties for humidity sensing

RSC Advances ◽  
2016 ◽  
Vol 6 (68) ◽  
pp. 63099-63106 ◽  
Author(s):  
Xiao-Zhou Li ◽  
Shui-Ren Liu ◽  
Ying Guo
Keyword(s):  
Layered Double Hydroxides ◽  
Rapid Response ◽  
Good Stability ◽  
High Humidity ◽  
Humidity Sensing ◽  
Double Hydroxides ◽  
Humidity Sensitivity

A series of polyaniline and sodium dodecanesulfonate co-intercalated layered double hydroxides (LDH/PANI/SDS) with high humidity sensitivity, rapid response and good stability.

Hydrothermal preparation of TiO2-Ag nanoparticles and its antimicrobial performance against human pathogenic microbial cells in water

BIOCELL ◽  
2018 ◽  
Vol 42 (3) ◽  
pp. 93-97 ◽  
Author(s):  
Mahmoud MOUSTAFA ◽  
Saad ALAMRI ◽  
Mohamed ELNOUBY ◽  
Tarek TAHA ◽  
M. A. ABU-SAIED ◽  
...  
Keyword(s):  
Ag Nanoparticles ◽  
Hydrothermal Preparation ◽  
Microbial Cells ◽  
Antimicrobial Performance

Degradation Analysis of Thick Film Chip Resistors

2009 ◽  
Author(s):  
Bhanu Sood ◽  
Diganta Das ◽  
Michael H. Azarian ◽  
Michael Pecht
Keyword(s):  
Thick Film ◽  
Printed Circuit Board ◽  
Negative Resistance ◽  
Circuit Board ◽  
High Humidity ◽  
Circuit Boards ◽  
Chemical Modifications ◽  
Current Leakage ◽  
Printed Circuit ◽  
Degradation Analysis

Abstract Negative resistance drift in thick film chip resistors in high temperature and high humidity application conditions was investigated. This paper reports on the investigation of possible causes including formation of current leakage paths on the printed circuit board, delamination between the resistor protective coating and laser trim, and the possibility of silver migration or copper dendrite formation. Analysis was performed on a set of circuit boards exhibiting failures due to this phenomenon. Electrical tests after mechanical and chemical modifications showed that the drift was most likely caused by moisture ingress that created a conductive path across the laser trim.

The Impact of Biochar on the Soil

2018 ◽  
Vol 69 (8) ◽  
pp. 2197-2208
Author(s):  
Carmen Otilia Rusanescu ◽  
Erol Murad ◽  
Cosmin Jinescu ◽  
Marin Rusanescu
Keyword(s):  
Agricultural Land ◽  
Agricultural Soils ◽  
Biomass Gasification ◽  
High Humidity ◽  
Agricultural Ecosystems ◽  
Productive Potential ◽  
Co2 Balance ◽  
Environmentally Sound ◽  
The Impact ◽  
Organic Resources

In the present paper are presented the experimental results of biomass gasification, the biochair was produced from vineyards by controlled pyrolysis at 750 �C, in order to increase the fertility of soils, it was found the increase of the fertility produced by the development of the vegetables in the soil to which was added biochar. Soil was added to soil 4 g/dm3 biochar, 8 g/dm3 biochar, the soil had no high humidity, was taken at a time when it had not rained for at least one week, the soil pH was 8, in the soil with 8 g/dm3 biochar the plants increased compared to the soil with 4 g/dm3 and the soil without biochar. The biochar resulting from pyrolysis and gasification processes is a valuable amendment to agricultural soils and an efficient and economical way to seize carbon. Using biochar it is possible to increase the diversity of agricultural land in an environmentally sound way in areas with depleted soils, limited organic resources and insufficient water for development. Helps to soil carbon sequestration with negative CO2 balance, increases the productive potential of agricultural ecosystems.

Controlled Growth and Characterization Ag/ZnO Nanotetrapods for Humidity Sensing

2018 ◽  
Vol 21 (7) ◽  
pp. 462-467
Author(s):  
Babak Sadeghi
Keyword(s):  
Room Temperature ◽  
Zinc Complex ◽  
Water Solution ◽  
Particle Morphology ◽  
Quick Response ◽  
Separation System ◽  
Humidity Sensing ◽  
Sensor Material ◽  
Highly Sensitive

Aim and Objective: Ultrafine Ag/ZnO nanotetrapods (AZNTP) have been prepared successfully using silver (I)–bis (oxalato) zinc complex and 1, 3-diaminopropane (DAP) with a phase separation system, and have been injected into a diethyl/water solution. Materials and Methods: This crystal structure and lattice constant of the AZNTP obtained were investigated by means of a SEM, XRD, TEM and UV-vis spectrum. Results: The results of the present study demonstrated the growth and characterization AZNTP for humidity sensing and DAP plays a key role in the determination of particle morphology. AZNTP films with 23 nm in arm diameter have shown highly sensitive, quick response sensor material that works at room temperature.

scholarly journals Synthesis of novel adsorbent based on tetrasulfide-functionalized fibrous silica KCC-1 for removal of Hg(II) cations

2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Azam Marjani ◽  
Reza Khan Mohammadi
Keyword(s):  
Effective Interaction ◽  
Sol Gel ◽  
Aqueous Media ◽  
Synthesis Method ◽  
Mercury Ions ◽  
Toxic Heavy Metals ◽  
Uptake Capacity ◽  
Hydrothermal Preparation ◽  
Ultrasonic Assisted ◽  
First Time

AbstractHg(II) has been identified to be one of the extremely toxic heavy metals because of its hazardous effects and this fact that it is even more hazardous to animals than other pollutants such as Ag, Au, Cd, Ni, Pb, Co, Cu, and Zn. Accordingly, for the first time, tetrasulfide-functionalized fibrous silica KCC-1 (TS-KCC-1) spheres were synthesized by a facile, conventional ultrasonic-assisted, sol–gel-hydrothermal preparation approach to adsorb Hg(II) from aqueous solution. Tetrasulfide groups (–S–S–S–S–) were chosen as binding sites due to the strong and effective interaction of mercury ions (Hg(II)) with sulfur atoms. Hg(II) uptake onto TS-KCC-1 in a batch system has been carried out. Isotherm and kinetic results showed a very agreed agreement with Langmuir and pseudo-first-order models, respectively, with a Langmuir maximum uptake capacity of 132.55 mg g–1 (volume of the solution = 20.0 mL; adsorbent dose = 5.0 mg; pH = 5.0; temperature: 198 K; contact time = 40 min; shaking speed = 180 rpm). TS-KCC-1was shown to be a promising functional nanoporous material for the uptake of Hg(II) cations from aqueous media. To the best of our knowledge, there has been no report on the uptake of toxic Hg(II) cations by tetrasulfide-functionalized KCC-1 prepared by a conventional ultrasonic-assisted sol–gel-hydrothermal synthesis method.

Sign in / Sign up

Export Citation Format

Share Document