Effects of water vapor condensation on the convection heat transfer of wet flue gas in a vertical tube

2001 ◽  
Vol 44 (22) ◽  
pp. 4257-4265 ◽  
Author(s):  
L. Jia ◽  
X.F. Peng ◽  
Y. Yan ◽  
J.D. Sun ◽  
X.P. Li
Keyword(s):  
Heat Transfer ◽  
Water Vapor ◽  
Flue Gas ◽  
Convection Heat Transfer ◽  
Vertical Tube ◽  
Vapor Condensation ◽  
Convection Heat ◽  
Water Vapor Condensation

scholarly journals An Experimental Investigation of Water Vapor Condensation from Biofuel Flue Gas in a Model of Condenser, (1) Base Case: Local Heat Transfer without Water Injection

Processes ◽  
2021 ◽  
Vol 9 (5) ◽  
pp. 844
Author(s):  
Robertas Poškas ◽  
Arūnas Sirvydas ◽  
Vladislavas Kulkovas ◽  
Povilas Poškas
Keyword(s):  
Heat Transfer ◽  
Water Vapor ◽  
Flue Gas ◽  
Waste Heat Recovery ◽  
Waste Heat ◽  
Water Injection ◽  
Vapor Condensation ◽  
Base Case ◽  
Water Vapor Condensation ◽  
Condensing Heat Exchanger

Waste heat recovery from flue gas based on water vapor condensation is an important issue as the waste heat recovery significantly increases the efficiency of the thermal power units. General principles for designing of this type of heat exchangers are known rather well; however, investigations of the local characteristics necessary for the optimization of those heat exchangers are very limited. Investigations of water vapor condensation from biofuel flue gas in the model of a vertical condensing heat exchanger were performed without and with water injection into a calorimetric tube. During the base-case investigations, no water was injected into the calorimetric tube. The results showed that the humidity and the temperature of inlet flue gas have a significant effect on the local and average heat transfer. For some regimes, the initial part of the condensing heat exchanger was not effective in terms of heat transfer because there the flue gas was cooled by convection until its temperature reached the dew point temperature. The results also showed that, at higher Reynolds numbers, there was an increase in the length of the convection prevailing region. After that region, a sudden increase was observed in heat transfer due to water vapor condensation.

Heat Exchangers for Cooling Boiler Flue Gas to Temperatures Below the Water Vapor Dewpoint

2011 ◽  
Author(s):  
Edward Levy ◽  
Harun Bilirgen ◽  
Michael Kessen ◽  
Daniel Hazell ◽  
Barbara Carney
Keyword(s):  
Heat Transfer ◽  
Water Vapor ◽  
Flue Gas ◽  
Heat Exchangers ◽  
Buoyancy Force ◽  
Power Plants ◽  
Vapor Condensation ◽  
Water Vapor Condensation ◽  
Funded Project ◽  
Condensed Water

Coal-fired power plants have traditionally operated with stack temperatures in the 300°F range to minimize fouling and corrosion problems due to sulfuric acid condensation and to provide a buoyancy force to assist in the transport of flue gas up the stack. However, as an alternative, there would be benefits to cooling the flue gas to temperatures below the water vapor and acid dew points, while capturing the condensed water vapor. This paper describes experimental results from a DOE and industry-funded project to develop condensing heat exchangers for application to coal-fired power plants. A system of condensing heat exchangers was designed, fabricated and tested using slip streams of boiler flue gas and experiments were performed to measure the effects of process parameters on rates of heat transfer and water vapor condensation. In addition, measurements were made to characterize the acid concentrations in the condensed water which collected on the heat exchanger tubes and to quantify the effects of the heat exchangers on flue gas mercury concentrations.

Convection Heat Transfer of CO2 at Supercritical Pressures in a Vertical Mini Tube

2009 ◽  
Author(s):  
Pei-Xue Jiang ◽  
Zhi-Hui Li ◽  
Chen-Ru Zhao
Keyword(s):  
Heat Transfer ◽  
Wall Temperature ◽  
Convection Heat Transfer ◽  
High Heat ◽  
Vertical Tube ◽  
Density Variation ◽  
Heat Fluxes ◽  
Convection Heat ◽  
Downward Flow ◽  
Flow Acceleration

This paper presents the experimental and numerical investigation results of the convection heat transfer of CO2 at supercritical pressures in a 0.0992 mm diameter vertical tube at various inlet Reynolds numbers, heat fluxes and flow directions. The effects of buoyancy and flow acceleration resulted from the dramatic properties variation were investigated. Results showed that the local wall temperature varied non-linearly for both upward and downward flow when the heat flux was high. The difference of the local wall temperature between upward flow and downward flow was very small when other test conditions were held the same, which indicates that for supercritical CO2 flowing in a mini tube as employed in this study, the buoyancy effect on the convection heat transfer was quite insignificant, and the flow acceleration induced by the axial density variation with temperature was the main factor that lead to the abnormal local wall temperature distribution at high heat fluxes. The predicted values using the LB low Reynolds number turbulence model correspond well with the measured data. Velocity profiles and turbulence kinetic energy near the wall varying along the tube generated by the numerical simulations were presented to develop a better understanding.

Sign in / Sign up

Export Citation Format

Share Document