Equilibrium turbulent boundary layers with lateral streamline convergence or divergence

2009 ◽  
Vol 623 ◽  
pp. 273-282 ◽  
Author(s):  
T. B. NICKELS

The constraints necessary for equilibrium solutions of the boundary layer equations are explored for turbulent boundary layers subject to lateral convergence and divergence and with longitudinal pressure gradients. It is shown that in addition to the well-known equilibrium solutions for two-dimensional boundary layers there are additionalpossibleequilibrium states for boundary layers with these extra rates-of-strain acting. The necessary constraints for equilibrium are derived and discussed.

1957 ◽  
Vol 24 (2) ◽  
pp. 191-196
Author(s):  
J. M. Robertson ◽  
J. W. Holl

Abstract The development of the three-dimensional boundary layer in a diffuser with several discharge arrangements has been studied for air flow, in continuation of the work of Uram (1). The flow conditions in a diffuser when followed by a straight pipe, an additional length of the diffuser, or a jet, are compared. Extension of the method of analysis developed by Ross for two-dimensional layers is presented. In some cases the use of three-dimensionally defined parameters leads to different results. Ross’s (2) unique outer-flow parameter is found to be no longer satisfactory. Other outer parameters are presented as possible substitutes.


1969 ◽  
Vol 35 (4) ◽  
pp. 737-757 ◽  
Author(s):  
K. C. Brown ◽  
P. N. Joubert

This paper describes a floating-element skin friction meter which has been designed for use in adverse pressure gradients. The effects of secondary forces on the element, which arise from the pressure gradient, are examined in some detail. The limitations of various methods of measuring wall shear stress are discussed and the results from the floating element device are compared with measurements taken in a two-dimensional boundary layer using Preston tubes and velocity profiles. As it is planned to use the instrument later for direct measurements of the shear stress in three-dimensional boundary layers, the relevance of the instrument to this situation is also discussed.


1993 ◽  
Vol 246 ◽  
pp. 503-527 ◽  
Author(s):  
Promode R. Bandyopadhyay ◽  
Anwar Ahmed

The effects of abruptly applied cycles of curvatures and pressure gradients on turbulent boundary layers are examined experimentally. Two two-dimensional curved test surfaces are considered: one has a sequence of concave and convex longitudinal surface curvatures and the other has a sequence of convex and concave curvatures. The choice of the curvature sequences were motivated by a desire to study the asymmetric response of turbulent boundary layers to convex and concave curvatures. The relaxation of a boundary layer from the effects of these two opposite sequences has been compared. The effect of the accompanying sequences of pressure gradient has also been examined but the effect of curvature dominates. The growth of internal layers at the curvature junctions have been studied. Measurements of the Górtler and corner vortex systems have been made. The boundary layer recovering from the sequence of concave to convex curvature has a sustained lower skin friction level than in that recovering from the sequence of convex to concave curvature. The amplification and suppression of turbulence due to the curvature sequences have also been studied.


A numerical method is presented for calculating unsteady two-dimensional laminar and turbulent boundary layers with fluctuations in external velocity. The method used an eddy-viscosity formulation to model the Reynolds shear stress term appropriate to turbulent flow and an efficient two-point finite-difference method to solve the governing boundary-layer equations. The method is used to calculate phase angles between the wall shear stress and an oscillating external laminar boundary layer over a flat plate. The results are in excellent agreement with the analytic solutions of Lighthill for the high- and low-frequency limits and provide information in the region between. Similar calculations for turbulent flows are compared with experimental data and the method shown to be more precise than previously described attempts to represent flows of this type. The agreement between calculations and measurements is imperfect but probably within the resolution of the experiments and adequate for engineering purposes.


1968 ◽  
Vol 19 (1) ◽  
pp. 1-19 ◽  
Author(s):  
H. McDonald

SummaryRecently two authors, Nash and Goldberg, have suggested, intuitively, that the rate at which the shear stress distribution in an incompressible, two-dimensional, turbulent boundary layer would return to its equilibrium value is directly proportional to the extent of the departure from the equilibrium state. Examination of the behaviour of the integral properties of the boundary layer supports this hypothesis. In the present paper a relationship similar to the suggestion of Nash and Goldberg is derived from the local balance of the kinetic energy of the turbulence. Coupling this simple derived relationship to the boundary layer momentum and moment-of-momentum integral equations results in quite accurate predictions of the behaviour of non-equilibrium turbulent boundary layers in arbitrary adverse (given) pressure distributions.


1966 ◽  
Vol 33 (2) ◽  
pp. 429-437 ◽  
Author(s):  
J. C. Rotta

A review is given of the recent development in turbulent boundary layers. At first, for the case of incompressible flow, the variation of the shape of velocity profile with the pressure gradient is discussed; also the temperature distribution and heat transfer in incompressible boundary layers are treated. Finally, problems of the turbulent boundary layer in compressible flow are considered.


1973 ◽  
Vol 2 (4) ◽  
pp. 201-204
Author(s):  
R. Camarero

A calculation procedure for the solution of two-dimensional and axi-symmetric laminar boundary layers in compressible flow has been developed. The method is an extension of the integral approach of Tani to include compressibility effects by means of a reference temperature. Arbitrary pressure gradients and wall temperature can be specified. Comparisons with experiments obtained for supersonic flows over a flat plate indicate that the method yields adequate results. The method is then applied to the solution of the boundary layer on a Basemann inlet.


2019 ◽  
Vol 880 ◽  
pp. 239-283 ◽  
Author(s):  
Christoph Wenzel ◽  
Tobias Gibis ◽  
Markus Kloker ◽  
Ulrich Rist

A direct numerical simulation study of self-similar compressible flat-plate turbulent boundary layers (TBLs) with pressure gradients (PGs) has been performed for inflow Mach numbers of 0.5 and 2.0. All cases are computed with smooth PGs for both favourable and adverse PG distributions (FPG, APG) and thus are akin to experiments using a reflected-wave set-up. The equilibrium character allows for a systematic comparison between sub- and supersonic cases, enabling the isolation of pure PG effects from Mach-number effects and thus an investigation of the validity of common compressibility transformations for compressible PG TBLs. It turned out that the kinematic Rotta–Clauser parameter $\unicode[STIX]{x1D6FD}_{K}$ calculated using the incompressible form of the boundary-layer displacement thickness as length scale is the appropriate similarity parameter to compare both sub- and supersonic cases. Whereas the subsonic APG cases show trends known from incompressible flow, the interpretation of the supersonic PG cases is intricate. Both sub- and supersonic regions exist in the boundary layer, which counteract in their spatial evolution. The boundary-layer thickness $\unicode[STIX]{x1D6FF}_{99}$ and the skin-friction coefficient $c_{f}$, for instance, are therefore in a comparable range for all compressible APG cases. The evaluation of local non-dimensionalized total and turbulent shear stresses shows an almost identical behaviour for both sub- and supersonic cases characterized by similar $\unicode[STIX]{x1D6FD}_{K}$, which indicates the (approximate) validity of Morkovin’s scaling/hypothesis also for compressible PG TBLs. Likewise, the local non-dimensionalized distributions of the mean-flow pressure and the pressure fluctuations are virtually invariant to the local Mach number for same $\unicode[STIX]{x1D6FD}_{K}$-cases. In the inner layer, the van Driest transformation collapses compressible mean-flow data of the streamwise velocity component well into their nearly incompressible counterparts with the same $\unicode[STIX]{x1D6FD}_{K}$. However, noticeable differences can be observed in the wake region of the velocity profiles, depending on the strength of the PG. For both sub- and supersonic cases the recovery factor was found to be significantly decreased by APGs and increased by FPGs, but also to remain virtually constant in regions of approximated equilibrium.


1969 ◽  
Vol 73 (698) ◽  
pp. 143-147 ◽  
Author(s):  
M. K. Bull

Although a numerical solution of the turbulent boundary-layer equations has been achieved by Mellor and Gibson for equilibrium layers, there are many occasions on which it is desirable to have closed-form expressions representing the velocity profile. Probably the best known and most widely used representation of both equilibrium and non-equilibrium layers is that of Coles. However, when velocity profiles are examined in detail it becomes apparent that considerable care is necessary in applying Coles's formulation, and it seems to be worthwhile to draw attention to some of the errors and inconsistencies which may arise if care is not exercised. This will be done mainly by the consideration of experimental data. In the work on constant pressure layers, emphasis tends to fall heavily on the author's own data previously reported in ref. 1, because the details of the measurements are readily available; other experimental work is introduced where the required values can be obtained easily from the published papers.


Sign in / Sign up

Export Citation Format

Share Document