Designing soft pyroelectric and electrocaloric materials using electrets

Soft Matter ◽  
2019 ◽  
Vol 15 (2) ◽  
pp. 262-277 ◽  
Author(s):  
Faezeh Darbaniyan ◽  
Kaushik Dayal ◽  
Liping Liu ◽  
Pradeep Sharma
Keyword(s):  
Temperature Variation ◽  
Pyroelectric Material

A temperature variation can electrically polarize a pyroelectric material.

Simulation of the internal temperature in the Passol Laboratory, University of Debrecen

2012 ◽  
Vol 3 (1) ◽  
pp. 63-73 ◽  
Author(s):  
I. Csáky ◽  
F. Kalmár
Keyword(s):  
Temperature Variation ◽  
Air Temperature ◽  
Indoor Air ◽  
Storage Capacity ◽  
Building Structures ◽  
Internal Temperature ◽  
The One ◽  
Heavy Structure ◽  
East West ◽  
Made In

Abstract Nowadays the facades of newly built buildings have significant glazed surfaces. The solar gains in these buildings can produce discomfort caused by direct solar radiation on the one hand and by the higher indoor air temperature on the other hand. The amplitude of the indoor air temperature variation depends on the glazed area, orientation of the facade and heat storage capacity of the building. This paper presents the results of a simulation, which were made in the Passol Laboratory of University of Debrecen in order to define the internal temperature variation. The simulation proved that the highest amplitudes of the internal temperature are obtained for East orientation of the facade. The upper acceptable limit of the internal air temperature is exceeded for each analyzed orientation: North, South, East, West. Comparing different building structures, according to the obtained results, in case of the heavy structure more cooling hours are obtained, but the energy consumption for cooling is lower.

THE EFFECT OF TEMPERATURE VARIATION ON RESISTANCE VALUE IN ELECTRICITY CIRCUITS

2020 ◽  
Vol 4 (1) ◽  
pp. 27
Author(s):  
Ridwan Yusuf Lubis ◽  
Lailatul Husna Lubis ◽  
Miftahul Husnah
Keyword(s):  
Temperature Variation ◽  
Effect Of Temperature ◽  
Resistance Value

Analisis Variasi Temperatur Aktivasi Terhadap Daya Serap Arang Aktif Tandan Aren (Arenga Pinnata Merr) Dengan Agen Aktivasi Potassium Silicate(K2SiO3)

2020 ◽  
Vol 5 (3) ◽  
pp. 221
Author(s):  
Muhammad Azam ◽  
Muhammad Anas ◽  
Erniwati Erniwati
Keyword(s):  
Methylene Blue ◽  
Activated Carbon ◽  
Adsorption Capacity ◽  
Temperature Variation ◽  
Chemical Activation ◽  
Weight Ratio ◽  
Potassium Silicate ◽  
Physical Activation ◽  
Activation Temperature ◽  
Pyrolysis Reactor

This study aims to determine the effect of variation of activation temperature of activated carbon from sugar palm bunches of chemically activatied with the activation agent of potassium silicate (K2SiO3) on the adsorption capacity of iodine and methylene blue. Activated carbon from bunches of sugar palmacquired in four steps: preparationsteps, carbonizationstepsusing the pyrolysis reactor with temperature of 300 oC - 400 oC for 8 hours and chemical activation using of potassium silicate (K2SiO3) activator in weight ratio of 2: 1 and physical activation using the electric furnace for 30 minutes with temperature variation of600 oC, 650 oC, 700 oC, 750 oC and 800 oC. The iodine and methyleneblue adsorption testedby Titrimetric method and Spectrophotometry methodrespectively. The results of the adsorption of iodine and methylene blue activated carbon from sugar palm bunches increased from 240.55 mg/g and 63.14 mg/g at a temperature of 600 oC to achieve the highest adsorption capacity of 325.80 mg/g and 73.59 mg/g at temperature of 700 oC and decreased by 257.54 mg/g and 52.03 mg/g at a temperature of 800 oCrespectively.However, it does not meet to Indonesia standard (Standard Nasional Indonesia/SNI), which is 750 mg/g and 120 mg/g respectively.

Sign in / Sign up

Export Citation Format

Share Document