scholarly journals Toward the Mechanistic Understanding of the Additives’ Role on Ammonium Nitrate Decomposition: Calcium Carbonate and Calcium Sulfate as Case Studies

ACS Omega ◽  
2020 ◽  
Vol 5 (10) ◽  
pp. 5034-5040
Author(s):  
Eleonora Menicacci ◽  
Patricia Rotureau ◽  
Guillaume Fayet ◽  
Carlo Adamo
1978 ◽  
Vol 90 (3) ◽  
pp. 509-516 ◽  
Author(s):  
A. Penny ◽  
F. V. Widdowson ◽  
J. F. Jenkyn

SummaryAn experiment at Saxmundham, Suffolk, during 1974–6, tested late sprays of a liquid N-fertilizer (ammonium nitrate/urea) supplying 50 kg N/ha, and a broad spectrum fungicide (benomyl and maneb with mancozeb) on winter wheat given, 0, 50, 100 or 150 kg N/ha as ‘Nitro-Chalk’ (ammonium nitrate/calcium carbonate) in springMildew (Erysiphe graminisf. sp. tritici) was most severe in 1974. It was increased by N and decreased by the fungicide in both 1974 and 1975, but was negligible in 1976. Septoria (S. nodorum) was very slight in 1974 and none was observed in 1976. It was much more severe in 1975, but was unaffected by the fungicide perhaps because this was applied too late.Yield and N content, number of ears and leaf area index were determined during summer on samples taken from all plots given 100 or 150 kg N/ha in spring; each was larger with 150 than with 100 kg N/ha. The effects of the liquid N-fertilizer on yield and N content varied, but leaf area index was consistently increased. None was affected consistently by the fungicide.Yields, percentages of N in, and amounts of N removed by grain and straw were greatly and consistently increased by each increment of ‘Nitro-Chalk’. Yields of grain were increased (average, 9%) by the liquid fertilizer in 1974 and 1975, and most where most ‘Nitro-Chalk’ had been given, but not in 1976 when the wheat ripened in July; however, both the percentage of N in and the amount of N removed by the grain were increased by the liquid fertilizer each year. The fungicide increased the response to the liquid N-fertilizer in 1974, but not in 1975 when Septoria was not controlled, nor in 1976 when leaf diseases were virtually absent.The weight of 1000 grains was increased by each increment of ‘Nitro-Chalk’ in 1975 but only by the first one (50 kg N/ha) in 1974 and 1976; it was very slightly increased by the liquid fertilizer and by fungicide each year.


2021 ◽  
pp. 350-350
Author(s):  
Guoyan Chen ◽  
Jianing Chen ◽  
Anchao Zhang ◽  
Haoxin Deng ◽  
Yanyang Mei ◽  
...  

Calcium-based sulfur-fixing agent, as the main sulfur-fixing product, is widely used in power plant boiler systems. In order to further study the thermodynamic properties and reaction characteristics of calcium-based sulfur fixing agent and its products, the method of combining power plant experiment with theory was used. The electronic structure, thermodynamic properties and density of states of quicklime, limestone, calcium sulfate and calcium sulphoaluminate have been calculated based on the first-principles ultra-soft pseudopotential plane wave method of density functional theory. The generalized gradient approximation algorithm isused to optimize the structure of various minerals to achieve the most stable state. The results show that the enthalpy, entropy, specific heat capacity at constant pressure and Gibbs free energy of calcium sulfonate vary greatly from 25K to 1000K, while the change of calcium oxide is small, and that of calcium carbonate and calcium sulfate are between them. It shows that calcium sulphoaluminate has strong stability and more energy is needed to destroy the molecular structure of calcium sulphoaluminate. Calcium oxide is the most unstable and requires less energy to react; Calcium carbonate and calcium sulfate are in between. The variation range of calcium sulfate is greater than that of calcium carbonate, indicating that the stability of calcium sulfate is higher than that of calcium carbonate. The experimental results show that the desulfurization efficiency of generating calcium sulphoaluminate is much higher than that of only generating calcium sulfate, indicating that calcium sulphoaluminate is very stable, which is consistent with the calculated results.


Author(s):  
M. Kh. Rumi ◽  
Sh. K. Irmatova ◽  
M. A. Zufarov ◽  
Sh. A. Fayziev ◽  
E. P. Mansurova ◽  
...  

The results of studies of the structure and composition of compositions based on red-burning kaolinite clay and calcium carbonate, heat-treated at 500oC, in the process of acid activation are presented. It is shown that when a 12 % solution of H2SO4is applied, leaching of iron and aluminum ions and the formation of calcium sulfate occur while maintaining the structure of kaolinite. The introduction of liquid glass into the composition of the material leads to the destruction of the structure of kaolinite, which contributes to an increase in the rate of extraction of aluminum ions during the subsequent acid activation. The components of the compositions with Ca2+and Fe3+in the presence of liquid glass are passivated by active amorphous silica formed during the reaction of liquid glass with CO2air.Ill. 2. Ref. 17. Tab. 1.


2020 ◽  
Vol 596 ◽  
pp. 117603 ◽  
Author(s):  
Omkar D. Supekar ◽  
Danielle J. Park ◽  
Alan R. Greenberg ◽  
Juliet T. Gopinath ◽  
Victor M. Bright

2015 ◽  
Vol 768 ◽  
pp. 350-362
Author(s):  
Bin Pei ◽  
Guang Zhan ◽  
Zhan Cheng Guo ◽  
Jin Tao Gao

Several physical and chemical detection methods were used to study the basic properties of sintering dust collected from Baogang Steel Corporation. The result shows that the major constituents of the electrostatic precipitator dust (ESP dust) were KCl, NaCl, Fe2O3 and Fe3O4. Water leaching experiment on the sintering dust had shown that the KCl in the ESP dust could be separated and recovered by water leaching and fractional crystallization. Component analysis of leaching solution showed that the massive calcium sulfate in the leaching solution should be removed first in order to obtain the pure potassium salt. In order to provide theoretical guidance to inhibit the dissolution of calcium ions from the sintering dust, the water leaching experiment of ESP dust and the dissolution behavior of CaSO4 in the potassium chloride, sodium chloride, potassium sulfate and their mixed salt solution were studied. Result showed that, a lower liquid-solid ratio should be chosen in the leaching process to inhibit the dissolution of calcium sulfate dehydrate. Using sodium carbonate solution as a precipitating agent, the influences of the concentration of sodium carbonate solution, reaction temperature, stirring speed on the preparation of the spherical calcium carbonate were studied. Spherical calcium carbonate with good dispersing performance and grain size distribution in nanometer range of less than 10μm was obtained. The production technology of potassium sulfate by double decomposition was sutdied, the results showed that over 80% and 12.76% of the recovery rate of potassium sulfate and potassium chloride ammonium compound fertilizer could be obtained. Furthermore, a potassium recovery process with joint production of spherical calcium carbonate and potassium sulfate was designed. This process is technically viable and considerable in economic benefit.


2014 ◽  
Vol 12 (1) ◽  
pp. 611-621 ◽  
Author(s):  
Jingcai Zhao ◽  
Xingfu Song ◽  
Ze Sun ◽  
Yanxia Xu ◽  
Jianguo Yu

Abstract Simulation on single factor effect was used for the design and optimization of the preparation of calcium carbonate from calcium sulfate (DH) and ammonium bicarbonate. This study shows that simulation on single factor effect is effective because the experimental results are close to predicted results. Furthermore, response surface method based on a central composite design was used to determine the range of parameters to achieve a highly efficient conversion of DH. The results indicate that the significant parameters that affected the conversion of DH were ratio of carbon to sulfur, temperature, concentration of ammonium bicarbonate, and stirring speed. The strength order of factors is as follows: ratio of carbon to sulfur > concentration of ammonium bicarbonate > stirring speed > temperature. A quadratic polynomial equation was established using multiple regression analysis. The optimum parameters were determined as follows: 2.10 for ratio of carbon to sulfur, 320.35 K for temperature, 337.31 rpm for the stirring speed, and 1.75 mol · L−1 for bicarbonate concentration. The corresponding conversion rate of the experimental result was 99.7%, which was highly consistent with the predicted value of 99.9%. Based on model and the optimum parameters, products of vaterite, with ammonium sulfate crystal of grade A, can be obtained. Equipotential lines of conversional rate and desired process conditions were provided as well.


2014 ◽  
Vol 472 ◽  
pp. 879-883
Author(s):  
Wei Yin

The feasible routine of carbon dioxide solidification is developed, which employs carbon dioxide with calcium sulfate and ammonia to obtain calcium carbonate and ammonium sulfate at ambient temperature. The process of carbon dioxide solidification is a spontaneous and exothermic reaction, whose possesses the rate constants of the second order reaction, which can be attributed to carbon dioxide gas dissolving the water media and carbon dioxide reacted with ammonia to produce ammonium bicarbonate. Calcium sulfate changing rapidly into calcium carbonate accelerates the process of reaction of carbon dioxide reacted with ammonia. The optimization process parameters of carbon dioxide solidification are a 0.075-MPa of CO2, a 0.5-mol of CaSO4·2H2O, a 0.5-mol of NH3·H2O and a 100-ml of H2O in a closed reactor, which is able to obtain 100% CO2 gas solidification efficiency within 4 minutes at ambient temperature.


Sign in / Sign up

Export Citation Format

Share Document