Changes in the Relationship Between the Variation in Spring Eurasian Snow and the Surface Temperature Over the Northern Hemisphere Around the Late 1980s

2021 ◽  
Vol 126 (4) ◽  
Author(s):  
XiaoJing Jia ◽  
Min Wang ◽  
QiFeng Qian ◽  
Renguang Wu
Keyword(s):  
Surface Temperature ◽  
Northern Hemisphere ◽  
Eurasian Snow ◽  
The Relationship

scholarly journals The covariation of Northern Hemisphere summertime CO<sub>2</sub> with surface temperature in boreal regions

2013 ◽  
Vol 13 (18) ◽  
pp. 9447-9459 ◽  
Author(s):  
D. Wunch ◽  
P. O. Wennberg ◽  
J. Messerschmidt ◽  
N. C. Parazoo ◽  
G. C. Toon ◽  
...  
Keyword(s):  
Greenhouse Gases ◽  
Surface Temperature ◽  
Interannual Variability ◽  
Northern Hemisphere ◽  
Seasonal Cycle ◽  
Atmospheric Transport ◽  
Exchange Model ◽  
Total Carbon ◽  
The Relationship

Abstract. We observe significant interannual variability in the strength of the seasonal cycle drawdown in northern midlatitudes from measurements of CO2 made by the Total Carbon Column Observing Network (TCCON) and the Greenhouse Gases Observing Satellite (GOSAT). This variability correlates with surface temperature in the boreal regions. Using TCCON measurements, we find that the slope of the relationship between the XCO2 seasonal cycle minima and boreal surface temperature is 1.2 ± 0.7 ppm K−1. Assimilations from CarbonTracker 2011 and CO2 simulations using the Simple Biosphere exchange Model (SiB) transported by GEOS-Chem underestimate this covariation. Both atmospheric transport and biospheric activity contribute to the observed covariation.

scholarly journals Modeling the Temperature Field in the Ground with an Installed Slinky-Coil Heat Exchanger

Energies ◽  
2021 ◽  
Vol 14 (13) ◽  
pp. 4010
Author(s):  
Monika Gwadera ◽  
Krzysztof Kupiec
Keyword(s):  
Temperature Field ◽  
Heat Exchanger ◽  
Surface Temperature ◽  
Ground Surface ◽  
Heat Sources ◽  
Ground Surface Temperature ◽  
Coil Heat Exchanger ◽  
The Relationship ◽  
Temperature Responses ◽  
Coil Heat

In order to find the temperature field in the ground with a heat exchanger, it is necessary to determine temperature responses of the ground caused by heat sources and the influence of the environment. To determine the latter, a new model of heat transfer in the ground under natural conditions was developed. The heat flux of the evaporation of moisture from the ground was described by the relationship taking into account the annual amount of rainfall. The analytical solution for the equations of this model is presented. Under the conditions for which the calculations were performed, the following data were obtained: the average ground surface temperature Tsm = 10.67 °C, the ground surface temperature amplitude As = 13.88 K, and the phase angle Ps = 0.202 rad. This method makes it possible to easily determine the undisturbed ground temperature at any depth and at any time. This solution was used to find the temperature field in the ground with an installed slinky-coil heat exchanger that consisted of 63 coils. The results of calculations according to the presented model were compared with the results of measurements from the literature. The 3D model for the ground with an installed heat exchanger enables the analysis of the influence of miscellaneous parameters of the process of extracting or supplying heat from/to the ground on its temperature field.

scholarly journals Coupled Thermomechanical Response Measurement of Deformation of Nickel-Based Superalloys Using Full-Field Digital Image Correlation and Infrared Thermography

Materials ◽  
2021 ◽  
Vol 14 (9) ◽  
pp. 2163
Author(s):  
Krzysztof Żaba ◽  
Tomasz Trzepieciński ◽  
Sandra Puchlerska ◽  
Piotr Noga ◽  
Maciej Balcerzak
Keyword(s):  
Surface Temperature ◽  
Strain Rate ◽  
Rolling Direction ◽  
Image Correlation ◽  
Uniaxial Tensile ◽  
Uniaxial Tensile Test ◽  
Response Measurement ◽  
Sheet Rolling ◽  
Inconel Alloys ◽  
The Relationship

The paper is devoted to highlighting the potential application of the quantitative imaging technique through results associated with work hardening, strain rate and heat generated during elastic and plastic deformation. The aim of the research presented in this article is to determine the relationship between deformation in the uniaxial tensile test of samples made of 1-mm-thick nickel-based superalloys and their change in temperature during deformation. The relationship between yield stress and the Taylor–Quinney coefficient and their change with the strain rate were determined. The research material was 1-mm-thick sheets of three grades of Inconel alloys: 625 HX and 718. The Aramis (GOM GmbH, a company of the ZEISS Group) measurement system and high-sensitivity infrared thermal imaging camera were used for the tests. The uniaxial tensile tests were carried out at three different strain rates. A clear tendency to increase the sample temperature with an increase in the strain rate was observed. This conclusion applies to all materials and directions of sample cutting investigated with respect to the sheet-rolling direction. An almost linear correlation was found between the percent strain and the value of the maximum surface temperature of the specimens. The method used is helpful in assessing the extent of homogeneity of the strain and the material effort during its deformation based on the measurement of the surface temperature.

Sign in / Sign up

Export Citation Format

Share Document