Balancing the electrical conductivity and Seebeck coefficient by controlled interfacial doping towards high performance benzothienobenzothiophene-based organic thermoelectric materials

2019 ◽  
Vol 7 (43) ◽  
pp. 24982-24991 ◽  
Author(s):  
Jingjuan Tan ◽  
Zhanhua Chen ◽  
Dagang Wang ◽  
Shihui Qin ◽  
Xu Xiao ◽  
...  
Keyword(s):  
Electrical Conductivity ◽  
Seebeck Coefficient ◽  
Thermoelectric Materials ◽  
High Performance ◽  
Organic Thermoelectric Materials

A generally applicable strategy of balancing the electrical conductivity and Seebeck coefficient for high-performance organic thermoelectric composites by controlled interfacial doping.

scholarly journals Electronic and Thermoelectric Properties of V2O5, MgV2O5, and CaV2O5

Coatings ◽  
2020 ◽  
Vol 10 (5) ◽  
pp. 453 ◽  
Author(s):  
Xiaofei Sheng ◽  
Zhuhong Li ◽  
Yajuan Cheng
Keyword(s):  
Electrical Conductivity ◽  
Seebeck Coefficient ◽  
Thermoelectric Properties ◽  
Thermoelectric Materials ◽  
High Performance ◽  
Van Der Waals ◽  
Thermoelectric Performance ◽  
Extreme Condition ◽  
Electronic Band ◽  
Classical Transport

Developing new thermoelectric materials with high performance can broaden the thermoelectric family and is the key to fulfill extreme condition applications. In this work, we proposed two new high-temperature thermoelectric materials—MgV2O5 and CaV2O5—which are derived from the interface engineered V2O5. The electronic and thermoelectric properties of V2O5, MgV2O5, and CaV2O5 were calculated based on first principles and Boltzmann semi-classical transport equations. It was found that although V2O5 possessed a large Seebeck coefficient, its large band gap strongly limited the electrical conductivity, hence hindering it from being good thermoelectric material. With the intercalation of Mg and Ca atoms into the van der Waals interfaces of V2O5, i.e., forming MgV2O5 and CaV2O5, the electronic band gaps could be dramatically reduced down to below 0.1 eV, which is beneficial for electrical conductivity. In MgV2O5 and CaV2O5, the Seebeck coefficient was not largely affected compared to V2O5. Consequently, the thermoelectric figure of merit was expected to be improved noticeably. Moreover, the intercalation of Mg and Ca atoms into the V2O5 van der Waals interfaces enhanced the anisotropic transport and thus provided a possible way for further engineering of their thermoelectric performance by nanostructuring. Our work provided theoretical guidelines for the improvement of thermoelectric performance in layered oxide materials.

Investigation of Thermoelectric Materials: Substitution effect of Bi on the Ag1-xPb18MTe20 (M = Sb, Bi) (x = 0, 0.14, 0.3)

2007 ◽  
Vol 1044 ◽  
Author(s):  
Mi-kyung Han ◽  
Huijun Kong ◽  
Ctirad Uher ◽  
Mercouri G Kanatzidis
Keyword(s):  
Thermal Conductivity ◽  
Electrical Conductivity ◽  
Seebeck Coefficient ◽  
Thermoelectric Materials ◽  
Figure Of Merit ◽  
Lattice Thermal Conductivity ◽  
Substitution Effect ◽  
Dimensionless Figure Of Merit ◽  
The Matrix ◽  
Mass Fluctuation

AbstractWe performed comparative investigations of the Ag1-xPb18MTe20 (M = Bi, Sb) (x = 0, 0.14, 0.3) system to better understand the roles of Sb and Bi on the thermoelectric properties. In both systems, the electrical conductivity nearly keeps the same values, while the Seebeck coefficient decreases dramatically in going from Sb to Bi. Compared to the lattice thermal conductivity of PbTe, that of AgPb18BiTe20 is substantially reduced. The lattice thermal conductivity of the Bi analog, however, is higher than that of AgPb18SbTe20 and this is attributed largely to the decrease in the degree of mass fluctuation between the nanostructures and the matrix (for the Bi analog). As a result the dimensionless figure of merit ZT of Ag1-xPb18MTe20 (M = Bi) is found to be smaller than that of Ag1-xPb18MTe20 (M = Sb).

Thermoelectric Performance of Glass Microsphere Dispersed Bi-Sb Composites at Low Temperature

2013 ◽  
Vol 743-744 ◽  
pp. 120-125
Author(s):  
Zhen Chen ◽  
Ye Mao Han ◽  
Min Zhou ◽  
Rong Jin Huang ◽  
Yuan Zhou ◽  
...  
Keyword(s):  
Thermal Conductivity ◽  
Electrical Conductivity ◽  
Seebeck Coefficient ◽  
Thermoelectric Materials ◽  
Sem Analysis ◽  
Glass Microsphere ◽  
Thermoelectric Performance ◽  
X Ray Diffraction ◽  
X Ray ◽  
Measurement Results

In the present study, the glass microsphere dispersed Bi-Sb thermoelectric materials have been fabricated through mechanical alloying followed by pressureless sintering. The phase composition and the microstructure were investigated by X-ray diffraction (XRD) and scanning electron microscopy (SEM) analysis. Electrical conductivity, Seebeck coefficient and thermal conductivity were measured in the temperature range of 77~300 K. The ZT values were calculated according to the measurement results. The results showed that the electrical conductivity, Seebeck coefficient and thermal conductivity decreased by adding glass microsphere into Bi-Sb thermoelectric materials. However, the optimum ZT value of 0.24 was obtained at 260 K, which was increased 10% than that of the Bi-Sb matrix. So it is confirmed that the thermoelectric performance of Bi-Sb-based materials can be improved by adding moderate glass microspheres.

Thermoelectric properties of polycrystalline Bi2Se3−x by powder compaction sintering

2020 ◽  
Vol 34 (18) ◽  
pp. 2050206
Author(s):  
Ying Zhou ◽  
Zhenhua Ge ◽  
Jun Guo ◽  
Jing Feng
Keyword(s):  
Electrical Conductivity ◽  
Seebeck Coefficient ◽  
Carrier Concentration ◽  
Thermoelectric Properties ◽  
Thermoelectric Materials ◽  
Electrical Transport ◽  
Bulk Material ◽  
Powder Compaction ◽  
Electrical Transport Properties ◽  
X Ray

[Formula: see text] is a [Formula: see text] compound (where Pn = Bi and Sb, Ch = Te, Se, and S), which has attracted increasing attention as a candidate for use in thermoelectric applications. Previous studies demonstrated the advantage of [Formula: see text] thermoelectric materials, despite an inferior thermoelectric performance. Herein, a series of [Formula: see text] ([Formula: see text], 0.10, 0.15, 0.20, and 0.25) thermoelectric materials were prepared by powder compaction sintering. The effects of phase structures and microstructure of the [Formula: see text] bulk material were analyzed by X-ray diffraction, scanning electron microscopy, and energy-dispersive X-ray spectroscopy. The thermoelectric properties, including Seebeck coefficient, electrical conductivity, and thermal conductivity, were measured systematically. The results show that carrier concentration increased with decreasing Se content, which in turn affected the electrical transport properties. Low Se contents gave larger power factor (PF) values than the pristine [Formula: see text] sample, the maximum PF value being [Formula: see text] at 320 K for [Formula: see text]. The variation in PF was attributed to the variations in electrical conductivity [Formula: see text] and Seebeck coefficient [Formula: see text] upon optimizing Se content. The [Formula: see text] samples showed an enhanced thermoelectric figure of merit (ZT) with increasing measurement temperature, due to the increased [Formula: see text] value, [Formula: see text], and decreased [Formula: see text]. The [Formula: see text] sample exhibited the highest ZT (0.28) at 575 K, while [Formula: see text] exhibited the lowest ZT (0.14) at 325 K. This indicated that tuning Se content was an effective way to enhance carrier concentration.

Thermoelectric Generators of Sequentially Deposited Si/Si+Ge Nano-layered Superlattices

2009 ◽  
Vol 1181 ◽  
Author(s):  
Cydale Smith ◽  
Marcus Pugh ◽  
Hervie Martin ◽  
Rufus Durel Hill ◽  
Brittany James ◽  
...  
Keyword(s):  
Thermal Conductivity ◽  
Electrical Conductivity ◽  
Seebeck Coefficient ◽  
Thermoelectric Materials ◽  
Figure Of Merit ◽  
Rutherford Backscattering Spectrometry ◽  
Ion Beam ◽  
Absolute Temperature ◽  
Simulation Software ◽  
The Cross

AbstractEffective thermoelectric materials have a low thermal conductivity and a high electrical conductivity. The performance of the thermoelectric materials and devices is shown by a dimensionless figure of merit, ZT = S2sσ/ KTC, σ is the electrical conductivity T/KTC, where S is the Seebeck coefficient, T is the absolute temperature and KTC is the thermal conductivity. In this study we have prepared the thermoelectric generator device of Si/Si+Ge multi-layer superlattice films using the ion beam assisted deposition (IBAD). To determine the stoichiometry of the elements of Si and Ge in the grown multilayer films and the thickness of the grown multi-layer films Rutherford Backscattering Spectrometry (RBS) and RUMP simulation software package were used. The 5 MeV Si ion bombardments were performed to make quantum clusters in the multi-layer superlattice thin films to decrease the cross plane thermal conductivity, increase the cross plane Seebeck coefficient and cross plane electrical conductivity.Keywords: Ion bombardment, thermoelectric properties, multi-nanolayers, Figure of merit.

scholarly journals Efficient interlayer charge release for high-performance layered thermoelectrics

2020 ◽  
Author(s):  
Hao Zhu ◽  
Zhou Li ◽  
Chenxi Zhao ◽  
Xingxing Li ◽  
Jinlong Yang ◽  
...  
Keyword(s):  
Thermal Conductivity ◽  
Electrical Conductivity ◽  
Seebeck Coefficient ◽  
Carrier Concentration ◽  
High Performance ◽  
Lattice Thermal Conductivity ◽  
Transport Barrier ◽  
High Seebeck Coefficient ◽  
Valence Bands ◽  
Increase Carrier Concentration

Abstract Many layered superlattice materials intrinsically possess large Seebeck coefficient and low lattice thermal conductivity, but poor electrical conductivity because of the interlayer transport barrier for charges, which has become a stumbling block for achieving high thermoelectric performance. Herein, taking BiCuSeO superlattice as an example, it is demonstrated that efficient interlayer charge release can increase carrier concentration, thereby activating multiple Fermi pockets through Bi/Cu dual vacancies and Pb codoping. Experimental results reveal that the extrinsic charges, which are introduced by Pb and initially trapped in the charge-reservoir [Bi2O2]2+ sublayers, are effectively released into [Cu2Se2]2− sublayers via the channels bridged by Bi/Cu dual vacancies. This efficient interlayer charge release endows dual-vacancy- and Pb-codoped BiCuSeO with increased carrier concentration and electrical conductivity. Moreover, with increasing carrier concentration, the Fermi level is pushed down, activating multiple converged valence bands, which helps to maintain a relatively high Seebeck coefficient and yield an enhanced power factor. As a result, a high ZT value of ∼1.4 is achieved at 823 K in codoped Bi0.90Pb0.06Cu0.96SeO, which is superior to that of pristine BiCuSeO and solely doped samples. The present findings provide prospective insights into the exploration of high-performance thermoelectric materials and the underlying transport physics.

Ensemble-machine-learning-based correlation analysis of internal and band characteristics of thermoelectric materials

2020 ◽  
Vol 8 (37) ◽  
pp. 13079-13089
Author(s):  
Lihao Chen ◽  
Ben Xu ◽  
Jia Chen ◽  
Ke Bi ◽  
Changjiao Li ◽  
...  
Keyword(s):  
Machine Learning ◽  
Electrical Conductivity ◽  
Correlation Analysis ◽  
Seebeck Coefficient ◽  
Thermoelectric Properties ◽  
Thermoelectric Materials ◽  
Ensemble Machine Learning ◽  
Properties Of Materials

Machine learning can significantly help to predict the thermoelectric properties of materials, such as the Seebeck coefficient and electrical conductivity.

Preparation of bulk AgNWs/PEDOT:PSS composites: a new model towards high-performance bulk organic thermoelectric materials

RSC Advances ◽  
2015 ◽  
Vol 5 (56) ◽  
pp. 45106-45112 ◽  
Author(s):  
Yuan Liu ◽  
Zijun Song ◽  
Qihao Zhang ◽  
Zhenxing Zhou ◽  
Yijing Tang ◽  
...  
Keyword(s):  
Thermoelectric Materials ◽  
High Performance ◽  
New Model ◽  
Organic Thermoelectric Materials

A facile and effective approach is demonstrated to prepare high-performance bulk AgNWs/PEDOT:PSS thermoelectric composites.

Sign in / Sign up

Export Citation Format

Share Document