scholarly journals Late Tertiary fault activity in the southwestern boundary fault system of the Roer Valley Graben: evidences from the Bree area (NE Belgium)

2001 ◽  
Vol 80 (3-4) ◽  
pp. 69-78 ◽  
Author(s):  
M. Sintubin ◽  
O. Sels ◽  
P. Buffel

AbstractThe Bree Uplift is a particular structure in the direct footwall of the southwestern graben boundary fault system of the Roer Valley Graben, which has been firstly recognized at the base of the Cretaceous. To date fault activity around the Bree Uplift has been confined to the Subhercynian (late Cretaceous) inversion event or considered fading out during Tertiary times.The revision of the existing geological data reveals that the Bree Uplift can still be recognized on the top-Tertiary map. This infers at least a late Tertiary activity, suggesting continuous fault activity in the graben boundary fault system not only on the major boundary faults but also on different splay faults, bounding individual fault blocks.

2020 ◽  
Author(s):  
Jef Deckers ◽  
Bernd Rombaut ◽  
Koen Van Noten ◽  
Kris Vanneste

Abstract. After their first development in the middle Mesozoic, the overall NW-SE striking border fault systems of the Roer Valley Graben were reactivated as reverse faults under Late Cretaceous compression (inversion) and reactivated again as normal faults under Cenozoic extension. In Flanders (northern Belgium), a new geological model was created for the western border fault system of the Roer Valley Graben. After carefully evaluating the new geological model, this study shows the presence of two structural domains in this fault system with distinctly different strain distributions during both Late Cretaceous compression and Cenozoic extension. A southern domain is characterized by narrow ( 10 km) distributed faulting. The total normal and reverse throw in the two domains was estimated to be similar during both tectonic phases. The repeated similarities in strain distribution during both compression and extension stresses the importance of inherited structural domains on the inversion/rifting kinematics besides more obvious factors such as stress directions. The faults in both domains strike NW-SE, but the change in geometry between them takes place across the oblique WNW-ESE striking Grote Brogel fault. Also in other parts of the Roer Valley Graben, WNW-ESE striking faults are associated with major geometrical changes (left-stepping patterns) in its border fault system. This study thereby demonstrates the presence of different long-lived structural domains in the Roer Valley Graben, each having their particular strain distributions that are related to the presence of non-colinear faults.


Solid Earth ◽  
2021 ◽  
Vol 12 (2) ◽  
pp. 345-361
Author(s):  
Jef Deckers ◽  
Bernd Rombaut ◽  
Koen Van Noten ◽  
Kris Vanneste

Abstract. The influence of strain distribution inheritance within fault systems on repeated fault reactivation is far less understood than the process of repeated fault reactivation itself. By evaluating cross sections through a new 3D geological model, we demonstrate contrasts in strain distribution between different fault segments of the same fault system during its reverse reactivation and subsequent normal reactivation. The study object is the Roer Valley graben (RVG), a middle Mesozoic rift basin in western Europe that is bounded by large border fault systems. These border fault systems were reversely reactivated under Late Cretaceous compression (inversion) and reactivated as normal faults under Cenozoic extension. A careful evaluation of the new geological model of the western RVG border fault system – the Feldbiss fault system (FFS) – reveals the presence of two structural domains in the FFS with distinctly different strain distributions during both Late Cretaceous compression and Cenozoic extension. A southern domain is characterized by narrow (<3 km) localized faulting, while the northern is characterized by wide (>10 km) distributed faulting. The total normal and reverse throws in the two domains of the FFS were estimated to be similar during both tectonic phases. This shows that each domain accommodated a similar amount of compressional and extensional deformation but persistently distributed it differently. The faults in both structural domains of the FFS strike NW–SE, but the change in geometry between them takes place across the oblique WNW–ESE striking Grote Brogel fault. Also in other parts of the Roer Valley graben, WNW–ESE-striking faults are associated with major geometrical changes (left-stepping patterns) in its border fault system. At the contact between both structural domains, a major NNE–SSW-striking latest Carboniferous strike-slip fault is present, referred to as the Gruitrode Lineament. Across another latest Carboniferous strike-slip fault zone (Donderslag Lineament) nearby, changes in the geometry of Mesozoic fault populations were also noted. These observations demonstrate that Late Cretaceous and Cenozoic inherited changes in fault geometries as well as strain distributions were likely caused by the presence of pre-existing lineaments in the basement.


1994 ◽  
Vol 34 ◽  
pp. 1-23
Author(s):  
Ole Valdemar Vejbæk ◽  
Svend Stouge ◽  
Kurt Damtoft Poulsen

The present distribution of Palaeozoic sediments in the Bornholm area is a consequence of several different tectonic regimes during the Phanerozoic eon. This development may be divided into three main evolutionary phases: A Caledonian to Variscian phase encompassing the Lower Palaeozoic sediments. The sediments are assumed originally to have showed a gradual thickness increase towards the Caledonian Deformation Front located to the south. This pre-rift development may be further subdivided into three sub-phases: A period of slow sedimentation on a relatively stable platform as recorded by the uniformly low thicknesses of the Cambrian to Lower Silurian sediments. A period of foreland-type rapid sedimentation commencing in the Llandoverian to Wenlockian, continuing in the Ludlovian and possibly into the Devonian. The period is characterized by /olding and uplift of the Caledonides to the south causing tectonic loading of the foreland and resultant rapid sedimentation in the foreland basin. A period of gravitational collapse causing minor erosion during the Devonian. The transition to the second major phase in the Phanerozaic structural development, during which the Sorgenfrei-Tornquist zone came into existence, is recorded by regional deposition of Carboniferous sediments. These sediments are, however, mostly removed by tater erosion. A syn-rift phase characterized by sedimentation in graben areas and expanding basins commencing in the Rotliegendes and continuing through the Triassic, Jurassic and Lower Cretaceous. This phase was probably initiated by a Late Carboniferous- Early Permian tensional dominated right-lateral wrench fault system within the Sorgenfrei-Tornquist zone. A Post-rift development phase dominated by Late Cretaceous carbonate sedimentation. During Late Cretaceous and Early Tertiary times the Bornholm area was strongly affected by inversion tectonism caused by compressional strike-slip movements. This resulted in reverse faulting and uplift and erosion of former basinal areas. Understanding the two latter phases is important for understanding the present distribution of the Palaeozoic. A key to understanding the hydrocarbon potential of the area is the maturation of the organic matter in the main potential source, the Ordovician Upper Alum Shale. Maturity was mainly achieved during the Silurian to Late Palaeozoic time, and little further maturation took place later. The Upper Alum Shale is accordingly expected to be overmature in the main part of the study area and mature in the Hano Bay Basin. This reflects the assumed primary uniform thickness of the Lower Palaeozoic, with a general thinning towards the northeast. A Caledonian to Variscian phase encompassing the Lower Palaeozoic sediments. The sediments are assumed originally to have showed a gradual thickness increase towards the Caledonian Deformation Front located to the south. This pre-rift development may be further subdivided into three sub-phases: A period of slow sedimentation on a relatively stable platform as recorded by the uniformly low thicknesses of the Cambrian to Lower Silurian sediments. A period of foreland-type rapid sedimentation commencing in the Llandoverian to Wenlockian, continuing in the Ludlovian and possibly into the Devonian. The period is characterized by /olding and uplift of the Caledonides to the south causing tectonic loading of the foreland and resultant rapid sedimentation in the foreland basin. A period of gravitational collapse causing minor erosion during the Devonian. The transition to the second major phase in the Phanerozaic structural development, during which the Sorgenfrei - Tornquist zane came into existence, is recorded by regional deposition of Carboniferous sediments. These sediments are, however, mostly removed by tater erosion. A syn-rift phase characterized by sedimentation in graben areas and expanding basins commencing in the Rotliegendes and continuing through the Triassic, Jurassic and Lower Cretaceous. This phase was probably initiated by a Late Carboniferous- Early Permian tensional dominated right-lateral wrench fault system within the Sorgenfrei-Tornquist zone. A Post-rift development phase dominated by Late Cretaceous carbonate sedimentation. During Late Cretaceous and Early Tertiary times the Bornholm area was strongly affected by inversion tectonism caused by compressional strike-slip movements. This resulted in reverse faulting and uplift and erosion of former basinal areas. Understanding the two latter phases is important for understanding the present distribution of the Palaeozoic. A key to understanding the hydrocarbon potential of thearea is the maturation of the organic matter in the main potential source, the Ordovician Upper Alum Shale. Maturity was mainly achieved during the Silurian to Late Palaeozoic time, and little further maturation took place later. The Upper Alum Shale is accordingly expected to be overmature in the main part of the study area and mature in the Hano Bay Basin. This reflects the assumed primary uniform thickness of the Lower Palaeozoic, with a general thinning towards the northeast.


2006 ◽  
Vol 28 (6) ◽  
pp. 1028-1039 ◽  
Author(s):  
Gideon G.O. Lopes Cardozo ◽  
Jan H. Behrmann

2000 ◽  
Vol 37 (9) ◽  
pp. 1259-1273 ◽  
Author(s):  
M E McMechan

Walker Creek fault zone (WCFZ), well exposed in the western Rocky Mountains of central British Columbia near 54°, comprises a 2 km wide zone of variably deformed Neoproterozoic and Cambrian strata in fault-bounded slivers and lozenges. Extensional shear bands, subhorizontal extension lineations, slickensides, mesoscopic shear bands, and other minor structures developed within and immediately adjacent to the fault zone consistently indicate right-lateral displacement. Offset stratigraphic changes in correlative Neoproterozoic strata indicate at least 60 km of right-lateral displacement across the zone. WCFZ is the southern continuation of the Northern Rocky Mountain Trench (NRMT) fault zone. It shows a through going, moderate displacement, strike-slip fault system structurally links the NRMT and the north-central part of the Southern Rocky Mountain Trench. Strike-slip motion on the WCFZ occurred in the Late Cretaceous to Early Eocene at the same time as northeast-directed shortening in the fold-and-thrust belt. Thus, oblique convergence in the eastern part of the south-central Canadian Cordillera was apparently resolved into parallel northwest-striking zones of strike-slip and thrust faulting during the Late Cretaceous to Early Eocene. The change in the net Late Cretaceous to Early Eocene displacement direction for rocks in the Rocky Mountain trenches from north (56-54°N) to northeast (52-49°N) suggests that the disappearance of strike-slip displacement and increase in fold-and-thrust belt shortening in the eastern Cordillera between 56° and 49°N is largely the result of a north-south change in relative plate motion or strain partitioning across the Cordillera, rather than the southward transformation of right-lateral strike-slip displacement on the Tintina - NRMT fault system into compressional deformation.


2013 ◽  
Vol 734-737 ◽  
pp. 170-177
Author(s):  
Shao Dong Qu ◽  
Chi Yang Liu ◽  
Li Jun Song ◽  
Hui Deng ◽  
Long Zhang ◽  
...  

Three-dimensional(3-D) seismic data and structure analysis of the Lishu subasin in Songliao basin indicates that Qinjiatun fault zone is composed of two faults: East-Qin and West-Qin fault. This fault system initially formed at Huoshiling stage, peaked at Shahezi stage and faded dramatically from Yingcheng stage. The Qinjiatun fault was important in controlling strata thickness and distribution of the Huoshiling formation. Qindong fault, a typical strike-slip fault, developed relatively later, cutting the Qinjiatun fault, The major active stage was in Denglouku-Quantou stage, and weakened in the end of late Cretaceous. Qinjiatun fault zone was reversed at Denglouku stage when the regional stress went compressive, generating a structure nose that was potentially beneficial for hydrocarbon to accumulate. The strike-slip Qindong fault became active relatively later, cutting through the previous strata and proving pathways for both accumulation and effusion of hydrocarbon.


AAPG Bulletin ◽  
2021 ◽  
Vol 105 (1) ◽  
pp. 157-188
Author(s):  
Hongdan Deng ◽  
Ken McClay ◽  
Awad Bilal
Keyword(s):  

Sign in / Sign up

Export Citation Format

Share Document