scholarly journals Effect of Fruit Maturity Stage on Some Physicochemical Properties of Jatropha Seed Oil and Derived Biodiesel

ACS Omega ◽  
2020 ◽  
Vol 5 (23) ◽  
pp. 13473-13481
Author(s):  
Mbako Jonas ◽  
Clever Ketlogetswe ◽  
Jerekias Gandure
Heliyon ◽  
2020 ◽  
Vol 6 (1) ◽  
pp. e03285 ◽  
Author(s):  
Mbako Jonas ◽  
Clever Ketlogetswe ◽  
Jerekias Gandure

2021 ◽  
Vol 12 (2) ◽  
pp. 141-143
Author(s):  
I.S. Ibrahim ◽  
I.T. Abdullahi ◽  
F.Y. Muhammad

Biodiesel is derived from triglycerides by transesterification reaction with alcohol (ethanol or methanol), and has classified as a renewable, biodegradable, and nontoxic fuel. Several methods for biodiesel production have been developed, among which transesterification using alkali-catalysis gives high levels of conversion of triglycerides to their corresponding methyl esters in short reaction times. This study was conducted to extract the neem and Jatropha oil for the production of biodiesel using alkali-catalyzed reaction The samples were subjected to reaction with sodium hydroxide (NaOH), 0.2:1 w/v methanol (MeOH) to oil mole ratio, reaction temperature of 6°C, and 30 min reaction time. The final biodiesel yield obtained was 47.5% and 45.5% from the neem and the jaropha oil sample respectively. The basic physicochemical properties of the jatropha methyl ester produced from both jatropha oil samples were found to be within the ASTM D6751 specified limits.


2010 ◽  
Vol 87 (6) ◽  
pp. 689-695 ◽  
Author(s):  
A. Emil ◽  
Zahira Yaakob ◽  
M. N. Satheesh Kumar ◽  
J. M. Jahim ◽  
J. Salimon

2021 ◽  
Vol 24 (12) ◽  
pp. 2005-2015
Author(s):  
Adane Legesse ◽  
Abate Habtamu ◽  
Tesfaye Tegene

The present study investigated the potential of Jatropha curcas L. seed oil and lye its ash for soapmaking. Oil was extracted from the seeds using Soxhlet extractor and n-hexane. Lye solution was obtained by boilingash of Jatropha with distilled water. The physicochemical properties (saponification value, Iodine value, acid valueand peroxide value) of the oil (and its blend with palm oil) were found to be consistent with reported values inliterature. The oil content and its relative density were also found to be 31.17% and 0.88g/cm3, respectively. Soapsamples were prepared by treating the oil and the prepared lye solution. Their physicochemical properties (moisturecontent, total alkali content, total fatty matter, pH, foam ability and cleansing ability) were found to be comparablewith reported properties for laundry soaps. The findings indicated that the lye solution from ash of Jatropha and itsseed oil result in soap materials that have acceptable qualities.


2019 ◽  
Author(s):  
Chem Int

Biodiesel produced by transesterification process from vegetable oils or animal fats is viewed as a promising renewable energy source. Now a day’s diminishing of petroleum reserves in the ground and increasing environmental pollution prevention and regulations have made searching for renewable oxygenated energy sources from biomasses. Biodiesel is non-toxic, renewable, biodegradable, environmentally benign, energy efficient and diesel substituent fuel used in diesel engine which contributes minimal amount of global warming gases such as CO, CO2, SO2, NOX, unburned hydrocarbons, and particulate matters. The chemical composition of the biodiesel was examined by help of GC-MS and five fatty acid methyl esters such as methyl palmitate, methyl stearate, methyl oleate, methyl linoleate and methyl linoleneate were identified. The variables that affect the amount of biodiesel such as methanol/oil molar ratio, mass weight of catalyst and temperature were studied. In addition to this the physicochemical properties of the biodiesel such as (density, kinematic viscosity, iodine value high heating value, flash point, acidic value, saponification value, carbon residue, peroxide value and ester content) were determined and its corresponding values were 87 Kg/m3, 5.63 Mm2/s, 39.56 g I/100g oil, 42.22 MJ/Kg, 132oC, 0.12 mgKOH/g, 209.72 mgKOH/g, 0.04%wt, 12.63 meq/kg, and 92.67 wt% respectively. The results of the present study showed that all physicochemical properties lie within the ASTM and EN biodiesel standards. Therefore, mango seed oil methyl ester could be used as an alternative to diesel engine.


Molecules ◽  
2020 ◽  
Vol 26 (1) ◽  
pp. 107
Author(s):  
Evelyn Reyes-Cueva ◽  
Juan Francisco Nicolalde ◽  
Javier Martínez-Gómez

Environmental problems have been associated with energy consumption and waste management. A solution is the development of renewable materials such as organic phase change materials. Characterization of new materials allows knowing their applications and simulations provide an idea of how they can developed. Consequently, this research is focused on the thermal and chemical characterization of five different avocado seed oils depending on the maturity stage of the seed: 100% unripe, 25% mature-75% unripe, 50% mature-50% unripe, 75% mature-25% unripe, and 100% mature. The characterization was performed by differential scanning calorimetry, Fourier transform infrared spectroscopy, and thermogravimetric analysis. The best oil for natural environments corresponded to 100% matured seed with an enthalpy of fusion of 52.93 J·g−1, and a degradation temperature between 241–545 °C. In addition, the FTIR analysis shows that unripe seed oil seems to contain more lipids than a mature one. Furthermore, a simulation with an isothermal box was conducted with the characterized oil with an initial temperature of −14 °C for the isothermal box, −27 °C for the PCM box, and an ambient temperature of 25 °C. The results show that without the PCM the temperature can reach −8 °C and with it is −12 °C after 7 h, proving its application as a cold thermal energy system.


2011 ◽  
Vol 233-235 ◽  
pp. 1210-1213 ◽  
Author(s):  
Shu Yu Liu ◽  
Hao Lu ◽  
Li Jie Sun ◽  
Xin Guo

Solvent extraction technique was applied for the extraction of β-Sitosterol from jatropha seed oil.The optimum conditions for the lab scale extraction were obtained at 30ml solvent, 0.05g magnesium power, ratio of hydrochloric acid to zinc chloride of 1/1.75 (ml/g) and tetrahydrofuran as a solvent. Under the optical conditions, the yield of β-sitosterol was up to 3.27mg/g.


Sign in / Sign up

Export Citation Format

Share Document