scholarly journals Probing subwavelength in-plane anisotropy with antenna-assisted infrared nano-spectroscopy

2021 ◽  
Vol 12 (1) ◽  
Author(s):  
Ziheng Yao ◽  
Xinzhong Chen ◽  
Lukas Wehmeier ◽  
Suheng Xu ◽  
Yinming Shao ◽  
...  

AbstractInfrared nano-spectroscopy based on scattering-type scanning near-field optical microscopy (s-SNOM) is commonly employed to probe the vibrational fingerprints of materials at the nanometer length scale. However, due to the elongated and axisymmetric tip shank, s-SNOM is less sensitive to the in-plane sample anisotropy in general. In this article, we report an easy-to-implement method to probe the in-plane dielectric responses of materials with the assistance of a metallic disk micro-antenna. As a proof-of-concept demonstration, we investigate here the in-plane phonon responses of two prototypical samples, i.e. in (100) sapphire and x-cut lithium niobate (LiNbO3). In particular, the sapphire in-plane vibrations between 350 cm−1 to 800 cm−1 that correspond to LO phonon modes along the crystal b- and c-axis are determined with a spatial resolution of < λ/10, without needing any fitting parameters. In LiNbO3, we identify the in-plane orientation of its optical axis via the phonon modes, demonstrating that our method can be applied without prior knowledge of the crystal orientation. Our method can be elegantly adapted to retrieve the in-plane anisotropic response of a broad range of materials, i.e. subwavelength microcrystals, van-der-Waals materials, or topological insulators.

2013 ◽  
Vol 5 (3) ◽  
pp. 301-308
Author(s):  
David Glay ◽  
Adelhatif El Fellahi ◽  
Tuami Lasri

In this paper, we present a non-resonant high impedance reflectometer with a reference impedance close to one of the tip probe of a near-field microwave microscope. We show that for an apex of the tip probe of 100 µm there is an optimum reference impedance close to 1 kΩ. To validate this approach a microwave circuit that makes use of lumped elements has been fabricated. A proof of concept is also explored for capacitance measurements between the tip probe and a metal plate.


2016 ◽  
Vol 18 (14) ◽  
pp. 9405-9411 ◽  
Author(s):  
C. Awada ◽  
J. Plathier ◽  
C. Dab ◽  
F. Charra ◽  
L. Douillard ◽  
...  

The need for a dedicated spectroscopic technique with nanoscale resolution to characterize SERS substrates pushed us to develop a proof of concept of a functionalized tip–surface enhanced Raman scattering (FTERS) technique.


Nanoscale ◽  
2019 ◽  
Vol 11 (30) ◽  
pp. 14113-14117 ◽  
Author(s):  
Mengfei Xue ◽  
Qi Zheng ◽  
Runkun Chen ◽  
Lihong Bao ◽  
Shixuan Du ◽  
...  

Near-field imaging of mid-infrared waveguide in SnSe2 slabs promotes two-dimensional van der Waals materials as building blocks for integrated MIR chips.


2019 ◽  
Vol 4 (1) ◽  
pp. 1593051 ◽  
Author(s):  
Jiahua Duan ◽  
Yafeng Li ◽  
Yixi Zhou ◽  
Yuan Cheng ◽  
Jianing Chen

2021 ◽  
Author(s):  
Daniel Grasseschi ◽  
Dario Bahamon ◽  
Francisco Maia ◽  
Ingrid Barcelos ◽  
Raul Freitas ◽  
...  

Nanophotonics ◽  
2020 ◽  
Vol 9 (10) ◽  
pp. 3473-3481 ◽  
Author(s):  
Shiqing Li ◽  
Zhuo Wang ◽  
Shaohua Dong ◽  
Sixiong Yi ◽  
Fuxin Guan ◽  
...  

AbstractAlthough many approaches have been proposed to manipulate propagating waves (PWs) and surface waves (SWs), usually each operation needs a separate meta-device, being unfavorable for optical integrations. Here, we propose a scheme to design a single meta-device that can efficiently generate SWs and/or PWs with pre-designed wavefronts, under the excitations of circularly polarized (CP) PWs with different helicity. As a proof of concept, we design and fabricate a microwave meta-device and experimentally demonstrate that it can convert incident CP waves of opposite helicity to SWs possessing different wavefronts and traveling to opposite directions, both exhibiting very high efficiencies. We further generalize our scheme to design a meta-device and numerically demonstrate that it can either excite a SW beam with tailored wavefront or generate a far-field PW with pre-designed wavefront, as shined by CP waves with different helicity. Our work opens the door to achieving simultaneous controls on far- and near-field electromagnetic environments based on a single ultra-compact platform.


2020 ◽  
Vol 11 (1) ◽  
Author(s):  
Zhigao Dai ◽  
Guangwei Hu ◽  
Guangyuan Si ◽  
Qingdong Ou ◽  
Qing Zhang ◽  
...  

AbstractHighly confined and low-loss polaritons are known to propagate isotropically over graphene and hexagonal boron nitride in the plane, leaving limited degrees of freedom in manipulating light at the nanoscale. The emerging family of biaxial van der Waals materials, such as α-MoO3 and V2O5, support exotic polariton propagation, as their auxiliary optical axis is in the plane. Here, exploiting this strong in-plane anisotropy, we report edge-tailored hyperbolic polaritons in patterned α-MoO3 nanocavities via real-space nanoimaging. We find that the angle between the edge orientation and the crystallographic direction significantly affects the optical response, and can serve as a key tuning parameter in tailoring the polaritonic patterns. By shaping α-MoO3 nanocavities with different geometries, we observe edge-oriented and steerable hyperbolic polaritons as well as forbidden zones where the polaritons detour. The lifetime and figure of merit of the hyperbolic polaritons can be regulated by the edge aspect ratio of nanocavity.


2012 ◽  
Vol 2012 ◽  
pp. 1-11 ◽  
Author(s):  
Victor V. Kotlyar ◽  
Sergey S. Stafeev ◽  
Roman V. Skidanov ◽  
Victor A. Soifer

We study binary axicons of period 4, 6, and 8 μm fabricated by photolithography with a 1 μm resolution, 500 nm depth, and 4 mm diameter. Near-field diffraction focal spots varying in diameter from 3.5λ to 4.5λ (for the axicon of period T=4 μm) and from 5λ to 8λ (for the axicon with T=8 μm) are experimentally found on the optical axis at a distance of up to 40 μm from the axicon for the wavelength λ=0.532 μm. The first focal spot is found at distance 2 μm (T=4 μm), with the period of the focal spots being 2 μm (T=4 μm) and 4 μm (T=8 μm). Diffraction of linearly polarized plane and diverging waves is simulated using FullWAVE (RSoft) and a proprietary program BOR-FDTD, which implement finite-difference schemes to solve three-dimensional Maxwell's equations in the Cartesian and cylindrical coordinates. The numerically simulated values for diameters of the near-field focal spots for the axicon of period T=4 μm are in good agreement with the experimental values.


ACS Photonics ◽  
2018 ◽  
Vol 5 (4) ◽  
pp. 1196-1201 ◽  
Author(s):  
Daniel Wintz ◽  
Kundan Chaudhary ◽  
Ke Wang ◽  
Luis A. Jauregui ◽  
Antonio Ambrosio ◽  
...  

2003 ◽  
Vol 67 (1) ◽  
Author(s):  
J.-H. Chung ◽  
T. Egami ◽  
R. J. McQueeney ◽  
M. Yethiraj ◽  
M. Arai ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document