Effect of moisture content in sewage sludge on air gasification

The possible volume reduction and stabilization of the sewage sludge associated with the melting process are expected to be greater than with the incineration process. In addition, melted slag can be utilized. However, since the melting process requires a very high temperature to melt inorganics (ash) in the sludge, the technologies to minimize energy consumption, to establish system operation and to prolong durability of facilities should be developed. This paper discusses the auxiliary fuel consumption as follows.(1)Preparation of a model that provides the auxiliary fuel consumption of the melting system on the basis of the mass and heat balances.(2)Evaluation of the auxiliary fuel consumption in the above model using the cake moisture content, the volatile solids of the cake, the dried cake moisture content and the melting temperature as parameters.(3)Examination of the operational conditions for an energy saving melting system based on the results of (1) and (2) above.

Download Full-text

Effect of moisture content on the accuracy and economic feasibility of oil–paper insulation prediction model

IET Science Measurement & Technology ◽

10.1049/iet-smt.2020.0025 ◽

2020 ◽

Vol 14 (9) ◽

pp. 696-703

Author(s):

Chong Li ◽

Kai Wu ◽

Chuanhui Cheng

Keyword(s):

Moisture Content ◽

Prediction Model ◽

Economic Feasibility ◽

Effect Of Moisture ◽

Paper Insulation

Download Full-text

Effect of Moisture Content on the Processing and Mechanical Properties of a Biodegradable Polyester

Polymers ◽

10.3390/polym13101616 ◽

2021 ◽

Vol 13 (10) ◽

pp. 1616

Author(s):

Vincenzo Titone ◽

Antonio Correnti ◽

Francesco Paolo La Mantia

Keyword(s):

Mechanical Properties ◽

Tensile Strength ◽

Moisture Content ◽

Mechanical Testing ◽

Hydrolytic Degradation ◽

Slight Reduction ◽

Biodegradable Polyester ◽

Molding Process ◽

Elongation At Break ◽

Effect Of Moisture

This work is focused on the influence of moisture content on the processing and mechanical properties of a biodegradable polyester used for applications in injection molding. The pellets of the biodegradable polyester were exposed under different relative humidity conditions at a constant temperature before being compression molded. The compression-molded specimens were again placed under the above conditions before the mechanical testing. With all these samples, it is possible to determine the effect of moisture content on the processing and mechanical properties separately, as well as the combined effect of moisture content on the mechanical properties. The results obtained showed that the amount of absorbed water—both before processing and before mechanical testing—causes an increase in elongation at break and a slight reduction of the elastic modulus and tensile strength. These changes have been associated with possible hydrolytic degradation during the compression molding process and, in particular, with the plasticizing action of the moisture absorbed by the specimens.

Download Full-text