Biocompatible polymer brushes grown from model quartz fibres: synthesis, characterisation and in situ determination of frictional coefficient

Soft Matter ◽  
2010 ◽  
Vol 6 (7) ◽  
pp. 1571 ◽  
Author(s):  
A. J. Morse ◽  
S. Edmondson ◽  
D. Dupin ◽  
S. P. Armes ◽  
Z. Zhang ◽  
...  
Keyword(s):  
Polymer Brushes ◽  
Frictional Coefficient ◽  
Biocompatible Polymer

INDIREKTE PAPIERCHROMATOGRAPHISCHE METHODE ZUR BESTIMMUNG DER HARNOESTROGENE

1961 ◽  
Vol 38 (4) ◽  
pp. 545-562 ◽  
Author(s):  
L. Kecskés ◽  
F. Mutschler ◽  
I. Glós ◽  
E. Thán ◽  
I. Farkas ◽  
...  
Keyword(s):  
Pregnant Women ◽  
Granulosa Cell ◽  
Iron Content ◽  
List Type ◽  
Granulosa Cell Tumour ◽  
Hydrolysis Of ◽  
Phenol Fraction ◽  
Qualitative Determination

ABSTRACT 1. An indirect paperchromatographic method is described for separating urinary oestrogens; this consists of the following steps: acidic hydrolysis, extraction with ether, dissociation of phenol-fractions with partition between the solvents. Previous purification of phenol fraction with the aid of paperchromatography. The elution of oestrogen containing fractions is followed by acetylation. Oestrogen acetate is isolated by re-chromatography. The chromatogram was developed after hydrolysis of the oestrogens 'in situ' on the paper. The quantity of oestrogens was determined indirectly, by means of an iron-reaction, after the elution of the iron content of the oestrogen spot, which was developed by the Jellinek-reaction. 2. The method described above is satisfactory for determining urinary oestrogen, 17β-oestradiol and oestriol, but could include 16-epioestriol and other oestrogenic metabolites. 3. The sensitivity of the method is 1.3–1.6 μg/24 hours. 4. The quantitative and qualitative determination of urinary oestrogens with the above mentioned method was performed in 50 pregnant and 9 non pregnant women, and also in 2 patients with granulosa cell tumour.

Single Crystal Growth of High-Pressure Phases of Ice and Salt Hydrate Far Below the Original Melting Point by Mixing Alcohol: Crystal Structure Determination of Magnesium Chloride Heptahydrate

2020 ◽  
Author(s):  
Keishiro Yamashita ◽  
Kazuki Komatsu ◽  
Hiroyuki Kagi
Keyword(s):  
Crystal Structure ◽  
High Pressure ◽  
Crystal Growth ◽  
Single Crystal ◽  
Room Temperature ◽  
Growth Technique ◽  
Salt Hydrate ◽  
X Ray

An crystal-growth technique for single crystal x-ray structure analysis of high-pressure forms of hydrogen-bonded crystals is proposed. We used alcohol mixture (methanol: ethanol = 4:1 in volumetric ratio), which is a widely used pressure transmitting medium, inhibiting the nucleation and growth of unwanted crystals. In this paper, two kinds of single crystals which have not been obtained using a conventional experimental technique were obtained using this technique: ice VI at 1.99 GPa and MgCl<sub>2</sub>·7H<sub>2</sub>O at 2.50 GPa at room temperature. Here we first report the crystal structure of MgCl2·7H2O. This technique simultaneously meets the requirement of hydrostaticity for high-pressure experiments and has feasibility for further in-situ measurements.

A Mechanical Loading/Synchrotron X-Ray Diffraction System for In-Situ Determination of Lattice Strains

2005 ◽  
Author(s):  
Matthew Miller ◽  
Paul Dawson
Keyword(s):  
Mechanical Loading ◽  
X Ray Diffraction ◽  
X Ray ◽  
Lattice Strains

Determination of Internal Stresses During Pearlite Transformation of 0.8c–1.5Mn Steel Through In-Situ Neutron Diffraction

2020 ◽  
Author(s):  
Satoshi Morooka ◽  
Nobuo Nakada ◽  
Yuhki Tsukada ◽  
Wu Gong ◽  
Takuro Kawasaki ◽  
...  
Keyword(s):  
Neutron Diffraction ◽  
Internal Stresses

Simple, Direct and Simultaneous Stripping Voltammetric Determination of Lead and Copper in Gasoline Using an In Situ Mercury Film Electrode

2013 ◽  
Vol 10 (4) ◽  
pp. 498-504 ◽  
Author(s):  
Lorena Martiniano ◽  
Joseany Almeida ◽  
Glene Cavalcante ◽  
Edmar Marques ◽  
Teresa Fonseca ◽  
...  
Keyword(s):  
Voltammetric Determination ◽  
Film Electrode ◽  
Mercury Film Electrode ◽  
Mercury Film

scholarly journals 7Au@SnO2-vertical graphene-based microneedle sensor for in-situ determination of abscisic acid in plants

2021 ◽  
pp. 112237
Author(s):  
ZhengWang ◽  
Lifang Xue ◽  
Mingji Li ◽  
Cuiping Li ◽  
Penghai Li ◽  
...  
Keyword(s):  
Abscisic Acid

scholarly journals In Situ exploration of the giant planets

2021 ◽  
Author(s):  
O. Mousis ◽  
D. H. Atkinson ◽  
R. Ambrosi ◽  
S. Atreya ◽  
D. Banfield ◽  
...  
Keyword(s):  
Solar System ◽  
Giant Planets ◽  
Atmospheric Composition ◽  
Formation History ◽  
History Of ◽  
Composition Structure ◽  
Galileo Probe ◽  
Probe Measurements

AbstractRemote sensing observations suffer significant limitations when used to study the bulk atmospheric composition of the giant planets of our Solar System. This impacts our knowledge of the formation of these planets and the physics of their atmospheres. A remarkable example of the superiority of in situ probe measurements was illustrated by the exploration of Jupiter, where key measurements such as the determination of the noble gases’ abundances and the precise measurement of the helium mixing ratio were only made available through in situ measurements by the Galileo probe. Here we describe the main scientific goals to be addressed by the future in situ exploration of Saturn, Uranus, and Neptune, placing the Galileo probe exploration of Jupiter in a broader context. An atmospheric entry probe targeting the 10-bar level would yield insight into two broad themes: i) the formation history of the giant planets and that of the Solar System, and ii) the processes at play in planetary atmospheres. The probe would descend under parachute to measure composition, structure, and dynamics, with data returned to Earth using a Carrier Relay Spacecraft as a relay station. An atmospheric probe could represent a significant ESA contribution to a future NASA New Frontiers or flagship mission to be launched toward Saturn, Uranus, and/or Neptune.

Sign in / Sign up

Export Citation Format

Share Document