scholarly journals Detection of Mechanical Stress in the Steel Structure of a Bridge Crane

2021 ◽  
pp. 100299
Author(s):  
Leopold Hrabovský ◽  
Daniel Čepica ◽  
Karel Frydrýšek
Keyword(s):  
Mechanical Stress ◽  
Steel Structure ◽  
Bridge Crane

Analysis of Dynamic Characteristics of Structure Design of Bridge Crane in 65t

2013 ◽  
Vol 482 ◽  
pp. 109-112 ◽  
Author(s):  
Jing Yang ◽  
Yu De Dong
Keyword(s):  
Dynamic Characteristics ◽  
Steel Structure ◽  
Structure Design ◽  
Bridge Crane ◽  
Characteristic Analysis ◽  
Element Analysis ◽  
Permissible Stress ◽  
Design Efficiency ◽  
Container Crane ◽  
The Finite Element Analysis

Quayside container crane, referred to as the bridge crane. The steel structure is usually the permissible stress method is adopted to design check, analysis on its dynamic characteristics through the finite element analysis, can the actual working state simulation of crane more accurate. The dynamic characteristic analysis of problem, change to correct the parameters in the design, greatly improved the design efficiency and accuracy .

scholarly journals DETECTION OF MECHANICAL STRESS LIMITING EFFECTS OF CRANE STRUCTURE DEFORMATION

2021 ◽  
Vol 2021 (6) ◽  
pp. 5396-5402
Author(s):  
LEOPOLD HRABOVSKY ◽  
◽  
ZDENEK FOLTA ◽  
Keyword(s):  
Mechanical Stress ◽  
Relative Elongation ◽  
Tensile Force ◽  
Steel Structure ◽  
Mechanical Tests ◽  
Construction Design ◽  
Axial Forces ◽  
Instantaneous Values ◽  
The Individual ◽  
Short Time

The paper presents a construction design and results of laboratory tests of so-called mechanical stress detectors, which can be used to detect the deformation of the steel structure of a crane and to amplify the mechanical signal from the effect of the so-called crane skewing, which is included among occasional loads acting on the crane. The values of the relative elongation of the detectors corresponding to the magnitude of the instantaneous tensile force were obtained by conducting experimental mechanical tests. Detectors of a known extent of deformation were installed on a two-girder overhead crane bridge, where they measured axial forces generated during the controlled deformation of the crane bridge. In practice, the instantaneous values of the axial forces recorded by the individual detectors make it possible to regulate the speed of the crane drive wheels and thus eliminate, in a relatively short time, the undesirable effects of deforming the crane bridge and friction of the crane wheels on the sides of the rail heads.

Behaviour of Ni-Mn-Ga alloys under mechanical stress

2003 ◽  
Vol 112 ◽  
pp. 943-946 ◽  
Author(s):  
K. Koho ◽  
J. Vimpari ◽  
L. Straka ◽  
N. Lanska ◽  
O. Sôderberg ◽  
...  
Keyword(s):  
Mechanical Stress

Enhancement of Platelet Sensitivity to ADP-Aggregation by Isometric Exercise in Arteriosclerotic Patients and its Prevention

1977 ◽  
Vol 37 (02) ◽  
pp. 329-338 ◽  
Author(s):  
Tadahiro Sano ◽  
Takeshi Motomiya ◽  
Hiroh Yamazaki ◽  
Takio Shimamoto
Keyword(s):  
Cyclic Amp ◽  
Mechanical Stress ◽  
Optical Density ◽  
Platelet Function ◽  
Isometric Exercise ◽  
Phosphodiesterase Inhibitor ◽  
New Method ◽  
Platelet Aggregability ◽  
Control Subjects ◽  
Healthy Control

SummaryA new method for assessment of platelet sensitivity to ADP-aggregation was devised. Its reproducibility and the correlations between the values obtained by this method, the optical density (O. D.) method, and the screen filtration pressure (SFP) method were assessed. In summary, this method may be said to have three main points:1. It can be performed without centrifugation, avoiding mechanical stress to platelets, using only 0.8 ml. of blood and inexpensive equipment.2. It may reflect different aspects of platelet function from the O. D. method and the SFP method, despite the positive significant correlations between the values obtained by these three methods.3. It was proved to be highly reproducible and is thought to be useful clinically.By using this method, the effect of sustained isometric exercise by handgripping on platelet aggregability was assessed in coronary sclerotic and cerebral arteriosclerotic patients on placebo and EG-626, a newly synthesized cyclic AMP phosphodiesterase inhibitor. On placebo, an enhancement of platelet sensitivity was observed after isometric exercise in coronary and cerebral arteriosclerotic patients but not in healthy control subjects. The enhancement was prevented by pretreatment of EG-626, administered orally 1.5 hours prior to exercise.

Exploring the Biological Protective Role of Carotenoids by Raman Spectroscopy: Mechanical Stress of Cells

2019 ◽  
Vol 64 (1-2) ◽  
pp. 75-82
Author(s):  
F. Nekvapil ◽  
◽  
Cs. Müller Molnár ◽  
S. Tomšić ◽  
S. Cintă Pinzaru ◽  
...  
Keyword(s):  
Raman Spectroscopy ◽  
Mechanical Stress ◽  
Protective Role

Regeneration of a historic city block: the example of the relocation of the historic Atelier building to the cloister area of the Congregation of the Resurrection in Krakow

2019 ◽  
Vol 63 (1) ◽  
pp. 77-86 ◽  
Author(s):  
Bogusław Podhalański ◽  
Anna Połtowicz
Keyword(s):  
Twentieth Century ◽  
Cultural Heritage ◽  
Steel Structure ◽  
City Block ◽  
Raising Awareness ◽  
Straight Line ◽  
Heritage Buildings ◽  
Heritage Building ◽  
Historic City ◽  
The City

Abstract The article discusses a project that features the relocation of the historic Atelier building, built by Krakow-based architect Wandalin Beringer (1839–1923) who was active in the early twentieth century, and the regeneration of a plot belonging to the Congregation of the Resurrection since 1885, which is located at 12 Łobzowska Street in Krakow. The method includes cutting the entire structure off at the foundation and then after reinforcing it with a steel structure transporting it in its entirety to the new location. The project included two possible variants of moving the building in a straight line, either by 21 or 59 metres and evaluates two projects of further regeneration, the adaptive reuse of the building as an exhibition and religious space as well as a proposal for the remodelling of the nearby plot that belongs to the Congregation into a space for meditation and as a recreational park. The aim of these measures is to prevent the demolition of this building, now over a century old, as a result of which a forgotten element of the cultural heritage of the city will be saved. This project was based on the results of analyses of the cultural and historical conditions of Krakow. The block of buildings in which the Atelier in question is located is a very attractive location, near to the very centre of Krakow, adjacent to residential, service and educational buildings. It is directly adjacent to the Monastery Complex of the Congregation of the Resurrection, listed as a heritage building under conservation protection (municipal registry of heritage buildings). In the second half of the twentieth century, the building was used as a workroom by artists such as Xawery Dunikowski and later by the sculptress Teodora Stasiak. The case of the Atelier may provide an inspiration for discussion as well as raising awareness among citizens and city authorities to avoid future situations in which cultural heritage may become forgotten or demolished.

Sensitive Mechanocontrolled Luminescence in Cross-Linked Polymer Films

2019 ◽  
Author(s):  
Ayumu Karimata ◽  
Pradnya Patil ◽  
Eugene Khaskin ◽  
Sébastien Lapointe ◽  
robert fayzullin ◽  
...  
Keyword(s):  
Mechanical Stress ◽  
Polymer Films ◽  
Soft Matter ◽  
Small Strain ◽  
Visual Methods ◽  
Photoluminescence Intensity ◽  
Stimuli Responsive ◽  
Responsive Materials ◽  
Highly Sensitive ◽  
Mechanical Stretching

Direct translation of mechanical force into changes in chemical behavior on a molecular level has important implication not only for the fundamental understanding of mechanochemical processes, but also for the development of new stimuli-responsive materials. In particular, detection of mechanical stress in polymers via non-destructive methods is important in order to prevent material failure and to study the mechanical properties of soft matter. Herein, we report that highly sensitive changes in photoluminescence intensity can be observed in response to the mechanical stretching of cross-linked polymer films when using stable, (pyridinophane)Cu-based dynamic mechanophores. Upon stretching, the luminescence intensity increases in a fast and reversible manner even at small strain (< 50%) and applied stress (< 0.1 MPa) values. Such sensitivity is unprecedented when compared to previously reported systems based on organic mechanophores. The system also allows for the detection of weak mechanical stress by spectroscopic measurements or by direct visual methods.<br>

Sign in / Sign up

Export Citation Format

Share Document