Role of ZnO and CeOx in Cu-Based Model Catalysts in Activation of H2O and CO2 Dynamics Studied by in Situ Ultraviolet–Visible and X-ray Photoelectron Spectroscopy

ACS Catalysis ◽  
2016 ◽  
Vol 6 (12) ◽  
pp. 7994-8003 ◽  
Author(s):  
Yibin Bu ◽  
C. J. Weststrate ◽  
J. W. Niemantsverdriet ◽  
Hans O. A. Fredriksson
1999 ◽  
Vol 567 ◽  
Author(s):  
Masayuki Suzuki ◽  
Yoji Saito

ABSTRACTWe tried direct oxynitridation of silicon surfaces by remote-plasma-exited nitrogen and oxygen gaseous mixtures at 700°C in a high vacuum. The oxynitrided surfaces were investigated with in-situ X-ray photoelectron spectroscopy. With increase of the oxynitridation time, the surface density of nitrogen gradually increases, but that of oxygen shows nearly saturation behavior after the rapid increase in the initial stage. We also annealed the grown oxynitride and oxide films to investigate the role of the contained nitrogen. The desorption rate of oxygen from the oxynitride films is much less than that from oxide films. We confirmed that nitrogen stabilizes the thermal stability of these oxynitride films.


1991 ◽  
Vol 238 ◽  
Author(s):  
S. M. Mukhopadhyay ◽  
C. S. Chen

ABSTRACTThe interfacial chemistry between Ni and Al2O3 has been studied during the initial stages of bonding. We have evaporated thin films of Ni on different alumina substrates (thin oxide film on metallic Al, polished and scratched sapphire crystals, surface with second phase precipitates) and have analyzed how the interface grows, in situ, using X-ray Photoelectron Spectroscopy. It was found that a certain fraction of the first monolayer of Ni which forms on the alumina surface undergoes charge transfer to form NiO. This is due to oxygen-active sites such as unattached oxygen bonds on the surface. A measure of the concentration of such sites can therefore be obtained from the submonolayer fraction of Ni that gets oxidized. It was found that a rough surface offered less oxidation sites for Ni than a smooth one whereas a surface with second phase MgAI2O4 (spinel) precipitates offered more oxidation sites. Also, there is much less oxidation on a thin film of amorphous alumina grown on metallic Al than on a polished bulk sapphire surface. The implications of these studies to further understanding of the metal-ceramic interface have been discussed.


2015 ◽  
Vol 119 (8) ◽  
pp. 4085-4094 ◽  
Author(s):  
Hans O. A. Fredriksson ◽  
Elin M. Larsson Langhammer ◽  
J. W. (Hans) Niemantsverdriet

2011 ◽  
Vol 1292 ◽  
Author(s):  
Yan Wu ◽  
Yiqiang Zhan ◽  
Mats Fahlman ◽  
Mei Fang ◽  
K. V. Rao ◽  
...  

ABSTRACTWe report on ‘in-situ’ solution processed homogeneous (200) oriented MgO ~85nm thin films deposited on Si substrates by inkjet printing. These films are found to show ferromagnetic order beyond room temperature with a saturation magnetization MS as high as ~0.63 emu/g. X-ray photoelectron spectroscopy investigations show the absence of any possible contamination effects, while the Mg 2p, and O 1s spectra indicate that the role of defect structure at the Mg site is important in the observed magnetism. By controlling the pH values of the precursors the concentration of the defects can be varied and hence tune the magnetization at room temperature. The origin of magnetism in these MgO thin films appears to arise from the cation vacancies.


2012 ◽  
Vol 181 (1) ◽  
pp. 20-25 ◽  
Author(s):  
K. Dumbuya ◽  
G. Cabailh ◽  
R. Lazzari ◽  
J. Jupille ◽  
L. Ringel ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document