Cause Clarification of Cysteine Oxidation by Active Species Generated during the Oxidation Process of Cinnamaldehyde and Impact on an In Chemico Alternative Method for Skin Sensitization Using a Nucleophilic Reagent Containing Cysteine

Author(s):  
Masaharu Fujita ◽  
Yusuke Yamamoto ◽  
Kumiko Watanabe ◽  
Koo Suzuki ◽  
Toshihiko Kasahara
Author(s):  
Xiaoyan Li ◽  
Hongwei Wang ◽  
Guozhen Zhang ◽  
Tianhong Zhou ◽  
Fuping Wu

Abstract Advanced oxidation process (AOP) has attracted widespread attention because it can effectively remove antibiotics in water, but its practical engineering application is limited by the problems of the low efficiency and difficult recovery of the catalyst. In the study, nano-spinel CoFe2O4 was prepared by hydrothermal method and served as the peroxymonosulfate (PMS) catalyst to degrade antibiotic amoxicillin (AMX). The reaction parameters such as CoFe2O4 dosage, AMX concentration, and initial pH value were also optimized. The reaction mechanism was proposed through free radical capture experiment and possible degradation pathway analysis. In addition, the magnetic recovery performance and stability of the catalyst were evaluated. Results showed that 85.5% of AMX could be removed within 90 min at optimal conditions. Sulfate radicals and hydroxyl radicals were the active species for AMX degradation. Moreover, the catalyst showed excellent magnetism and stability in the cycle experiment, which has great potential in the AOP treatment of antibiotic polluted wastewater.


Polymers ◽  
2019 ◽  
Vol 12 (1) ◽  
pp. 46
Author(s):  
Yuchao Wang ◽  
Ming Chen ◽  
Miaoyu Lan ◽  
Zhi Li ◽  
Shulai Lu ◽  
...  

A stabilizer called 2-tert-butyl-6-(3-tert-butyl-2-hydroxy-5-methylbenzyl)-4-methylphenyl acrylate (GM) was mixed in acrylonitrile butadiene styrene (ABS) with the same amount of 9-bis(octadecyloxy)-2,4,8,10-tetraoxa-3,9-diphosphaspiro[5.5]undecane (DSPDP), octadecyl-3-(3,5-di-tert-butyl-4-hydroxyphenyl) propionate (Irganox 1076) and tris(3,5-di-tert-butyl-4-hydroxybenzyl) isocyanurate (Irganox 3114) to investigate the influence of additives on the antiaging effect of ABS in oven aging or repeated extrusion aging. It was found that the ABS doped with the GM stabilizer showed a better yellowing resistance and thermal stability than the ABS doped with other antioxidants. Owing to the fact that the stabilizer can act on the free radicals before it has been peroxidized, it could trap the free radicals as a consequence of directly blocking the oxidation process of the active species, thus solving the problem of oxidative degradation of the materials from the source. This work provides guidance for improving thermal stability of ABS, indicating a promising potential for industrial application.


2013 ◽  
Vol 221 ◽  
pp. S204
Author(s):  
Susanne N. Kolle ◽  
Annette Mehling ◽  
Wera Teubner ◽  
Bennard van Ravenzwaay ◽  
Robert Landsiedel

1996 ◽  
Vol 446 ◽  
Author(s):  
K. Koh ◽  
H. Niimi ◽  
G. Lucovsky

AbstractThis paper presents experimental studies in which N-atoms have been incorporated at Si-SiO2 interfaces by forming the interface and oxide film by a 300°C remote plasma assisted nitridation/oxidation process using N2O. Process dynamics have been studied by on-line Auger electron spectroscopy (AES) by interrupted plasma processing. Plasma-activated species have been identified by in-situ mass spectrometry (MS) and optical emission spectroscopy (OES). Based on AES studies using N2O, O2 and sequenced N2O and O2 source gases, reaction pathways for N-atom incorporation i) at and/or ii) removal from buried Si-SiO2 interfaces have been identified, and contrasted with reaction pathways for nitridation using conventional furnace processing. The active species for N-atom incorporation is NO+, and for oxide growth, O2.


Author(s):  
R. R. Dils ◽  
P. S. Follansbee

Electric fields have been applied across oxides growing on a high temperature alloy and control of the oxidation of the material has been demonstrated. At present, three-fold increases in the oxidation rate have been measured in accelerating fields and the oxidation process has been completely stopped in a retarding field.The experiments have been conducted with an iron-base alloy, Pe 25Cr 5A1 0.1Y, although, in principle, any alloy capable of forming an adherent aluminum oxide layer during oxidation can be used. A specimen is polished and oxidized to produce a thin, uniform insulating layer on one surface. Three platinum electrodes are sputtered on the oxide surface and the specimen is reoxidized.


Author(s):  
L. P. Lemaire ◽  
D. E. Fornwalt ◽  
F. S. Pettit ◽  
B. H. Kear

Oxidation resistant alloys depend on the formation of a continuous layer of protective oxide scale during the oxidation process. The initial stages of oxidation of multi-component alloys can be quite complex, since numerous metal oxides can be formed. For oxidation resistance, the composition is adjusted so that selective oxidation occurs of that element whose oxide affords the most protection. Ideally, the protective oxide scale should be i) structurally perfect, so as to avoid short-circuit diffusion paths, and ii) strongly adherent to the alloy substrate, which minimizes spalling in response to thermal cycling. Small concentrations (∼ 0.1%) of certain reactive elements, such as yttrium, markedly improve the adherence of oxide scales in many alloy systems.


2019 ◽  
Vol 476 (21) ◽  
pp. 3141-3159 ◽  
Author(s):  
Meiru Si ◽  
Can Chen ◽  
Zengfan Wei ◽  
Zhijin Gong ◽  
GuiZhi Li ◽  
...  

Abstract MarR (multiple antibiotic resistance regulator) proteins are a family of transcriptional regulators that is prevalent in Corynebacterium glutamicum. Understanding the physiological and biochemical function of MarR homologs in C. glutamicum has focused on cysteine oxidation-based redox-sensing and substrate metabolism-involving regulators. In this study, we characterized the stress-related ligand-binding functions of the C. glutamicum MarR-type regulator CarR (C. glutamicum antibiotic-responding regulator). We demonstrate that CarR negatively regulates the expression of the carR (ncgl2886)–uspA (ncgl2887) operon and the adjacent, oppositely oriented gene ncgl2885, encoding the hypothetical deacylase DecE. We also show that CarR directly activates transcription of the ncgl2882–ncgl2884 operon, encoding the peptidoglycan synthesis operon (PSO) located upstream of carR in the opposite orientation. The addition of stress-associated ligands such as penicillin and streptomycin induced carR, uspA, decE, and PSO expression in vivo, as well as attenuated binding of CarR to operator DNA in vitro. Importantly, stress response-induced up-regulation of carR, uspA, and PSO gene expression correlated with cell resistance to β-lactam antibiotics and aromatic compounds. Six highly conserved residues in CarR were found to strongly influence its ligand binding and transcriptional regulatory properties. Collectively, the results indicate that the ligand binding of CarR induces its dissociation from the carR–uspA promoter to derepress carR and uspA transcription. Ligand-free CarR also activates PSO expression, which in turn contributes to C. glutamicum stress resistance. The outcomes indicate that the stress response mechanism of CarR in C. glutamicum occurs via ligand-induced conformational changes to the protein, not via cysteine oxidation-based thiol modifications.


2020 ◽  
Vol 10 (2) ◽  
pp. 103-111
Author(s):  
Andrey K. Babin ◽  
Andrew R. Dattel ◽  
Margaret F. Klemm

Abstract. Twin-engine propeller aircraft accidents occur due to mechanical reasons as well as human error, such as misidentifying a failed engine. This paper proposes a visual indicator as an alternative method to the dead leg–dead engine procedure to identify a failed engine. In total, 50 pilots without a multi-engine rating were randomly assigned to a traditional (dead leg–dead engine) or an alternative (visual indicator) group. Participants performed three takeoffs in a flight simulator with a simulated engine failure after rotation. Participants in the alternative group identified the failed engine faster than the traditional group. A visual indicator may improve pilot accuracy and performance during engine-out emergencies and is recommended as a possible alternative for twin-engine propeller aircraft.


1984 ◽  
Vol 23 (06) ◽  
pp. 277-282 ◽  
Author(s):  
A. Van Lingen ◽  
G. Westera ◽  
M. van ◽  
W. Den Hollander ◽  
E. E. Van der Wall ◽  
...  

SummaryThis paper presents an alternative method of demarcating regions of in terest over the myocardium after ad ministration of 123I-heptadecanoic acid to patients with coronary artery disea se. In a matrix of 32 × 32 pixels the elimination rates of the radioactivity, which are not corrected for back ground activity, are visualized per pixel in a functional image. The func tional image showed areas in the myocardium with high values of uncorrected elimination rates. These areas corresponded with the tracer defects on the scintigram. Corrected elimination rates obtained from re gions of interest of functional images were comparable with those of scinti grams. Thus based on functional im ages of uncorrected elimination rates a reliable, objective determination of regions of interest over normal and abnormal myocardium can be made.


Sign in / Sign up

Export Citation Format

Share Document